Slic3r config.ini

; Slic3r config.ini for Slicing test and 0.6.0/0.7.0 comparison

acceleration = 0
bottom_layer_speed_ratio = 0.3
bridge_fan_speed = 100
bridge_flow_ratio = 1
bridge_speed = 70
cooling =
disable_fan_first_layers = 1
duplicate_distance = 6
duplicate_x = 1
duplicate_y = 1
end_gcode = M104 S0 ; turn off temperature\nG28 X0  ; home X axis\nM84     ; disable motors
extrusion_axis = E
extrusion_multiplier = 1
extrusion_width_ratio = 0
fan_below_layer_time = 30
filament_diameter = 3
fill_angle = 45
fill_density = 0.3
fill_pattern = rectilinear
first_layer_height_ratio = 0.1
first_layer_temperature = 195
g0 = 0
gcode_arcs = 0
gcode_comments = 0
gcode_flavor = reprap
infill_acceleration = 50
infill_every_layers = 1
infill_speed = 50
layer_height = 0.4
max_fan_speed = 100
min_fan_speed = 35
min_print_speed = 10
notes =
nozzle_diameter = 0.5
output_filename_format = [input_filename_base].gcode
perimeter_acceleration = 25
perimeter_speed = 25
perimeters = 3
post_process =
print_center = 80,95
retract_before_travel = 2
retract_length = 3
retract_lift = 0.5
retract_restart_extra = 0
retract_speed = 30
rotate = 0
scale = 1
skirt_distance = 6
skirt_height = 1
skirts = 0
slowdown_below_layer_time = 20
small_perimeter_speed = 25
solid_fill_pattern = rectilinear
solid_infill_speed = 40
solid_layers = 3
start_gcode =
support_material = 1
support_material_tool = 0
temperature = 185
travel_speed = 130
use_relative_e_distances = 0
z_offset = 0