Kaitlin's E36 318

2015-11-16 20:49:54  ★ Richard Hawkins would walk over to the toolstationas he then bends down and pick up the toolbox.
2015-11-16 20:50:18  ★ Richard Hawkins would then stand back up and would then walk to the bmw.
2015-11-16 20:50:46  ★ Richard Hawkins would use his right hand to pull open the driverside door as he then bends down and pulls
2015-11-16 20:50:56  ★ on the lever to open the hood of the car.      ((Richard Hawkins))
2015-11-16 20:51:48  ★ Richard Hawkins would then walk to the front of the vehicle as he then sldies his fingers under the hood and
2015-11-16 20:51:59  ★ flicks a lever, releasing the hood.      ((Richard Hawkins))
2015-11-16 20:52:06  ★ Richard Hawkins would then lift the hood all the way up
2015-11-16 20:52:33  ★ Richard Hawkins would then walk to the side of the garage as he then picks up 4 plastic pads with
2015-11-16 20:52:45  ★ both of his hands , and starts to walk back to the car.      ((Richard Hawkins))
2015-11-16 20:52:59  ★ Richard Hawkins would then place one of the pads to each end of the skirt.
2015-11-16 20:53:18  ★ Richard Hawkins would then walk to the control panel of the lift as he then presse on the button with
2015-11-16 20:53:46  ★ his right hand and releases it as soon as the all four wheels are off the ground.      ((Richard Hawkins))
2015-11-16 20:54:23  ★ Richard Hawkins would then walk over to the toolbox as he then bends down and takes out the breaker bar.
2015-11-16 20:54:36  ★ Richard Hawkins would then take out a 19mm socket for it aswell.
2015-11-16 20:55:12  ★ Richard Hawkins would then connect the two as he then uses the breaker bar to loosen all 5 wheelnuts.
2015-11-16 20:56:00  ★ Richard Hawkins would then place the breaker bar down onto the lift, next to him and  removes all wheelnuts
2015-11-16 20:56:08  ★ by hand and places them into his pocket.      ((Richard Hawkins))
2015-11-16 20:56:33  ★ Richard Hawkins would then grab ahold of the wheel as he then lifts it away from the wheelhub.
2015-11-16 20:57:10  ★ Richard Hawkins would then place the wheel onto the groun, next to him and lowers it down onto the side of
2015-11-16 20:57:11  ★ it.      ((Richard Hawkins))
2015-11-16 20:57:31  ★ Richard Hawkins would then reach for the toolbox as he then takes out a socket wrench and a 13mm socket.
2015-11-16 20:57:57  ★ Richard Hawkins would then start to loosen up and remove the two bolts connecting the shock absorber to
2015-11-16 20:58:07  ★ the sway bar rear end link.      ((Richard Hawkins))
2015-11-16 20:58:30  ★ Richard Hawkins would then remove the sway bar as he then places it onto the ground next to him.
2015-11-16 20:58:49  ★ Richard Hawkins would then use the same socket wrench to loosen up and remove the bolts connecting the
2015-11-16 20:59:03  ★ shockabsorber to the fron steering knuckle.      ((Richard Hawkins))
2015-11-16 20:59:46  ★ Richard Hawkins would then place the two bolts and the two nuts into his pocket as he then stands up.
2015-11-16 21:00:25  ★ Richard Hawkins would then start to remove the nuts holding the shockabsorber against the chassis.
2015-11-16 21:01:10  ★ Richard Hawkins would use the socket wrench to three of the 13mm nuts and places them into his pocket.
2015-11-16 21:01:40  ★ Richard Hawkins would then crouch back down.
2015-11-16 21:02:02  ★ Richard Hawkins would then press down the front steering knuckle as he tries to wiggle the
2015-11-16 21:02:11  ★ coilover out of the wheelhub.      ((Richard Hawkins))
2015-11-16 21:02:38  ★ as he gets ahold of the coilover , he would walk to the toolstation.      ((Richard Hawkins))
2015-11-16 21:03:03  ★ Richard Hawkins places the coilover onto the table as he then walks to the cardboard box, containing the new
2015-11-16 21:03:07  ★ set of coils.      ((Richard Hawkins))
2015-11-16 21:03:37  ★ Richard Hawkins would open one of the boxes and takes out the coilover with both of his hands.
2015-11-16 21:04:11  ★ Richard Hawkins would then compare the two before taking the new one to the car.
2015-11-16 21:07:27  ★ Richard Hawkins would then walk over to the front of the car as he then crouches down.
