Not a member of Pastebin yet?
Sign Up,
it unlocks many cool features!
- Z erase sector = 50
- erase sector = 51
- *
- erase sector = 52
- erase sector = 53
- *
- erase sector = 54
- erase sector = 55
- *
- erase sector = 56
- erase sector = 57
- erase sector = 58
- *
- erase sector = 59
- erase sector = 60
- *Erased 56 sectors
- Copy to Flash...
- Copy 3643147 byte to Flash...
- addr = 0xBF0A4092 ,cnt=3298937
- addr = 0xBF0F8124 ,cnt=2954727
- addr = 0xBF14C1B6 ,cnt=2610517
- addr = 0xBF1A0248 ,cnt=2266307
- addr = 0xBF1F42DA ,cnt=1922097
- addr = 0xBF24836C ,cnt=1577887
- addr = 0xBF29C3FE ,cnt=1233677
- addr = 0xBF2F0490 ,cnt=889467
- addr = 0xBF344522 ,cnt=545257
- addr = 0xBF3985B4 ,cnt=201047 done
- LINUX started...
- THIS IS ASIC
- Linux version 2.6.23.17 (root@dd-wrt) (gcc version 4.5.2 (Linaro GCC 4.5-2011.02-0) ) #143 Tue Jun 14 11:59:32 CEST 2011
- The CPU frequency set to 384 MHz
- 32M RAM Detected!
- CPU revision is: 0001964c
- Determined physical RAM map:
- memory: 02000000 @ 00000000 (usable)
- Built 1 zonelists in Zone order. Total pages: 8128
- Kernel command line: console=ttyS1,57600n8 root=/dev/mtdblock4 rootfstype=squashfs noinitrd
- Primary instruction cache 32kB, physically tagged, 4-way, linesize 32 bytes.
- Primary data cache 16kB, 4-way, linesize 32 bytes.
- Synthesized TLB refill handler (20 instructions).
- Synthesized TLB load handler fastpath (32 instructions).
- Synthesized TLB store handler fastpath (32 instructions).
- Synthesized TLB modify handler fastpath (31 instructions).
- Cache parity protection disabled
- cause = 8080001c, status = 1100ff00
- PID hash table entries: 128 (order: 7, 512 bytes)
- calculating r4koff... 003a9800(3840000)
- CPU frequency 384.00 MHz
- Using 192.000 MHz high precision timer.
- console [ttyS1] enabled
- Dentry cache hash table entries: 4096 (order: 2, 16384 bytes)
- Inode-cache hash table entries: 2048 (order: 1, 8192 bytes)
- Memory: 29532k/32768k available (2121k kernel code, 3236k reserved, 318k data, 112k init, 0k highmem)
- Mount-cache hash table entries: 512
- NET: Registered protocol family 16
- Generic PHY: Registered new driver
- NET: Registered protocol family 2
- Time: MIPS clocksource has been installed.
- IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
- TCP established hash table entries: 1024 (order: 1, 8192 bytes)
- TCP bind hash table entries: 1024 (order: 0, 4096 bytes)
- TCP: Hash tables configured (established 1024 bind 1024)
- TCP reno registered
- Load Ralink DFS Timer Module
- devfs: 2004-01-31 Richard Gooch (rgooch@atnf.csiro.au)
- devfs: boot_options: 0x1
- squashfs: version 3.0 (2006/03/15) Phillip Lougher
- io scheduler noop registered
- io scheduler deadline registered (default)
- Ralink gpio driver initialized
- Serial: 8250/16550 driver $Revision: 1.3 $ 2 ports, IRQ sharing disabled
- serial8250: ttyS0 at I/O 0xb0000500 (irq = 37) is a 16550A
- serial8250: ttyS1 at I/O 0xb0000c00 (irq = 12) is a 16550A
- rt3052 access driver initialization.
- PPP generic driver version 2.4.2
- PPP Deflate Compression module registered
- PPP BSD Compression module registered
- MPPE/MPPC encryption/compression module registered
- NET: Registered protocol family 24
- PPPoL2TP kernel driver, V1.0
- tun: Universal TUN/TAP device driver, 1.6
- tun: (C) 1999-2004 Max Krasnyansky <maxk@qualcomm.com>
- ralink flash device: 0x1000000 at 0xbf000000
- Ralink SoC physically mapped flash: Found 1 x16 devices at 0x0 in 16-bit bank
- Amd/Fujitsu Extended Query Table at 0x0040
- Ralink SoC physically mapped flash: Swapping erase regions for broken CFI table.
- number of CFI chips: 1
- cfi_cmdset_0002: Disabling erase-suspend-program due to code brokenness.
- found squashfs at 127000
- Creating 6 MTD partitions on "Ralink SoC physically mapped flash":
- 0x00000000-0x00030000 : "uboot"
- 0x00030000-0x00040000 : "uboot-config"
- 0x00040000-0x00050000 : "factory-defaults"
- 0x00050000-0x003e0000 : "linux"
- 0x00127000-0x003e0000 : "rootfs"
- mtd: partition "rootfs" doesn't start on an erase block boundary -- force read-only
- 0x003e0000-0x003f0000 : "nvram"
- Ralink APSoC Hardware Watchdog Timer
- u32 classifier
- Actions configured
- Netfilter messages via NETLINK v0.30.
- nf_conntrack version 0.5.0 (1024 buckets, 4096 max)
- ctnetlink v0.93: registering with nfnetlink.
