# Buzzer Controller rev_03

/********* Pleasedontcode.com **********

    Pleasedontcode thanks you for automatic code generation! Enjoy your code!

    - Terms and Conditions:
    You have a non-exclusive, revocable, worldwide, royalty-free license
    for personal and commercial use. Attribution is optional; modifications
    are allowed, but you're responsible for code maintenance. We're not
    liable for any loss or damage. For full terms,
    please visit pleasedontcode.com/termsandconditions.

    - Project: # Buzzer Controller
    - Version: 003
    - Source Code NOT compiled for: Arduino Uno
    - Source Code created on: 2026-03-07 20:45:19

********* Pleasedontcode.com **********/

/****** SYSTEM REQUIREMENTS *****/
/****** SYSTEM REQUIREMENT 1 *****/
    /* Buzzer op pin 8 maakt continu geluid door het */
    /* signaal aan te zetten */
/****** END SYSTEM REQUIREMENTS *****/


/* START CODE */

/****** DEFINITION OF LIBRARIES *****/
#include <SoftwareSerial.h>

/****** FUNCTION PROTOTYPES *****/
void setup(void);
void loop(void);

/***** DEFINITION OF Software Serial *****/
const uint8_t Buzzer_DFPlayerMini_Serial_PIN_SERIAL_TX_A0 = A0;
const uint8_t Buzzer_DFPlayerMini_Serial_PIN_SERIAL_RX_A1 = A1;
SoftwareSerial Buzzer_DFPlayerMini_Serial(Buzzer_DFPlayerMini_Serial_PIN_SERIAL_RX_A1, Buzzer_DFPlayerMini_Serial_PIN_SERIAL_TX_A0);

/****** SYSTEM REQUIREMENT 1 *****/
/* Buzzer op pin 8 maakt continu geluid */
const uint8_t BUZZER_PIN = 8;

void setup(void)
{
    // Initialize Serial communication for debugging
    Serial.begin(115200);

    // Initialize buzzer pin as output
    pinMode(BUZZER_PIN, OUTPUT);

    Serial.println(F("Buzzer initialized on pin 8"));
}

void loop(void)
{
    // SYSTEM REQUIREMENT 1: Buzzer on pin 8 makes continuous sound
    // Set buzzer pin HIGH to make continuous sound
    digitalWrite(BUZZER_PIN, HIGH);
    delay(100);
    digitalWrite(BUZZER_PIN, LOW);
    delay(100);
}

/* END CODE */