REQUIRED
MAIN AREA
_m -Emergency Door [hinged door] is required by each revolving door.AIso for WELL
Cenmcorion, min 3m iong door mot is requires.
SOLUTION PLAZA 520 1200 -InsT<:III hot wafer demonstration equipmeni on 2F. Balcony is necessary for placing
oufdoor unit
BALCONY 10 Install lF balcony for placing outdoor unit for residential products. Chiller < 3.4t
[3200xi200} to be placed on i F.
-Slab to be FL-BOO.
- Flows are planned where customers and staffs to access from iF and service
department and vendors to access from Bi F.
-Assuming that the freight Ev is used for routing equipment rooftop replacement,
setting the EV cage inner size W 1,950 x D 2, 450 x H 2,600, maximum load 2,500 .
n: SOLUTION PLAZA -Size of the large tour bus that comes into iF Carriage to have 45 seats. Since the bus
cannot be parked for a long time on the front street, the bus needs to be parked on
the site. Therefore, plan to devise three devaluation points.
-Visitor tour route: Solution Plaza [i-QFJ —»Training Center [3F]—>Contact Center 8.
Testing Room [4F]
-Establish a cafe {tenant} of about SOsqm to attract passersbv on iF.
-Set up a motorbike parking tor visitors on the ground floor.
-Install flag poles on the facade by the entrance.
-InstaII hot water demonstration equipment on 2F. Balcony is necessary for placing
outdoor unit-
MEETING ROOM 2 35 30 Install iF balcony for placing outdoor unit for residential products. Chiller < 3.4t
MEETING ROOM 3 25 30 [3200xi200} to be placed on lF.
2F SOLUTION PLAZA -5iob ro be FL-soo.
MEETING ROOM 5 20 30 -Visitor tour route: Solution Plaza [i -2F] —>Training Center [SH—Contact Center &
_—
___
-Secure 60 Male Lockers and 9-18 Female Lockers.Size of the locker to be H l ,800x
W900 {9 box].
AP ROOM 40 50 -Between Roomi and Room3&2 to be movable partitions.
BRAZING TRAINING CENTER 80 iOO - N0 anchor is needed to fix the equipment to the floor.
_m -When setting up the equipment under direct management work, please use the
CLASSROOM 2 65 70 equipment side anti-vibration stand. When setting up the equipment [the Client's
Scope], please use the anti—vibration stand. No measures will be taken such as making
___the floor ot the Training Room architecturally "floating tloor structure".
-Since 3F Training Rooms require sound insulation, it is difficult to secure the insulation
STORAGE 1 25 quality thus the hinged doors to be used.
3F TRAINING CENTER In addition, the general doors are set to be single-open effective W 850, double open
SUPPLY STORAGE effective W 1700.
- Floor waterproofing is required for 3F Training Rooms and 4F Testing Room.
-3F Classrooms i, 2 and 3 to be the window's side as a front. The desk size should be
WI 400>< H750>< D600.
-Floor waterproofing is required for Pantry, Kitchen and wet areas.
-Visifor tour route: Solution Plaza [i -2F] —’Training Center [SH-Contact Center 8.
Testing Room [4F]
-When setting up the equipment under direct management work, please use the
equipment side anti-vibration stand. When setting up the equipment (the Client's
PRESENTATION ROOM 35 50 Scope], please use the anti-vibration stand. No measures will be taken such as making
RELAX CENTER 25 30 the floor of the Training Room architecturally "floating floor structure".
-Since SF Training Rooms require sound insulation, it is difficult to secure the insulation
HVAC OURDOOR MECH SPACE 45 39 Quality thus the hinged doors to be used.
In addition, the general doors are set to be single-open effective W 850, double open
effective W 1700.
- Floor waterproofing is required for 3F Training Rooms and 4F Testing Room.
-SurveiIIance monitors ii 370mmx8] immxé monitors] and 7 monitoring seats to be
installed.
-FIoor waterproofing is required for

Free Online OCR newocr.com