- IPv4 over IPv4 tunneling driver
- GRE over IPv4 tunneling driver
- ip_tables: (C) 2000-2006 Netfilter Core Team
- IPP2P v0.8.2 loading
- ClusterIP Version 0.8 loaded successfully
- TCP bic registered
- TCP cubic registered
- TCP westwood registered
- TCP highspeed registered
- TCP hybla registered
- TCP htcp registered
- TCP vegas registered
- TCP scalable registered
- NET: Registered protocol family 1
- NET: Registered protocol family 17
- Welcome to PF_RING 3.2.1
- (C) 2004-06 L.Deri <deri@ntop.org>
- NET: Registered protocol family 27
- PF_RING: bucket length 128 bytes
- PF_RING: ring slots 4096
- PF_RING: sample rate 1 [1=no sampling]
- PF_RING: capture TX No [RX only]
- PF_RING: transparent mode Yes
- PF_RING initialized correctly.
- PF_RING: registered /proc/net/pf_ring/
- 802.1Q VLAN Support v1.8 Ben Greear <greearb@candelatech.com>
- All bugs added by David S. Miller <davem@redhat.com>
- MAC_ADRH -- : 0x00000000
- MAC_ADRL -- : 0x00000000
- eth2 mii.o query= phy_id:0, address:1 retval:7849
- Ralink APSoC Ethernet Driver Initilization. v2.0 256 rx/tx descriptors allocated, mtu = 1500!
- NAPI enable, weight = 0, Tx Ring = 256, Rx Ring = 256
- MAC_ADRH -- : 0x0000000c
- MAC_ADRL -- : 0x43305277
- decode /dev/mtdblock4
- VFS: Mounted root (squashfs filesystem) readonly.
- Mounted devfs on /dev
- Freeing unused kernel memory: 112k freed
- start service
- starting Architecture code for rt2880
- starting hotplug
- done
- rt2860v2_ap: module license 'unspecified' taints kernel.
- phy_tx_ring = 0x01c1e000, tx_ring = 0xa1c1e000
- phy_rx_ring0 = 0x01c1f000, rx_ring0 = 0xa1c1f000
- RT305x_ESW: Link Status Changed
- CDMA_CSG_CFG = 81000007
- GDMA1_FWD_CFG = 710000
- switch reg write offset=14, value=405555
- switch reg write offset=50, value=2001
- switch reg write offset=98, value=7f3f
- switch reg write offset=e4, value=3f
- switch reg write offset=40, value=1002
- switch reg write offset=44, value=1001
- switch reg write offset=48, value=1001
- switch reg write offset=70, value=ffff417e
- /bin/sh: can't create /proc/sys/net/bridge/bridge-nf-call-arptables: nonexistent directory
- /bin/sh: can't create /proc/sys/net/bridge/bridge-nf-call-ip6tables: nonexistent directory
- /bin/sh: can't create /proc/sys/net/bridge/bridge-nf-call-iptables: nonexistent directory
- br0: Dropping NETIF_F_UFO since no NETIF_F_HW_CSUM feature.
- device br0 entered promiscuous mode
- device vlan1 entered promiscuous mode
- device eth2 entered promiscuous mode
- /bin/sh: ead: not foundbr0: port 1(vlan1) entering learning state
- device br0 left promiscuous mode
- device br0 entered promiscuous mode
- device br0 left promiscuous mode
- device br0 entered promiscuous mode
- RtmpOSNetDevDetach(): RtmpOSNetDeviceDetach(), dev->name=ra0!
- 0x1300 = 00064380
- br0: topology change detected, propagating
- br0: port 1(vlan1) entering forwarding state
- 0x1300 = 00064380
- device ra0 entered promiscuous mode
- br0: port 2(ra0) entering learning state
- wland: No such file or directory
- device vlan2 entered promiscuous mode
- SIOCGIFFLAGS: No such device
- device vlan2 left promiscuous mode
- SIOCGIFFLAGS: No such device
- br0: topology change detected, propagating
- br0: port 2(ra0) entering forwarding state
- SIOCGIFFLAGS: No such device
- SIOCGIFFLAGS: No such device
- SIOCGIFFLAGS: No such device
- SIOCGIFFLAGS: No such device
- SIOCGIFFLAGS: No such device
- etherip: Ethernet over IPv4 tunneling driver
- /bin/sh: can't create /proc/sys/net/bridge/bridge-nf-call-arptables: nonexistent directory
- /bin/sh: can't create /proc/sys/net/bridge/bridge-nf-call-ip6tables: nonexistent directory
- /bin/sh: can't create /proc/sys/net/bridge/bridge-nf-call-iptables: nonexistent directory
- DD-WRT v24-sp2 std (c) 2011 NewMedia-NET GmbH
- Release: 06/14/11 (SVN revision: 17201)
- ÿ
- DD-WRT login: ^@ÿÿà^@^@^@^@^@
- connect: Network is unreachable
- connect: Network is unreachable
- connect: Network is unreachable
- gethostbyname: Network is unreachable
- DD-WRT v24-sp2 std (c) 2011 NewMedia-NET GmbH
- Release: 06/14/11 (SVN revision: 17201)
- ÿ
- DD-WRT login: root
- Password:
- ==========================================================
- ____ ___ __ ______ _____ ____ _ _
- | _ \| _ \ \ \ / / _ \_ _| __ _|___ \| || |
- || | || ||____\ \ /\ / /| |_) || | \ \ / / __) | || |_
- ||_| ||_||_____\ V V / | _ < | | \ V / / __/|__ _|
- |___/|___/ \_/\_/ |_| \_\|_| \_/ |_____| |_|
- DD-WRT v24-sp2
- http://www.dd-wrt.com
- ==========================================================
- Jan 1 00:03:08 login[1130]: root login on 'console'
- BusyBox v1.13.4 (2011-06-14 12:03:12 CEST) built-in shell (ash)
- Enter 'help' for a list of built-in commands.
- root@DD-WRT:~# w
- -sh: w: not found
- root@DD-WRT:~# exit
Add Comment
Please, Sign In to add comment