Juniper SRX650

U-Boot 1.1.6-JNPR-1.9 (Build time: May 17 2010 - 06:30:31)

SRX_650 board revision major:0, minor:10, serial #: AADG5485
OCTEON CN5650-SCP pass 2.1, Core clock: 700 MHz, DDR clock: 333 MHz (666 Mhz dat                                   a rate)
DRAM:  2048 MB
Starting Memory POST...
Checking datalines... OK
Checking address lines... OK
Checking 512K memory for U-Boot... OK.
Running U-Boot CRC Test... OK.
Flash:  8 MB
USB:   scanning bus for devices... 2 USB Device(s) found
       scanning bus for storage devices... 0 Storage Device(s) found
Clearing DRAM........ done
Fuse: 0x0fff, Coremask: 0x0fff
BIST check passed.
0:00:00.0 Vendor/Device ID = 0x850910b5
0:01:01.0 Vendor/Device ID = 0x850910b5
0:02:00.0 Vendor/Device ID = 0xb68014e4
Boot Media: usb internal-compact-flash external-compact-flash
Net:   octeth0, octeth1, octeth2, octeth3

  ide 0: Model: CF 2GB Firm: 20080112 Ser#: 2010B     0000128560
            Type: Removable Hard Disk
            Capacity: 2000.7 MB = 1.9 GB (4097520 x 512)
POST Passed
Press SPACE to abort autoboot in 1 seconds
ELF file is 32 bit
Loading .text @ 0x8f000078 (244680 bytes)
Loading .rodata @ 0x8f03bc40 (13940 bytes)
Loading .rodata.str1.4 @ 0x8f03f2b4 (16432 bytes)
Loading set_Xcommand_set @ 0x8f0432e4 (100 bytes)
Loading .rodata.cst4 @ 0x8f043348 (20 bytes)
Loading .data @ 0x8f044000 (5608 bytes)
Loading .data.rel.ro @ 0x8f0455e8 (120 bytes)
Loading .data.rel @ 0x8f045660 (136 bytes)
Clearing .bss @ 0x8f0456e8 (11656 bytes)
## Starting application at 0x8f000078 ...
Consoles: U-Boot console
Found compatible API, ver. 1.9

FreeBSD/MIPS U-Boot bootstrap loader, Revision 1.9
([email protected], Mon May 17 05:45:58 UTC 2010)
Memory: 2048MB
[0]Booting from internal-compact-flash slice 1
Un-Protected 1 sectors
writing to flash...
Protected 1 sectors
Loading /boot/defaults/loader.conf
/kernel data=0xb15b3c+0x13464c syms=[0x4+0x8bb00+0x4+0xcac15]


