ReceptorRFarduino

#include <LiquidCrystal.h>
 #include <RCSwitch.h>

RCSwitch mySwitch = RCSwitch();
LiquidCrystal lcd(12, 11, 6, 5, 3, 4);
int ix;//velocidade loop e transmissao

void setup() {
  Serial.begin(9600);
lcd.begin(16, 2);
lcd.setCursor(3, 0);
 lcd.print("iniciando");
 Serial.println("iniciando");
  lcd.setCursor(1, 1);
 lcd.print("Esperando Dados");
delay(555);
ix=0;
 mySwitch.enableReceive(0);  // pino padrao 2
}

void loop() {

 if (mySwitch.available()) {
    ix=ix+1;
    int value = mySwitch.getReceivedValue();

 if (value == 0) {
      lcd.clear();
      lcd.print("Unknown encoding"); //vericando se existe receptor
      Serial.print("Unknown encoding");
    } else {
      lcd.clear();
       lcd.setCursor(11, 1);
       lcd.print("BT:");
      lcd.setCursor(0, 0);
      lcd.print("Taxa");
                  lcd.print(mySwitch.getReceivedValue());
                  lcd.setCursor(9, 0);
                  //getbits

                  lcd.print(mySwitch.getReceivedBitlength());
                  lcd.print( "bit:");
                  lcd.setCursor(0, 1);
                  lcd.print("CH:");
                  lcd.setCursor(3, 1);
                  lcd.print(mySwitch.getReceivedProtocol());
                  lcd.setCursor(5, 1);
                  lcd.print("VT:");
                  lcd.setCursor(8, 1);
                  lcd.print(ix);
                  if(ix==101){ix=0;}

          }

    if(value==110){//Codigo recebido do transmissor
     lcd.setCursor(14, 1);
     lcd.print("ON");
     }

    if(value==111){
     lcd.setCursor(14, 1);
      lcd.print("OF");
     }

 mySwitch.resetAvailable(); //reset!
   }
  }
bem10jfx.blogspot.com