post -s 2 restore snapshot

MX6SDL JUPITER KT 4.2.2 U-Boot >                                                 bsp set -s 2
BSP A is valid
BSP B is valid
-boot sub mode

. done
Erased 1 sectors

. done
Erased 1 sectors
MX6SDL JUPITER KT 4.2.2 U-Boot >

U-Boot 2009.08 (Jan 06 2014 - 16:32:44)

CPU: Freescale i.MX6 family TO1.1 at 792 MHz
Thermal sensor with ratio = 174
Temperature:   54 C, calibration data 0x5514a87d
mx6q pll1: 792MHz
mx6q pll2: 528MHz
mx6q pll3: 480MHz
mx6q pll8: 50MHz
ipg clock     : 66000000Hz
ipg per clock : 66000000Hz
uart clock    : 80000000Hz
cspi clock    : 60000000Hz
ahb clock     : 132000000Hz
axi clock   : 198000000Hz
emi_slow clock: 99000000Hz
ddr clock     : 396000000Hz
usdhc1 clock  : 198000000Hz
usdhc2 clock  : 198000000Hz
usdhc3 clock  : 198000000Hz
usdhc4 clock  : 198000000Hz
nfc clock     : 24000000Hz
Board: i.MX6DL/Solo-JUPITER: unknown-board Board: 0x61011 [POR ]
Boot Device: NOR
I2C:   ready
DRAM:   1 GB
Flash:  8 MB
MMC:   FSL_USDHC: 0,FSL_USDHC: 1,FSL_USDHC: 2
Using default environment

In:    serial
Out:   serial
Err:   serial
***** display DDR calibration result *****
***************************************
Display result(register) of WriteLeveling

   MMDC registers updated from WriteLeveling
   MPWLDECTRL0 (0x021b080c) = 0x00320036
   MPWLDECTRL1 (0x021b0810) = 0x00140019
***************************************
Display result(register) of DDR calibration

   MMDC registers updated from calibration

   Read DQS Gating calibration
   MPDGCTRL0 PHY0 (0x021b083c) = 0x421C0215
   MPDGCTRL1 PHY0 (0x021b0840) = 0x016B0173

   Read calibration
   MPRDDLCTL PHY0 (0x021b0848) = 0x46484B48

   Write calibration
   MPWRDLCTL PHY0 (0x021b0850) = 0x423D3F41
***************************************


Net:   got MAC address from IIM: 00:00:00:00:00:00
FEC0 [PRIME]
BSP A is valid
BSP B is valid
imx6 core num: 1
BSP A is valid
BSP B is valid
match invalid password 1.
warp boot side A

Lineo Warp!! 4.0.0 (Jupiter14 1.0.1) Tue Jan 14 13:23:03 JST 2014

SDHC2 'SDU1 '  30735MB  4bit  50.0Mbit/s (HS)  block: 512  sect: 127  spec: 3
Snapshot ID : 681b6132
Snapshot total size : 0x15f7d140   compressed size : 0x049b8714
--- Read Snapshot ---
00800000
[  270.831292] add wake up source irq 51
[  270.837753] PM: freeze of devices complete after 9.946 msecs
[  270.838726] PM: late freeze of devices complete after 0.957 msecs
[  270.838735] Disabling non-boot CPUs ...
[  270.838926] Video Saved size is 71921984 bytes.
[  270.838935] FB Saved size gets reduced from 0x4f800000 to 0x00600000 bytes.
[  271.070098] dram save 70819 pages
[  271.070111] maxarea 0x0001182e(0x000107d2)  lowmem_maxarea 0x0001182e(0x000107d2)
[  271.070122] zonetbl 2  exttbl 21  dramtbl 1595
[   85.881403] L310 cache controller enabled
[   85.881403] l2x0: 16 ways, CACHE_ID 0x410000c8, AUX_CTRL 0x02050000, Cache size: 524288 B
[   85.893817] PM: early restore of devices complete after 0.662 msecs
[   85.909456] imx-ipuv3 imx-ipuv3.0: IPU DMFC NORMAL mode: 1(0~1), 5B(4,5), 5F(6,7)
[   85.962671] remove wake up source irq 51
[   85.964928] imx-sdma imx-sdma: loaded firmware 1.1
[   85.964999] fsl_otg_resume: add delay 200 ms
[   89.179442] wait otg vbus change timeout!
[   90.459624] mmc0: Starting deferred resume
[   90.489514] PM: restore of devices complete after 4595.431 msecs
[   90.599950] Restarting kernel threads ... done.
[   90.640562] mmc0: Deferred resume completed
[   90.671562] EXT4-fs (mmcblk0p8): recovery complete
[   90.676370] EXT4-fs (mmcblk0p8): mounted filesystem with ordered data mode. Opts: ,user_xattr,barrier=1,nomblk_io_submit,data=ordered
[   90.694669] Restarting tasks ... done.
[   90.710268] inotify_warp_restart Start.
[   90.714192] inotify_warp_restart Exit.
[   90.719643] usb 1-1: new full speed USB device number 6 using fsl-ehci
[   90.970746] usb 1-1: device descriptor read/64, error -71
[   91.299751] usb 1-1: device descriptor read/64, error -71
done
uid=0 gid=0@android:/ # D/NPuCom  ( 2188): [04:35:561]Send    : 9F 02 D0 00 00 00 28 00 00 00 00 00 00 00 F8 9F 03
D/NPuCom  ( 2188):
[   91.539493] usb 1-1: new full speed USB device number 7 using fsl-ehci
[   91.759485] usb 1-1: device descriptor read/64, error -71
[   92.079479] usb 1-1: device descriptor read/64, error -71
[   92.309486] usb 1-1: new full speed USB device number 8 using fsl-ehci
[   92.799520] usb 1-1: device not accepting address 8, error -71
[   92.919538] usb 1-1: new full speed USB device number 9 using fsl-ehci
D/sysdwatchdog( 2188): NPSysCtrlWDT ioctl(fd, WDIOC_KEEPALIVE, 0); feed dog every 15s , tc:277542, ret=0
[   93.399462] usb 1-1: device not accepting address 9, error -71
[   93.405396] hub 1-0:1.0: unable to enumerate USB device on port 1
D/NPuCom  ( 2188): [04:40:558]Send    : 9F 02 D0 00 00 00 28 00 00 00 00 00 00 00 F8 9F 03
D/NPuCom  ( 2188):
D/NPuCom  ( 2188): [04:45:559]Send    : 9F 02 D0 00 00 00 28 00 00 00 00 00 00 00 F8 9F 03
D/NPuCom  ( 2188):
D/NPuCom  ( 2188): [04:50:559]Send    : 9F 02 D0 00 00 00 28 00 00 00 00 00 00 00 F8 9F 03
D/NPuCom  ( 2188):
D/sysdwatchdog( 2188): NPSysCtrlWDT ioctl(fd, WDIOC_KEEPALIVE, 0); feed dog every 15s , tc:292542, ret=0


U-Boot 2009.08 (Jan 06 2014 - 16:32:44)

CPU: Freescale i.MX6 family TO1.1 at 792 MHz