Hit [Enter] to boot immediately, or space bar for command prompt.
Booting [/kernel]...
Kernel entry at 0x801000e0 ...
init regular console
Primary ICache: Sets 64 Size 128 Asso 4
Primary DCache: Sets 1 Size 128 Asso 64
Secondary DCache: Sets 2048 Size 128 Asso 8
GDB: debug ports: uart
GDB: current port: uart
KDB: debugger backends: ddb gdb
KDB: current backend: ddb
kld_map_v: 0x8ff80000, kld_map_p: 0x0
Copyright (c) 1996-2015, Juniper Networks, Inc.
All rights reserved.
Copyright (c) 1992-2006 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
        The Regents of the University of California. All rights reserved.
JUNOS 12.1X46-D35.1 #0: 2015-05-14 23:19:08 UTC
    [email protected]:/volume/build/junos/12.1/service/12.1X46-D35.1/o                                   bj-octeon/junos/bsd/kernels/JSRXNLE/kernel
JUNOS 12.1X46-D35.1 #0: 2015-05-14 23:19:08 UTC
    [email protected]:/volume/build/junos/12.1/service/12.1X46-D35.1/o                                   bj-octeon/junos/bsd/kernels/JSRXNLE/kernel
real memory  = 2147483648 (2048MB)
avail memory = 1057017856 (1008MB)
FreeBSD/SMP: Multiprocessor System Detected: 12 CPUs
Security policy loaded: JUNOS MAC/pcap (mac_pcap)
Security policy loaded: JUNOS MAC/runasnonroot (mac_runasnonroot)
netisr_init: !debug_mpsafenet, forcing maxthreads from 12 to 1
cpu0 on motherboard
: CAVIUM's OCTEON 56XX CPU Rev. 0.9 with no FPU implemented
        L1 Cache: I size 32kb(128 line), D size 8kb(128 line), sixty four way.
        L2 Cache: Size 2048kb, 8 way
obio0 on motherboard
uart0: <Octeon-16550 channel 0> on obio0
uart0: console (9600,n,8,1)
twsi0 on obio0
dwc0: <Synopsis DWC OTG Controller Driver> on obio0
usb0: <USB Bus for DWC OTG Controller> on dwc0
usb0: USB revision 2.0
uhub0: vendor 0x0000 DWC OTG root hub, class 9/0, rev 2.00/1.00, addr 1
uhub0: 1 port with 1 removable, self powered
uhub1: vendor 0x0409 product 0x005a, class 9/0, rev 2.00/1.00, addr 2
uhub1: single transaction translator
uhub1: 4 ports with 4 removable, self powered
pcib0: <Cavium on-chip PCIe HOST bridge> on obio0
Disabling Octeon big bar support
PCIe: Waiting for port 0 to finish reset
PCIe: Port 0 link active, 4 lanes
PCIe: Waiting for port 1 to finish reset
PCIe: Port 1 link active, 4 lanes
pcib0: Initialized controller
pci0: <PCI bus> on pcib0
pcib2: <PCI-PCI bridge> irq 0 at device 0.0 on pci0
pci1: <PCI bus> on pcib2
pcib3: <PCI-PCI bridge> irq 0 at device 1.0 on pci1
pci2: <PCI bus> on pcib3
pci2: <network, ethernet> at device 0.0 (no driver attached)
pcib4: <PCI-PCI bridge> irq 0 at device 2.0 on pci1
pci3: <PCI bus> on pcib4
atapci0: <SiI 3132 SATA300 controller> mem 0x100000-0x10007f,0x104000-0x107fff irq 0 at device 0.0 on pci3
unknown: Allocating IRQ for intpin 1, device atapci failed, i2cid
pcib0: Allocating IRQ for atapci failed
atapci0: unable to map interrupt
device_attach: atapci0 attach returned 6
pcib5: <PCI-PCI bridge> irq 0 at device 3.0 on pci1
pci4: <PCI bus> on pcib5
pcib6: <PCI-PCI bridge> mem 0x200000-0x21ffff irq 0 at device 0.0 on pci4
pci5: <PCI bus> on pcib6
pcib7: <PCI-PCI bridge> irq 0 at device 1.0 on pci5
pci6: <PCI bus> on pcib7
pcib8: <PCI-PCI bridge> irq 0 at device 2.0 on pci5
pci7: <PCI bus> on pcib8
pcib9: <PCI-PCI bridge> irq 0 at device 3.0 on pci5
pci8: <PCI bus> on pcib9
pcib10: <PCI-PCI bridge> irq 0 at device 4.0 on pci5
pci9: <PCI bus> on pcib10
pcib11: <PCI-PCI bridge> irq 0 at device 5.0 on pci5
pci10: <PCI bus> on pcib11
pcib12: <PCI-PCI bridge> irq 0 at device 6.0 on pci5
pci11: <PCI bus> on pcib12
pcib13: <PCI-PCI bridge> irq 0 at device 7.0 on pci5
pci12: <PCI bus> on pcib13
pcib14: <PCI-PCI bridge> irq 0 at device 4.0 on pci1
pci13: <PCI bus> on pcib14
pcib1: <Cavium on-chip PCIe HOST bridge> on obio0
pci14: <PCI bus> on pcib1
pci14: <processor> at device 0.0 (no driver attached)
CompactFlash model CF 2GB
ata0: <Octeon Compact Flash Driver> on obio0
gblmem0 on obio0
octpkt0: <Octeon RGMII> on obio0
cfi0: <AMD/Fujitsu - 8MB> on obio0
Timecounter "mips" frequency 700000000 Hz quality 0
###PCB Group initialized for udppcbgroup
###PCB Group initialized for tcppcbgroup
Trying to mount root from ufs:/dev/ad0s1a
WARNING: / was not properly dismounted
MFSINIT: Initialising MFSROOT
WARNING: / was not properly dismounted
Process-1 beginning MFSROOT initialization...
Creating MFSROOT...
/dev/md0: 20.0MB (40956 sectors) block size 16384, fragment size 2048
        using 4 cylinder groups of 5.00MB, 320 blks, 640 inodes.
super-block backups (for fsck -b #) at:
 32, 10272, 20512, 30752
Populating MFSROOT...
Creating symlinks...
Setting up mounts...
Continuing boot from MFSROOT...
Attaching /cf/packages/junos via /dev/mdctl...
Mounted junos package on /dev/md1...
J
Automatic reboot in progress...
** /dev/ad0s1a (NO WRITE)
** Last Mounted on /
** Root file system
** Phase 1 - Check Blocks and Sizes
** Phase 2 - Check Pathnames
** Phase 3 - Check Connectivity
** Phase 4 - Check Reference Counts
** Phase 5 - Check Cyl groups
164 files, 75074 used, 242841 free (73 frags, 30346 blocks, 0.0% fragmentation)
mount reload of '/' failed: Operation not supported