2015-11-16 21:08:01  ★ Richard Hawkins would then attempt to slide the coilover into the line with the holes on top , before he
2015-11-16 21:08:11  ★ rests it onto the steering knuckle.      ((Richard Hawkins))
2015-11-16 21:08:34  ★ Richard Hawkins would then stand up, as he then starts to tighten the three 13mm nuts .
2015-11-16 21:08:53  ★ after doing so he would then crouch back down.      ((Richard Hawkins))
2015-11-16 21:09:21  ★ Richard Hawkins would then press down the steering knuckle as he then slides the coilover into the place.
2015-11-16 21:09:38  ★ Richard Hawkins would then digg into his pocket and takes out 2 bolts and nuts.
2015-11-16 21:10:06  ★ Richard Hawkins would then slide the bolts through the steering knuckle and screwes on the bolts to the end
2015-11-16 21:10:14  ★ end of thos, with his left hand.      ((Richard Hawkins))
2015-11-16 21:10:34  ★ Richard Hawkins would then use the socket wrench with the 13mm socket to tighten the nuts as hard as he can.
2015-11-16 21:11:25  ★ Richard Hawkins would then stand up and walk to the toolstation.
2015-11-16 21:11:47  ★ Richard Hawkins would then reach for a cardboard box which was in the cardboard box.
2015-11-16 21:11:56  ★ Richard Hawkins would take it out as he then opens it.
2015-11-16 21:12:21  ★ Richard Hawkins would take out new sway bar end link as he then throws the carboard box away and -
2015-11-16 21:12:39  ★ walks back to the car with the swaybar end link in his hand.      ((Richard Hawkins))
2015-11-16 21:13:05  ★ Richard Hawkins would then crouch down as he then connects the sway bar end link.
2015-11-16 21:13:25  ★ Richard Hawkins would then dig into his pocket and take sout two nuts  for the sway bar end link.
2015-11-16 21:13:49  ★ Richard Hawkins would then tighten the nuts by using the socket wrench with the 13mm socket.
2015-11-16 21:14:20  ★ after doing taht, he would reach for the special key, before he starts to set the      ((Richard Hawkins))
2015-11-16 21:14:29  ★ height of the coilover.      ((Richard Hawkins))
2015-11-16 21:14:48  ★ Richard Hawkins would twist it as long as it is set to the lowest setting.
2015-11-16 21:15:25  ★ Richard Hawkins would then reach wor the wheel as he grabs it with both of his hands and lifts it to wheelhu
2015-11-16 21:15:31  ★ -b.      ((Richard Hawkins))
2015-11-16 21:16:08  ★ Richard Hawkins would then hold onto the wheel with his left hand as he hand tightens the wheelnuts.
2015-11-16 21:16:26  ★ Richard Hawkins would then reach for the toolbox as he then reaches for the torque bar.
2015-11-16 21:16:56  ★ Richard Hawkins would then disconnect the 19mm socket from the breaker bar and then connects it to
2015-11-16 21:17:04  ★ the torque bar.      ((Richard Hawkins))
2015-11-16 21:17:21  ★ Richard Hawkins would then use it to tighten the nuts to about 115N:M
2015-11-16 21:17:40  ★ Richard Hawkins would then move on to the next wheel.
2015-11-16 21:17:56  ★ Richard Hawkins would repera the same actions until he ahs changed all coilovers.
2015-11-16 21:18:15  ★ Richard Hawkins would then start to collect all his tools and places them into the toolbox.
2015-11-16 21:18:32  ★ Richard Hawkins would then bend down as he then picks up the toolbox with his right hand.
2015-11-16 21:18:50  ★ Richard Hawkins would thenwalk over to the toolstation and places the toolbox next to it.
2015-11-16 21:19:02  ★ Richard Hawkins would then walk over to the lift control panel.
2015-11-16 21:19:14  ★ Richard Hawkins would press on the button as he lowers the car onto the ground.
2015-11-16 21:19:25  ★ Richard Hawkins would then release the button .
2015-11-16 21:19:49  ★ Richard Hawkins would then walk around the car as  he bends down and picks up the plastic pads.
2015-11-16 21:20:21  ★ Richard Hawkins would then take the plastic pads tot he toolstation and places them down.
2015-11-16 21:20:39  ★ Richard Hawkins would then walk ove rot the sink as he washes his hands.
2015-11-16 21:20:57  ★ Richard Hawkins would then walk back to the car as he then closes the hood.