**Blynk Control** rev_02

/********* Pleasedontcode.com **********

    Pleasedontcode thanks you for automatic code generation! Enjoy your code!

    - Terms and Conditions:
    You have a non-exclusive, revocable, worldwide, royalty-free license
    for personal and commercial use. Attribution is optional; modifications
    are allowed, but you're responsible for code maintenance. We're not
    liable for any loss or damage. For full terms,
    please visit pleasedontcode.com/termsandconditions.

    - Project: **Blynk Control**
    - Source Code NOT compiled for: Arduino Uno
    - Source Code created on: 2025-02-09 18:52:29

********* Pleasedontcode.com **********/

/****** SYSTEM REQUIREMENTS *****/
/****** SYSTEM REQUIREMENT 1 *****/
    /* blynk code */
/****** END SYSTEM REQUIREMENTS *****/

/* START CODE */

/****** DEFINITION OF LIBRARIES *****/
#include <Blynk.h> // Include Blynk library

/****** FUNCTION PROTOTYPES *****/
void setup(void);
void loop(void);

/***** DEFINITION OF DIGITAL OUTPUT PINS *****/
const uint8_t myLED_LED_PIN_D2      = 2;

/***** DEFINITION OF OUTPUT RAW VARIABLES *****/
/***** used to store raw data *****/
bool    myLED_LED_PIN_D2_rawData        = 0;

/***** DEFINITION OF OUTPUT PHYSICAL VARIABLES *****/
/***** used to store data after characteristic curve transformation *****/
float   myLED_LED_PIN_D2_phyData        = 0.0;

// Blynk authentication token
char auth[] = "YourAuthToken"; // Replace with your Blynk Auth Token

void setup(void)
{
    // put your setup code here, to run once:
    pinMode(myLED_LED_PIN_D2, OUTPUT);
    Blynk.begin(auth); // Initialize Blynk
}

void loop(void)
{
    // put your main code here, to run repeatedly:
    Blynk.run(); // Run Blynk
    updateOutputs(); // Refresh output data
}

void updateOutputs()
{
    digitalWrite(myLED_LED_PIN_D2, myLED_LED_PIN_D2_rawData);
}

/* END CODE */