Verified junos signed by PackageProduction_12_1_0
Verified jboot signed by PackageProduction_12_1_0
Verified junos-12.1X46-D35.1-domestic signed by PackageProduction_12_1_0
** /dev/bo0s3e
** Last Mounted on /config
** Phase 1 - Check Blocks and Sizes
** Phase 2 - Check Pathnames
** Phase 3 - Check Connectivity
** Phase 4 - Check Reference Counts
** Phase 5 - Check Cyl groups
17 files, 112 used, 24998 free (22 frags, 3122 blocks, 0.1% fragmentation)

***** FILE SYSTEM MARKED CLEAN *****
** /dev/bo0s3f
** Last Mounted on /cf/var
** Phase 1 - Check Blocks and Sizes
INCORRECT BLOCK COUNT I=78 (4 should be 0)
CORRECT? yes

** Phase 2 - Check Pathnames
** Phase 3 - Check Connectivity
** Phase 4 - Check Reference Counts
UNREF FILE I=78  OWNER=0 MODE=100600
SIZE=0 MTIME=Jan 31 20:14 2019
CLEAR? yes

UNREF FILE I=40265  OWNER=0 MODE=100640
SIZE=102071 MTIME=Nov  7 19:38 2018
CLEAR? yes

** Phase 5 - Check Cyl groups
FREE BLK COUNT(S) WRONG IN SUPERBLK
SALVAGE? yes

SUMMARY INFORMATION BAD
SALVAGE? yes

BLK(S) MISSING IN BIT MAPS
SALVAGE? yes

384 files, 12359 used, 302935 free (135 frags, 37850 blocks, 0.0% fragmentation)

***** FILE SYSTEM MARKED CLEAN *****

***** FILE SYSTEM WAS MODIFIED *****
Loading configuration ...
Time and ticks drifted too much,                        resetting synchronization...
mgd: commit complete
Setting initial options: .
Starting optional daemons:  usbd.
Doing initial network setup:.
Initial interface configuration:
additional daemons: eventd.
Additional routing options:kern.module_path: /boot//kernel;/boot/modules -> /boot/modules;/modules/ifpfe_drv;/modules;
kld netpfe drv: ifpfed_dialer ipsec kld.
Doing additional network setup: ipv6_security=YES.
Starting final network daemons:.
setting ldconfig path: /usr/lib /opt/lib
starting standard daemons: cron.
Initial rc.mips initialization:.
Local package initialization:.
starting local daemons:set cores for group access
.
kern.securelevel: -1 -> 1
Creating JAIL MFS partition...
JAIL MFS partition created
Boot media /dev/ad0 has dual root support
WARNING: JUNOS versions running on dual partitions are not same
** /dev/ad0s2a
FILE SYSTEM CLEAN; SKIPPING CHECKS
clean, 246071 free (55 frags, 30752 blocks, 0.0% fragmentation)
Fri Jun 25 01:16:49 UTC 2021

fw1.ops.pao1.mozilla.net (ttyu0)

login: