[] Linux version 5.4.74 (ubuntu@ip-172-31-27-145) (gcc version 8.4.0 (OpenWrt GCC 8.4.0 r14868+13-dd651e54cc)) #0 Fri Dec 4 15:35:50 2020
[] printk: bootconsole [early0] enabled
[] CPU0 revision is: 00019374 (MIPS 24Kc)
[] MIPS: machine is Jangala Get Box
[] SoC: Qualcomm Atheros QCA9533 ver 2 rev 0
[] Initrd not found or empty - disabling initrd
[] Primary instruction cache 64kB, VIPT, 4-way, linesize 32 bytes.
[] Primary data cache 32kB, 4-way, VIPT, cache aliases, linesize 32 bytes
[] Zone ranges:
[]   Normal   [mem 0x0000000000000000-0x0000000007ffffff]
[] Movable zone start for each node
[] Early memory node ranges
[]   node   0: [mem 0x0000000000000000-0x0000000007ffffff]
[] Initmem setup node 0 [mem 0x0000000000000000-0x0000000007ffffff]
[] Built 1 zonelists, mobility grouping on.  Total pages: 32480
[] Kernel command line: console=ttyS0,115200n8 rootfstype=squashfs,jffs2
[] Dentry cache hash table entries: 16384 (order: 4, 65536 bytes, linear)
[] Inode-cache hash table entries: 8192 (order: 3, 32768 bytes, linear)
[] Writing ErrCtl register=00000004
[] Readback ErrCtl register=00000004
[] mem auto-init: stack:off, heap alloc:off, heap free:off
[] Memory: 122196K/131072K available (4819K kernel code, 193K rwdata, 1112K rodata, 1228K init, 196K bss, 8876K reserved, 0K cma-reserved)
[] SLUB: HWalign=32, Order=0-3, MinObjects=0, CPUs=1, Nodes=1
[] NR_IRQS: 51
[] random: get_random_bytes called from start_kernel+0x32c/0x518 with crng_init=0
[] CPU clock: 658.593 MHz
[] clocksource: MIPS: mask: 0xffffffff max_cycles: 0xffffffff, max_idle_ns: 5804064938 ns
[] sched_clock: 32 bits at 329MHz, resolution 3ns, wraps every 6521420798ns
[] Calibrating delay loop... 438.78 BogoMIPS (lpj=877568)
[] pid_max: default: 32768 minimum: 301
[] Mount-cache hash table entries: 1024 (order: 0, 4096 bytes, linear)
[] Mountpoint-cache hash table entries: 1024 (order: 0, 4096 bytes, linear)
[] clocksource: jiffies: mask: 0xffffffff max_cycles: 0xffffffff, max_idle_ns: 7645041785100000 ns
[] futex hash table entries: 256 (order: -1, 3072 bytes, linear)
[] pinctrl core: initialized pinctrl subsystem
[] NET: Registered protocol family 16
[] workqueue: max_active 576 requested for napi_workq is out of range, clamping between 1 and 512
[] clocksource: Switched to clocksource MIPS
[] NET: Registered protocol family 2
[] tcp_listen_portaddr_hash hash table entries: 512 (order: 0, 4096 bytes, linear)
[] TCP established hash table entries: 1024 (order: 0, 4096 bytes, linear)
[] TCP bind hash table entries: 1024 (order: 0, 4096 bytes, linear)
[] TCP: Hash tables configured (established 1024 bind 1024)
[] UDP hash table entries: 256 (order: 0, 4096 bytes, linear)
[] UDP-Lite hash table entries: 256 (order: 0, 4096 bytes, linear)
[] NET: Registered protocol family 1
[] PCI: CLS 0 bytes, default 32
[] workingset: timestamp_bits=14 max_order=15 bucket_order=1
[] squashfs: version 4.0 (2009/01/31) Phillip Lougher
[] jffs2: version 2.2 (NAND) (SUMMARY) (LZMA) (RTIME) (CMODE_PRIORITY) (c) 2001-2006 Red Hat, Inc.
[] pinctrl-single 1804002c.pinmux: 576 pins, size 72
[] Serial: 8250/16550 driver, 1 ports, IRQ sharing disabled
[] printk: console [ttyS0] disabled
[] 18020000.uart: ttyS0 at MMIO 0x18020000 (irq = 9, base_baud = 1562500) is a 16550A
[] printk: console [ttyS0] enabled
[] printk: console [ttyS0] enabled
[] printk: bootconsole [early0] disabled
[] printk: bootconsole [early0] disabled
[] spi-nor spi0.0: w25q128 (16384 Kbytes)
[] 6 fixed-partitions partitions found on MTD device spi0.0
[] Creating 6 MTD partitions on "spi0.0":
[] 0x000000000000-0x000000040000 : "u-boot"
[] 0x000000040000-0x000000050000 : "u-boot-env"
[] 0x000000050000-0x000000800000 : "firmware"
[] 2 uimage-fw partitions found on MTD device firmware
[] Creating 2 MTD partitions on "firmware":
[] 0x000000000000-0x0000001f0000 : "kernel"
[] 0x0000001f0000-0x0000007b0000 : "rootfs"
[] mtd: device 4 (rootfs) set to be root filesystem
[] 1 squashfs-split partitions found on MTD device rootfs
[] 0x000000710000-0x0000007b0000 : "rootfs_data"
[] 0x000000800000-0x000000fb0000 : "firmware-b"
[] 0x000000fb0000-0x000000ff0000 : "persist"
[] 0x000000ff0000-0x000001000000 : "art"
[] libphy: Fixed MDIO Bus: probed
[] ag71xx 19000000.eth: Could not connect to PHY device. Deferring probe.
[] random: fast init done
[] libphy: ag71xx_mdio: probed
[] libphy: ar8xxx-mdio: probed
[] switch0: Atheros AR8229 rev. 1 switch registered on mdio.0
[] ag71xx 1a000000.eth: connected to PHY at fixed-0:00 [uid=00000000, driver=Generic PHY]
[] eth0: Atheros AG71xx at 0xba000000, irq 5, mode: gmii
[] i2c /dev entries driver
[] ath79-wdt 18060008.wdt: unable to register misc device, err=-16
[] ath79-wdt: probe of 18060008.wdt failed with error -16
[] NET: Registered protocol family 10
[] Segment Routing with IPv6
[] NET: Registered protocol family 17
[] 8021q: 802.1Q VLAN Support v1.8
[] PCI host bridge /ahb/pcie-controller@180c0000 ranges:
[]  MEM 0x0000000010000000..0x0000000013ffffff
[]   IO 0x0000000000000000..0x0000000000000000
[] ar724x-pci 180c0000.pcie-controller: PCIe link is down
[] PCI host bridge to bus 0000:00
[] pci_bus 0000:00: root bus resource [mem 0x10000000-0x13ffffff]
[] pci_bus 0000:00: root bus resource [io  0x0000]
[] pci_bus 0000:00: root bus resource [??? 0x00000000 flags 0x0]
[] pci_bus 0000:00: No busn resource found for root bus, will use [bus 00-ff]
[] pci_bus 0000:00: busn_res: [bus 00-ff] end is updated to 00
[] ag71xx 19000000.eth: connected to PHY at mdio.0:1f:04 [uid=004dd042, driver=Generic PHY]
[] eth1: Atheros AG71xx at 0xb9000000, irq 4, mode: mii
[] VFS: Mounted root (squashfs filesystem) readonly on device 31:4.
[] Freeing unused kernel memory: 1228K
[] This architecture does not have kernel memory protection.
