View difference between Paste ID: YEt8Y2j6 and 6NFdJ0fs
SHOW: | | - or go back to the newest paste.
1-
 erase sector  = 50
1+
Z erase sector  = 50
2
3
 erase sector  = 51
4
*
5
 erase sector  = 52
6
7
 erase sector  = 53
8
*
9
 erase sector  = 54
10
11
 erase sector  = 55
12
*
13
 erase sector  = 56
14
15
 erase sector  = 57
16
17
 erase sector  = 58
18
*
19
 erase sector  = 59
20
21
 erase sector  = 60
22
*Erased 56 sectors
23
Copy to Flash...
24
 Copy 3643147 byte to Flash...
25
 addr = 0xBF0A4092 ,cnt=3298937
26
 addr = 0xBF0F8124 ,cnt=2954727
27
 addr = 0xBF14C1B6 ,cnt=2610517
28
 addr = 0xBF1A0248 ,cnt=2266307
29
 addr = 0xBF1F42DA ,cnt=1922097
30
 addr = 0xBF24836C ,cnt=1577887
31
 addr = 0xBF29C3FE ,cnt=1233677
32
 addr = 0xBF2F0490 ,cnt=889467
33
 addr = 0xBF344522 ,cnt=545257
34
 addr = 0xBF3985B4 ,cnt=201047 done
35
36
LINUX started...
37
38
 THIS IS ASIC
39
Linux version 2.6.23.17 (root@dd-wrt) (gcc version 4.5.2 (Linaro GCC 4.5-2011.02-0) ) #143 Tue Jun 14 11:59:32 CEST 2011
40
41
 The CPU frequency set to 384 MHz
42
32M RAM Detected!
43
CPU revision is: 0001964c
44
Determined physical RAM map:
45
 memory: 02000000 @ 00000000 (usable)
46
Built 1 zonelists in Zone order.  Total pages: 8128
47
Kernel command line: console=ttyS1,57600n8 root=/dev/mtdblock4 rootfstype=squashfs noinitrd
48
Primary instruction cache 32kB, physically tagged, 4-way, linesize 32 bytes.
49
Primary data cache 16kB, 4-way, linesize 32 bytes.
50
Synthesized TLB refill handler (20 instructions).
51
Synthesized TLB load handler fastpath (32 instructions).
52
Synthesized TLB store handler fastpath (32 instructions).
53
Synthesized TLB modify handler fastpath (31 instructions).
54
Cache parity protection disabled
55
cause = 8080001c, status = 1100ff00
56
PID hash table entries: 128 (order: 7, 512 bytes)
57
calculating r4koff... 003a9800(3840000)
58
CPU frequency 384.00 MHz
59
Using 192.000 MHz high precision timer.
60
console [ttyS1] enabled
61
Dentry cache hash table entries: 4096 (order: 2, 16384 bytes)
62
Inode-cache hash table entries: 2048 (order: 1, 8192 bytes)
63
Memory: 29532k/32768k available (2121k kernel code, 3236k reserved, 318k data, 112k init, 0k highmem)
64
Mount-cache hash table entries: 512
65
NET: Registered protocol family 16
66
Generic PHY: Registered new driver
67
NET: Registered protocol family 2
68
Time: MIPS clocksource has been installed.
69
IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
70
TCP established hash table entries: 1024 (order: 1, 8192 bytes)
71
TCP bind hash table entries: 1024 (order: 0, 4096 bytes)
72
TCP: Hash tables configured (established 1024 bind 1024)
73
TCP reno registered
74
Load Ralink DFS Timer Module
75
devfs: 2004-01-31 Richard Gooch (rgooch@atnf.csiro.au)
76
devfs: boot_options: 0x1
77
squashfs: version 3.0 (2006/03/15) Phillip Lougher
78
io scheduler noop registered
79
io scheduler deadline registered (default)
80
Ralink gpio driver initialized
81
Serial: 8250/16550 driver $Revision: 1.3 $ 2 ports, IRQ sharing disabled
82
serial8250: ttyS0 at I/O 0xb0000500 (irq = 37) is a 16550A
83
serial8250: ttyS1 at I/O 0xb0000c00 (irq = 12) is a 16550A
84
rt3052 access driver initialization.
