Decoders Readme Additons - Incomplete

for AMD your going to have to do a few things because GPU decoding is significantly different

View > Options > Internal Filters
under "Internal LAV Filters settings" click "Video decoder"
This should bring up the "Properties"/"Video Settings" window for the video decoder
under "Harder Acceleration" change "Hardware Decoder to use:" to "DXVA2 (copy-back)
then under "Software Deinterlacing (YADIF)" check the box for "Enable YADIF Deinterlacing"
leave the "Output Mode" at "50p/60p (Video)" unless you know for sure your monitor supports a 25hz/30hz
click the "Ok" button in the "Properties" window
click the "Ok" button in the "Options" window
close and then reopen mpc-hc for the setting to take effect








yes I am. i assume the amd settings worked?

you still have a bit more to config and its all in relation to madVR but I havnt written that yet. I i would you I would just open it up and poke around there should be enough stuff in there taht you should be able to figure out or at least try some stuff.

to edit madvr settings
open a video and pause it
right click the video and click Filters > madVR
Click edit settings
***the below steps are from the original readme slightly modified and continue from where I left off. This is just a starting point as there are far more options now then when I originally wrote this. I may find a way for at least the default settings to have a config file.***

click and expand devices then click your device
set the device type
expand your device and set the display mode		*if you  dont know what display mode you should set contact me
click and expand processing
turn of all decoding and deinterlacing
click and expand scaling algorithems
click chroma upscaling and set it to Catmull-Rom
click luma upscaling and set it to Catmull-Rom and check scale in linear light
click luma downscaling and set it to Catmull-Rom and check scale in linear light
click and expand rendering and click general setings
check disable desktop composition and uncheck only in fullscreen
hit apply the ok at the bottom then ok and the window that is still on screen
	*if you have problems with preformance its probably because you dont have a powerful enough GPU contact me for help adjusting or try disabling madVR