[] Run /sbin/init as init process
[] init: Console is alive
[] init: - watchdog -
[] kmodloader: loading kernel modules from /etc/modules-boot.d/*
[] usbcore: registered new interface driver usbfs
[] usbcore: registered new interface driver hub
[] usbcore: registered new device driver usb
[] ehci_hcd: USB 2.0 'Enhanced' Host Controller (EHCI) Driver
[] ehci-fsl: Freescale EHCI Host controller driver
[] ehci-platform: EHCI generic platform driver
[] ehci-platform 1b000000.usb: EHCI Host Controller
[] ehci-platform 1b000000.usb: new USB bus registered, assigned bus number 1
[] ehci-platform 1b000000.usb: irq 3, io mem 0x1b000000
[] ehci-platform 1b000000.usb: USB 2.0 started, EHCI 1.00
[] hub 1-0:1.0: USB hub found
[] hub 1-0:1.0: 1 port detected
[] kmodloader: done loading kernel modules from /etc/modules-boot.d/*
[] init: - preinit -
[] usb 1-1: new high-speed USB device number 2 using ehci-platform
[] usb 1-1: device descriptor read/64, error -71
[] usb 1-1: device descriptor read/64, error -71
[] usb 1-1: new high-speed USB device number 3 using ehci-platform
[] random: jshn: uninitialized urandom read (4 bytes read)
[] random: jshn: uninitialized urandom read (4 bytes read)
[] usb 1-1: device descriptor read/64, error -71
[] random: jshn: uninitialized urandom read (4 bytes read)
[] usb 1-1: device descriptor read/64, error -71
[] usb usb1-port1: attempt power cycle
[] urandom_read: 6 callbacks suppressed
[] random: jshn: uninitialized urandom read (4 bytes read)
[] usb 1-1: new high-speed USB device number 4 using ehci-platform
[] usb 1-1: device not accepting address 4, error -71
[] eth0: link up (1000Mbps/Full duplex)
[] IPv6: ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready
[] usb 1-1: new high-speed USB device number 5 using ehci-platform
Press the [f] key and hit [enter] to enter failsafe mode
Press the [1], [2], [3] or [4] key and hit [enter] to select the debug level
[] usb 1-1: device not accepting address 5, error -71
[] usb usb1-port1: unable to enumerate USB device
[] jffs2_scan_eraseblock(): End of filesystem marker found at 0x10000
[] jffs2_build_filesystem(): unlocking the mtd device...
[] done.
[] jffs2_build_filesystem(): erasing all blocks after the end marker...
[] done.
[] jffs2: notice: (563) jffs2_build_xattr_subsystem: complete building xattr subsystem, 0 of xdatum (0 unchecked, 0 orphan) and 0 of xref (0 dead, 0 orphan) found.
[] mount_root: overlay filesystem has not been fully initialized yet
[] mount_root: switching to jffs2 overlay
[] overlayfs: upper fs does not support tmpfile.
- config restore -
[] urandom-seed: Seed file not found (/etc/urandom.seed)
[] eth0: link down
[] procd: - early -
[] procd: - watchdog -
[] procd: - watchdog -
[] procd: - ubus -
Failed to connect to ubus
[] procd: - init -
Please press Enter to activate this console.
[] kmodloader: loading kernel modules from /etc/modules.d/*
[] Mirror/redirect action on
[] u32 classifier
[]     input device check on
[]     Actions configured
[] urngd: v1.0.2 started.
[] usbcore: registered new interface driver cdc_wdm
[] Loading modules backported from Linux version v5.8-0-gbcf876870b95
[] Backport generated by backports.git v5.8-1-0-g79400d9e
[] xt_time: kernel timezone is -0000
[] random: crng init done
[] PPP generic driver version 2.4.2
[] NET: Registered protocol family 24
[] usbcore: registered new interface driver qmi_wwan
[] ieee80211 phy0: Atheros AR9531 Rev:2 mem=0xb8100000, irq=13
[] kmodloader: done loading kernel modules from /etc/modules.d/*