U-Boot 2015.07-15072-g45cfc85 (Jan 28 2016 - 17:41:33 -0700), Build: jenkins-ub0

CPU:   Freescale i.MX6Q rev1.2 996 MHz (running at 792 MHz)
Reset cause: POR
Board: Nitrogen6_max
I2C:   ready
DRAM:  3.8 GiB
MMC:   FSL_SDHC: 0, FSL_SDHC: 1
SF: Detected SST25VF016B with page size 256 Bytes, erase size 4 KiB, total 2 MiB
Display: hdmi:1280x720M@60 (1280x720)
In:    serial
Out:   serial
Err:   serial
Net:   using phy at 6    +-----------------------------+
FEC [PRIME], usb_ether   |                             |
Hit any key to stop autob|  Cannot open /dev/ttyUSB0!  |
AHCI 0001.0300 32 slots 1|                             |e
flags: ncq stag pm led cl+-----------------------------+
No port device detected!
** Bad device size - sata 0 **
switch to partitions #0, OK
mmc0 is current device
5609 bytes read in 28 ms (195.3 KiB/s)
## Executing script at 10008000
** File not found uEnv.txt **
50006 bytes read in 1329 ms (36.1 KiB/s)
only CEA modes allowed on HDMI port
----------- trying to load /initrd.img
2942597 bytes read in 601 ms (4.7 MiB/s)
invalid extent block
invalid extent block
ext4fs_devread read outside partition 4294967120
** File not found /vmlinuz **
Error loading kernel image
switch to partitions #0, OK
mmc1(part 0) is current device
** No partition table - mmc 1 **
starting USB...
USB0:   Port not available.
USB1:   USB EHCI 1.00
scanning bus 1 for devices... 2 USB Device(s) found
       scanning usb for storage devices... 0 Storage Device(s) found
       scanning usb for ethernet devices... 0 Ethernet Device(s) found

USB device 0: unknown device
** Bad device usb 0 **

6x_bootscript not found

serial console at 115200, 8N1

details at http://boundarydevices.com/6q_bootscript
AHCI 0001.0300 32 slots 1 ports 3 Gbps 0x1 impl SATA mode
flags: ncq stag pm led clo only pmp pio slum part
No port device detected!
switch to partitions #0, OK
mmc0 is current device
expose mmc 0 over USB
UMS: disk start sector: 0x0, count: 0x780000
\