85
PPP generic driver version 2.4.2
86
PPP Deflate Compression module registered
87
PPP BSD Compression module registered
88
MPPE/MPPC encryption/compression module registered
89
NET: Registered protocol family 24
90
PPPoL2TP kernel driver, V1.0
91
tun: Universal TUN/TAP device driver, 1.6
92
tun: (C) 1999-2004 Max Krasnyansky <maxk@qualcomm.com>
93
ralink flash device: 0x1000000 at 0xbf000000
94
Ralink SoC physically mapped flash: Found 1 x16 devices at 0x0 in 16-bit bank
95
 Amd/Fujitsu Extended Query Table at 0x0040
96
Ralink SoC physically mapped flash: Swapping erase regions for broken CFI table.
97
number of CFI chips: 1
98
cfi_cmdset_0002: Disabling erase-suspend-program due to code brokenness.
99
100
found squashfs at 127000
101
Creating 6 MTD partitions on "Ralink SoC physically mapped flash":
102
0x00000000-0x00030000 : "uboot"
103
0x00030000-0x00040000 : "uboot-config"
104
0x00040000-0x00050000 : "factory-defaults"
105
0x00050000-0x003e0000 : "linux"
106
0x00127000-0x003e0000 : "rootfs"
107
mtd: partition "rootfs" doesn't start on an erase block boundary -- force read-only
108
0x003e0000-0x003f0000 : "nvram"
109
Ralink APSoC Hardware Watchdog Timer
110
u32 classifier
111
    Actions configured
112
Netfilter messages via NETLINK v0.30.
113
nf_conntrack version 0.5.0 (1024 buckets, 4096 max)
114
ctnetlink v0.93: registering with nfnetlink.
115
IPv4 over IPv4 tunneling driver
116
GRE over IPv4 tunneling driver
117
ip_tables: (C) 2000-2006 Netfilter Core Team
118
IPP2P v0.8.2 loading
119
ClusterIP Version 0.8 loaded successfully
120
TCP bic registered
121
TCP cubic registered
122
TCP westwood registered
123
TCP highspeed registered
124
TCP hybla registered
125
TCP htcp registered
126
TCP vegas registered
127
TCP scalable registered
128
NET: Registered protocol family 1
129
NET: Registered protocol family 17
130
Welcome to PF_RING 3.2.1
131
(C) 2004-06 L.Deri <deri@ntop.org>
132
NET: Registered protocol family 27
133
PF_RING: bucket length    128 bytes
134
PF_RING: ring slots       4096
135
PF_RING: sample rate      1 [1=no sampling]
136
PF_RING: capture TX       No [RX only]
137
PF_RING: transparent mode Yes
138
PF_RING initialized correctly.
139
PF_RING: registered /proc/net/pf_ring/
140
802.1Q VLAN Support v1.8 Ben Greear <greearb@candelatech.com>
141
All bugs added by David S. Miller <davem@redhat.com>
142
MAC_ADRH -- : 0x00000000
143
MAC_ADRL -- : 0x00000000
144
145
eth2 mii.o query= phy_id:0, address:1 retval:7849
146
Ralink APSoC Ethernet Driver Initilization. v2.0  256 rx/tx descriptors allocated, mtu = 1500!
147
NAPI enable, weight = 0, Tx Ring = 256, Rx Ring = 256
148
MAC_ADRH -- : 0x0000000c
149
MAC_ADRL -- : 0x43305277
150
decode /dev/mtdblock4
151
VFS: Mounted root (squashfs filesystem) readonly.
152
Mounted devfs on /dev
153
Freeing unused kernel memory: 112k freed
154
start service
155
starting Architecture code for rt2880
156
starting hotplug
157
done
158
rt2860v2_ap: module license 'unspecified' taints kernel.
