Not a member of Pastebin yet?
Sign Up,
it unlocks many cool features!
- ; bed.g
- ; called to perform automatic delta calibration via G32
- ;
- ; generated by RepRapFirmware Configuration Tool on Sat Aug 19 2017 13:38:35 GMT-0400 (Eastern Standard Time)
- ; Clear any bed transform
- M561
- ; Home all towers
- G28
- ; Probe the bed at 6 peripheral and 6 halfway points, and perform 7-factor auto compensation
- ; Before running this, you should have set up your Z-probe trigger height to suit your build, in the G31 command in config.g.
- G30 P0 X0 Y99.9 H0 Z-99999
- G30 P1 X86.52 Y49.95 H0 Z-99999
- G30 P2 X86.52 Y-49.95 H0 Z-99999
- G30 P3 X0 Y-99.9 H0 Z-99999
- G30 P4 X-86.52 Y-49.95 H0 Z-99999
- G30 P5 X-86.52 Y49.95 H0 Z-99999
- G30 P6 X0 Y49.9 H0 Z-99999
- G30 P7 X43.21 Y24.95 H0 Z-99999
- G30 P8 X43.21 Y-24.95 H0 Z-99999
- G30 P9 X0 Y-49.9 H0 Z-99999
- G30 P10 X-43.21 Y-24.95 H0 Z-99999
- G30 P11 X-43.21 Y24.95 H0 Z-99999
- G30 P12 X0 Y0 H0 Z-99999 S7
- ; Use S-1 for measurements only, without calculations. Use S4 for endstop heights and Z-height only. Use S6 for full 6 factors
- ; If your Z probe has significantly different trigger heights depending on XY position, adjust the H parameters in the G30 commands accordingly. The value of each H parameter should be (trigger height at that XY position) - (trigger height at centre of bed)
Advertisement
Add Comment
Please, Sign In to add comment