2018-04-25 20:41:34  ★ Samantha Tosik uses the remote to lift the car up on the ramp.

2018-04-25 20:43:24  ★ Samantha Tosik uses a deep wheel socket to remove the back left tire off the vehicle.

2018-04-25 20:44:03  ★ uses the deep wheel socket to remove off the back right tire.      ((Samantha Tosik))

2018-04-25 20:44:36  ★ Samantha Tosik uses a deep wheel socket to remove the front right tire and then proceeds to remove the

2018-04-25 20:44:59  ★ front left tire leaving them all on the ground in a corner.      ((Samantha Tosik))

2018-04-25 20:48:20  ★ Samantha Tosik walks towards the A arm and the spindle, using a loosening the upper ball joint but not taki

2018-04-25 20:48:30  ★ -ng it off completely.      ((Samantha Tosik))

2018-04-25 20:49:16  ★ Samantha Tosik uses a hammer and taps it on the spindle until it breaks loose from the A arm.

2018-04-25 20:50:00  ★ Samantha Tosik uses oil  and puts it on the upper shock mount to make it easier to remove the

2018-04-25 20:50:07  ★ bolt that holds on the shock.      ((Samantha Tosik))

2018-04-25 20:50:53  ★ Samantha Tosik then uses the socket to loosen up the bolt on the tire rod but making sure to not take it o

2018-04-25 20:51:24  ★ -ff completely and tapping it with a hammer to bust it loose from the spindle.      ((Samantha Tosik))

2018-04-25 20:52:31  ★ Samantha Tosik uses oil on the bolt holding the sway bar and proceeds to loosen up the bolt holding on the

2018-04-25 20:52:36  ★ -sway bar.      ((Samantha Tosik))

2018-04-25 20:53:21  ★ Samantha Tosik uses a floor jack to jack at the lower control arm and removes the shock.

2018-04-25 20:55:03  ★ Samantha Tosik uses the to remove the upper ball joint from the spindle.

2018-04-25 20:55:33  ★ Samantha Tosik slowly lowers the jack down making sure it doesnt lose any lines and slowly removes

2018-04-25 20:55:43  ★ the tie rod completely.      ((Samantha Tosik))

2018-04-25 20:56:07  ★ Samantha Tosik removes the tie rod end allowing the spindle to hang down.

2018-04-25 20:56:52  ★ Samantha Tosik gets a spring compressor and puts it with the springs to remove the springs.

2018-04-25 20:58:00  ★ Samantha Tosik pushes down on the lower control arm and pulls out the spring.

2018-04-25 20:58:41  ★ Samantha Tosik puts the leveling kit onto the spring and proceeds to put it back in making sure it is in

2018-04-25 20:58:53  ★ -the right position and pushing it back in place.      ((Samantha Tosik))

2018-04-25 20:59:34  ★ Samantha Tosik uses the floor jack to jack it up again and reconnects the spindle to the upper A arm.

2018-04-25 21:00:53  ★ Samantha Tosik torques the sway bar and the ball joint back to how they were according to the manufacturer

2018-04-25 21:01:04  ★ specifications on the car.      ((Samantha Tosik))

2018-04-25 21:01:37  ★ Samantha Tosik carefully releases the spring compressor.

2018-04-25 21:02:37  ★ Samantha Tosik gets the back right wheel and pops it back into place  using a deep wheel socket to put it

2018-04-25 21:02:40  ★ back on.      ((Samantha Tosik))

2018-04-25 21:03:17  ★ Samantha Tosik then walks to the back left and puts the wheel  back into place whilst using the socket to

2018-04-25 21:03:21  ★ put it back on.      ((Samantha Tosik))

2018-04-25 21:03:58  ★ Samantha Tosik proceeds to put on both the front wheels by using the wheel socket and slowly brings the car

2018-04-25 21:04:11  ★ back down by lowering the ramp.      ((Samantha Tosik))

2018-04-25 21:04:14  *Samantha Tosik presses the button on the ramp controls lowering the car lift*