Not a member of Pastebin yet?
Sign Up,
it unlocks many cool features!
- # For more options and information see
- # http://rpf.io/configtxt
- # Some settings may impact device functionality. See link above for details
- # uncomment if you get no picture on HDMI for a default "safe" mode
- #hdmi_safe=1
- # uncomment this if your display has a black border of unused pixels visible
- # and your display can output without overscan
- disable_overscan=1
- # uncomment the following to adjust overscan. Use positive numbers if console
- # goes off screen, and negative if there is too much border
- #overscan_left=16
- #overscan_right=16
- #overscan_top=16
- #overscan_bottom=16
- # uncomment to force a console size. By default it will be display's size minus
- # overscan.
- #framebuffer_width=1920
- #framebuffer_height=1080
- # uncomment if hdmi display is not detected and composite is being output
- hdmi_force_hotplug=1
- # uncomment to force a specific HDMI mode (this will force VGA)
- hdmi_group=1
- hdmi_mode=16
- # uncomment to force a HDMI mode rather than DVI. This can make audio work in
- # DMT (computer monitor) modes
- #hdmi_drive=2
- # uncomment to increase signal to HDMI, if you have interference, blanking, or
- # no display
- #config_hdmi_boost=4
- # uncomment for composite PAL
- #sdtv_mode=2
- #uncomment to overclock the arm. 700 MHz is the default.
- arm_freq=1300
- gpu_freq=500
- core_freq=500
- sdram_freq=500
- sdram_schmoo=0x02000020
- over_voltage=6
- sdram_over_voltage=2
- v3d_freq=525
- # Uncomment some or all of these to enable the optional hardware interfaces
- #dtparam=i2c_arm=on
- #dtparam=i2s=on
- #dtparam=spi=on
- # Uncomment this to enable the lirc-rpi module
- #dtoverlay=lirc-rpi
- # Additional overlays and parameters are documented /boot/overlays/README
- # Enable audio (loads snd_bcm2835)
- dtparam=audio=on
- gpu_mem_256=128
- gpu_mem_512=256
- gpu_mem_1024=256
- overscan_scale=1
- gpu_mem = 32
Add Comment
Please, Sign In to add comment