$ sudo client/oibc
Client connected: !<filename>[@<address>] to send a file, ~<filename>[@<address>]:<len> to receive a file
---------------------------------------------------------------------------------------------------------
USB state change: 0 -> 0
EP 0: 2
EP 1: 2
EP 2: 2
EP 3: 2
EP 4: 2
EP 5: 2
USB state change: 0 -> 1
syrah_quiesce()
otf clock divisor: 5
fps set to: 59.976
SFN: 0x600, Addr: 0xfd00000, Size: 0x14001e0, hspan: 0x500, QLEN: 0x140
usb: reset detected
USB state change: 1 -> 1
syrah_init() -- Hurray for displays
usb: reset detected
USB state change: 1 -> 1
Syrah Panel ID (0xb1d11b):
   Build:          UNKNOWN
   Type:           SHARP
   Project/Driver: N45/Novatek-6.x
Writing LCD init registers...
changing to continuous calibration modeusb: reset detected
USB state change: 1 -> 1
syrah_init success!
Installing gamma table 0x0000d110 / 0x0000ff70
USB state change: 1 -> 3
NOR vendor=bf, device=273f
Successfully loaded bank1 nvram
Successfully loaded bank2 nvram
USB state change: 3 -> 4
menu: images loaded
nand: Probing flash controller...
nand: DEVICE: 2555d5ec
nand: BANKS_TOTAL: 4
nand: BLOCKS_PER_BANK: 8192
nand: SUBLKS_TOTAL: 8192
nand: USER_SUBLKS_TOTAL: 7744
nand: PAGES_PER_SUBLK: 512
nand: PAGES_PER_BANK: 1048576
nand: SECTORS_PER_PAGE: 4
nand: BYTES_PER_SPARE: 64
nand: BYTES_PER_PAGE: 2048
ftl: no signature or production format.
ftl: setting refresh_page to TRUE due to the following factors: Data->field_2F = 3, ret = 18446744071562199040
ftl: _AddLbnToRefreshList (0x0, 0x0)
ftl: ECC error, ECC mark is: ff
ftl: lbn 0x0 pLog->wVbn 0x0 dataVbn 0x0 offset 0x0 vpn 0x0
ftl: USER_DATA_ERROR, failed with (0x0, 0x1, 0x938b0)
-----------------------------------------------
              WELCOME TO OPENIBOOT
-----------------------------------------------
                    DEBUG MODE