osmc@osmc:~$ sudo lsusb
sudo: lsusb: command not found
osmc@osmc:~$ dmesg | tail -n 50
[    6.045918] systemd[1]: Found dependency on rpcbind.service/start
[    6.045959] systemd[1]: Found dependency on network-online.target/start
[    6.045993] systemd[1]: Found dependency on network.target/start
[    6.046027] systemd[1]: Found dependency on connman.service/start
[    6.046058] systemd[1]: Found dependency on dbus.service/start
[    6.046090] systemd[1]: Found dependency on basic.target/start
[    6.046122] systemd[1]: Breaking ordering cycle by deleting job rpcbind.servi                                                                                                 ce/start
[    6.046161] systemd[1]: Job rpcbind.service/start deleted to break ordering c                                                                                                 ycle starting with basic.target/start
[    6.299147] fuse init (API version 7.23)
[    6.431713] EXT4-fs (mmcblk0p2): re-mounted. Opts: (null)
[    7.274327] systemd-udevd[111]: starting version 215
[    7.770197] lirc_dev: IR Remote Control driver registered, major 245
[    7.788296] lirc_rpi: module is from the staging directory, the quality is un                                                                                                 known, you have been warned.
[    7.839917] gpiomem-bcm2835 20200000.gpiomem: Initialised: Registers at 0x202                                                                                                 00000
[    8.541651] FAT-fs (mmcblk0p1): Volume was not properly unmounted. Some data                                                                                                  may be corrupt. Please run fsck.
[    8.764980] lirc_rpi: auto-detected active low receiver on GPIO pin 18
[    8.765361] lirc_rpi lirc_rpi: lirc_dev: driver lirc_rpi registered at minor                                                                                                  = 0
[    8.765379] lirc_rpi: driver registered!
[    9.544089] systemd[1]: Job rpcbind.service/start deleted to break ordering c                                                                                                 ycle starting with basic.target/start
[    9.979454] input: lircd as /devices/virtual/input/input0
[   11.568431] smsc95xx 1-1.1:1.0 eth0: hardware isn't capable of remote wakeup
[   11.568936] IPv6: ADDRCONF(NETDEV_UP): eth0: link is not ready
[   11.691649] systemd-journald[86]: Received request to flush runtime journal f                                                                                                 rom PID 1
[   13.188410] IPv6: ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready
[   13.195352] smsc95xx 1-1.1:1.0 eth0: link up, 100Mbps, full-duplex, lpa 0x45E                                                                                                 1
[   13.277963] 8021q: 802.1Q VLAN Support v1.8
[   17.124057] usb 1-1.2: device descriptor read/64, error -110
[   18.444994] Console: switching to colour dummy device 80x30
[   32.314524] usb 1-1.2: device descriptor read/64, error -110
[   32.504627] usb 1-1.2: new high-speed USB device number 5 using dwc_otg
[   47.585124] usb 1-1.2: device descriptor read/64, error -110
[   60.114778] Console: switching to colour frame buffer device 160x64
[   62.775648] usb 1-1.2: device descriptor read/64, error -110
[   62.965645] usb 1-1.2: new high-speed USB device number 6 using dwc_otg
[   73.386131] usb 1-1.2: device not accepting address 6, error -110
[   73.466120] usb 1-1.2: new high-speed USB device number 7 using dwc_otg
[   73.710723] Console: switching to colour dummy device 80x30
[   83.886475] usb 1-1.2: device not accepting address 7, error -110
[   83.886714] usb 1-1-port2: unable to enumerate USB device
[  395.867359] Console: switching to colour frame buffer device 160x64
[  411.010867] Console: switching to colour dummy device 80x30
[61009.906556] usb 1-1.2: new high-speed USB device number 8 using dwc_otg
[61010.008766] usb 1-1.2: New USB device found, idVendor=048d, idProduct=9135
[61010.008801] usb 1-1.2: New USB device strings: Mfr=0, Product=0, SerialNumber                                                                                                 =0
[61010.434197] usb 1-1.2: dvb_usb_af9035: prechip_version=83 chip_version=01 chi                                                                                                 p_type=9135
[61010.434650] usb 1-1.2: dvb_usb_v2: found a 'ITE 9135 Generic' in cold state
[61010.448417] usb 1-1.2: Direct firmware load for dvb-usb-it9135-01.fw failed w                                                                                                 ith error -2
[61010.448457] usb 1-1.2: dvb_usb_v2: Did not find the firmware file 'dvb-usb-it                                                                                                 9135-01.fw'. Please see linux/Documentation/dvb/ for more details on firmware-pr                                                                                                 oblems. Status -2
[61010.448509] dvb_usb_af9035: probe of 1-1.2:1.0 failed with error -2
[61010.450823] usbcore: registered new interface driver dvb_usb_af9035
osmc@osmc:~$ uname -a
Linux osmc 4.2.3-3-osmc #1 PREEMPT Tue Oct 13 17:58:31 UTC 2015 armv6l GNU/Linux
osmc@osmc:~$