159
160
phy_tx_ring = 0x01c1e000, tx_ring = 0xa1c1e000
161
162
phy_rx_ring0 = 0x01c1f000, rx_ring0 = 0xa1c1f000
163
RT305x_ESW: Link Status Changed
164
CDMA_CSG_CFG = 81000007
165
GDMA1_FWD_CFG = 710000
166
switch reg write offset=14, value=405555
167
switch reg write offset=50, value=2001
168
switch reg write offset=98, value=7f3f
169
switch reg write offset=e4, value=3f
170
switch reg write offset=40, value=1002
171
switch reg write offset=44, value=1001
172
switch reg write offset=48, value=1001
173
switch reg write offset=70, value=ffff417e
174
/bin/sh: can't create /proc/sys/net/bridge/bridge-nf-call-arptables: nonexistent directory
175
/bin/sh: can't create /proc/sys/net/bridge/bridge-nf-call-ip6tables: nonexistent directory
176
/bin/sh: can't create /proc/sys/net/bridge/bridge-nf-call-iptables: nonexistent directory
177
br0: Dropping NETIF_F_UFO since no NETIF_F_HW_CSUM feature.
178
device br0 entered promiscuous mode
179
device vlan1 entered promiscuous mode
180
device eth2 entered promiscuous mode
181
/bin/sh: ead: not foundbr0: port 1(vlan1) entering learning state
182
183
device br0 left promiscuous mode
184
device br0 entered promiscuous mode
185
device br0 left promiscuous mode
186
device br0 entered promiscuous mode
187
RtmpOSNetDevDetach(): RtmpOSNetDeviceDetach(), dev->name=ra0!
188
0x1300 = 00064380
189
br0: topology change detected, propagating
190
br0: port 1(vlan1) entering forwarding state
191
0x1300 = 00064380
192
device ra0 entered promiscuous mode
193
br0: port 2(ra0) entering learning state
194
wland: No such file or directory
195
device vlan2 entered promiscuous mode
196
SIOCGIFFLAGS: No such device
197
device vlan2 left promiscuous mode
198
SIOCGIFFLAGS: No such device
199
br0: topology change detected, propagating
200
br0: port 2(ra0) entering forwarding state
201
SIOCGIFFLAGS: No such device
202
SIOCGIFFLAGS: No such device
203
SIOCGIFFLAGS: No such device
204
SIOCGIFFLAGS: No such device
205
SIOCGIFFLAGS: No such device
206
etherip: Ethernet over IPv4 tunneling driver
207
/bin/sh: can't create /proc/sys/net/bridge/bridge-nf-call-arptables: nonexistent directory
208
/bin/sh: can't create /proc/sys/net/bridge/bridge-nf-call-ip6tables: nonexistent directory
209
/bin/sh: can't create /proc/sys/net/bridge/bridge-nf-call-iptables: nonexistent directory
210
211
DD-WRT v24-sp2 std (c) 2011 NewMedia-NET GmbH
212
Release: 06/14/11 (SVN revision: 17201)
213
ÿ
214
DD-WRT login: ^@ÿÿà^@^@^@^@^@
215
                             connect: Network is unreachable
216
connect: Network is unreachable
217
connect: Network is unreachable
218
gethostbyname: Network is unreachable
219
220
DD-WRT v24-sp2 std (c) 2011 NewMedia-NET GmbH
221
Release: 06/14/11 (SVN revision: 17201)
222
ÿ
223
DD-WRT login: root
224
Password:
225
==========================================================
226
227
 ____  ___    __        ______ _____         ____  _  _
228
 | _ \| _ \   \ \      / /  _ \_   _| __   _|___ \| || |
229
 || | || ||____\ \ /\ / /| |_) || |   \ \ / / __) | || |_
230
 ||_| ||_||_____\ V  V / |  _ < | |    \ V / / __/|__   _|
231
 |___/|___/      \_/\_/  |_| \_\|_|     \_/ |_____|  |_|
232
233
                       DD-WRT v24-sp2
234
                   http://www.dd-wrt.com
235
236
==========================================================
237
Jan  1 00:03:08 login[1130]: root login on 'console'
238
239
240
BusyBox v1.13.4 (2011-06-14 12:03:12 CEST) built-in shell (ash)
241
Enter 'help' for a list of built-in commands.
242
243
root@DD-WRT:~# w
244
-sh: w: not found
245
root@DD-WRT:~# exit