U-Boot SPL 2021.04+olimex-1-20231103.141125 (Nov 03 2023 - 14:12:28 +0000)
DRAM: 512 MiB
CPU: 912000000Hz, AXI/AHB/APB: 3/2/2
Loading configuration from EEPROM: Error
Loading configuration from MMC: OK
Verifying data: Error
Error

WARNING: The board cannot be detected!
Please run:
        'olinuxino config list' - Select your board
        'olinuxino config write' - Store the board configuration
        'reset' - Reset the board and load the configuration

Using 'A20-OLinuXino-LIME' as fallback configuration.

Trying to boot from MMC1


U-Boot 2021.04+olimex-1-20231103.141125 (Nov 03 2023 - 14:12:28 +0000) Allwinney

CPU:   Allwinner A20 (SUN7I)
ID:    A20-OLinuXino-LIME Rev.A
SN:    00000000
MAC:   FF:FF:FF:FF:FF:FF
I2C:   ready
DRAM:  512 MiB
MMC:   mmc@1c0f000: 0
Loading Environment from EXT4... *** Warning - bad CRC, using default environmet

Loading Environment from FAT... ** No device specified **
DDC: timeout reading EDID
DDC: timeout reading EDID
DDC: timeout reading EDID
In:    serial
Out:   serial
Err:   serial
Allwinner mUSB OTG (Peripheral)
Net:   eth0: ethernet@1c50000, eth1: usb_ether
starting USB...
Bus usb@1c14000: USB EHCI 1.00
Bus usb@1c14400: USB OHCI 1.0
Bus usb@1c1c000: USB EHCI 1.00
Bus usb@1c1c400: USB OHCI 1.0
scanning bus usb@1c14000 for devices... 2 USB Device(s) found
scanning bus usb@1c14400 for devices... 1 USB Device(s) found
scanning bus usb@1c1c000 for devices... 1 USB Device(s) found
scanning bus usb@1c1c400 for devices... 1 USB Device(s) found
       scanning usb for storage devices... 0 Storage Device(s) found
Hit any key to stop autoboot:  0
switch to partitions #0, OK
mmc0 is current device
Scanning mmc 0:1...
Found U-Boot script /boot/boot.scr
2274 bytes read in 1 ms (2.2 MiB/s)
## Executing script at 43100000
Boot script loaded from mmc
Checking for /uEnv.txt...
Checking for /boot/uEnv.txt...
400 bytes read in 1 ms (390.6 KiB/s)
Loaded environment from /boot/uEnv.txt
Loading FIT image...
16233771 bytes read in 888 ms (17.4 MiB/s)
## Loading kernel from FIT Image at 58000000 ...
   Using 'config-7739' configuration
   Trying 'kernel-1' kernel subimage
     Description:  Linux kernel 5.10.180-olimex
     Type:         Kernel Image
     Compression:  uncompressed
     Data Start:   0x580000d4
     Data Size:    6571752 Bytes = 6.3 MiB
     Architecture: ARM
     OS:           Linux
     Load Address: 0x40080000
     Entry Point:  0x40080000
     Hash algo:    crc32
     Hash value:   ab9ddc5e
     Hash algo:    sha1
     Hash value:   987115694f4ebc9b887060eecd13d520820f53c4
   Verifying Hash Integrity ... crc32+ sha1+ OK
## Loading ramdisk from FIT Image at 58000000 ...
   Using 'config-7739' configuration
   Trying 'ramdisk-1' ramdisk subimage
     Description:  Ramdisk for kernel 5.10.180-olimex
     Type:         RAMDisk Image
     Compression:  Unknown Compression
     Data Start:   0x586448f0
     Data Size:    9205798 Bytes = 8.8 MiB
     Architecture: ARM
     OS:           Linux
     Load Address: 0x4fe00000
     Entry Point:  0x4fe00000
     Hash algo:    crc32
     Hash value:   29f4036b
     Hash algo:    sha1
     Hash value:   307c320132b8bdabcc1b6e865afe145b9382ec4f
   Verifying Hash Integrity ... crc32+ sha1+ OK
   Loading ramdisk from 0x586448f0 to 0x4fe00000
WARNING: 'compression' nodes for ramdisks are deprecated, please fix your .its !
## Loading fdt from FIT Image at 58000000 ...
   Using 'config-7739' configuration
   Trying 'fdt-1' fdt subimage
     Description:  unavailable
     Type:         Flat Device Tree
     Compression:  uncompressed
     Data Start:   0x58f0c204
     Data Size:    42972 Bytes = 42 KiB
     Architecture: ARM
     Load Address: 0x4fa00000
     Hash algo:    crc32
     Hash value:   9ca69e08
     Hash algo:    sha1
     Hash value:   e8705cd67aea16ffba139212128a3d631ac8fa4e
   Verifying Hash Integrity ... crc32+ sha1+ OK
   Loading fdt from 0x58f0c204 to 0x4fa00000
   Booting using the fdt blob at 0x4fa00000
EHCI failed to shut down host controller.
   Loading Kernel Image
   Loading Ramdisk to 49738000, end 49fff826 ... OK
   Loading Device Tree to 4972a000, end 497377db ... OK

Starting kernel ...

[    0.005661] /cpus/cpu@0 missing clock-frequency property
[    0.005704] /cpus/cpu@1 missing clock-frequency property
[    1.004937] sun4i-usb-phy 1c13400.phy: Couldn't request ID GPIO
[    1.315265] axp20x-i2c 0-0034: unsupported ramp value 1900
[    1.320857] vddio-csi1: failed to set ramp_delay: -EINVAL
[    1.326297] axp20x-regulator axp20x-regulator: Failed to register ldo3
[    1.496354] ahci-sunxi 1c18000.sata: PHY power up failed.
Loading, please wait...
Starting version 247.3-7+deb11u4
Begin: Loading essential drivers ... done.
Begin: Running /scripts/init-premount ... done.
Begin: Mounting root file system ... Begin: Running /scripts/local-top ... done.
Begin: Running /scripts/local-premount ... done.
Begin: Waiting for root file system ... Begin: Running /scripts/local-block ....
Begin: Running /scripts/local-block ... done.
Begin: Running /scripts/local-block ... done.
Begin: Running /scripts/local-block ... done.
Begin: Running /scripts/local-block ... done.
Begin: Running /scripts/local-block ... done.
Begin: Running /scripts/local-block ... done.
Begin: Running /scripts/local-block ... done.
Begin: Running /scripts/local-block ... done.
Begin: Running /scripts/local-block ... done.
Begin: Running /scripts/local-block ... done.
Begin: Running /scripts/local-block ... done.
Begin: Running /scripts/local-block ... done.
Begin: Running /scripts/local-block ... done.
Begin: Running /scripts/local-block ... done.
Begin: Running /scripts/local-block ... done.
Begin: Running /scripts/local-block ... done.
Begin: Running /scripts/local-block ... done.
Begin: Running /scripts/local-block ... done.
Begin: Running /scripts/local-block ... done.
Begin: Running /scripts/local-block ... done.
Begin: Running /scripts/local-block ... done.
Begin: Running /scripts/local-block ... done.
Begin: Running /scripts/local-block ... done.
Begin: Running /scripts/local-block ... done.
Begin: Running /scripts/local-block ... done.
Begin: Running /scripts/local-block ... done.
Begin: Running /scripts/local-block ... done.
Begin: Running /scripts/local-block ... done.
done.
Gave up waiting for root file system device.  Common problems:
 - Boot args (cat /proc/cmdline)
   - Check rootdelay= (did the system wait long enough?)
 - Missing modules (cat /proc/modules; ls /dev)
ALERT!  PARTUUID=c2d28430-01 does not exist.  Dropping to a shell!
Rebooting automatically due to panic= boot argument
[   44.480020] reboot: Restarting system