View difference between Paste ID: <a href="/fb3PS1U9">fb3PS1U9</a> and <a href="/9VxWiNpn">9VxWiNpn</a>

########################creality_cr10_pla_#2####################################
1		########################creality_cr10_pla_#2####################################
2		[general]
3		version = 4
4		name = PLA #2
5		definition = fdmprinter
6
7		[metadata]
8		type = quality_changes
9		setting_version = 4
10		quality_type = draft
11
12		[values]
13		adaptive_layer_height_enabled = True
14		adhesion_type = raft
15		layer_height_0 = 0.26
16		material_bed_temperature = 50
17		support_enable = True
18
19		#####################fdmextruder_#2_pla_#2######################################
20		[general]
21		version = 4
22		name = PLA #2
23		definition = fdmprinter
24
25		[metadata]
26		type = quality_changes
27		setting_version = 4
28		position = 0
29		quality_type = draft
30
31		[values]
32		acceleration_print = 450
33		acceleration_travel = 4500
34		bottom_layers = 6
35		infill_sparse_density = 15
36		infill_sparse_thickness = 0.2
37		infill_wipe_dist = 0.2
38		ironing_enabled = True
39		jerk_print = 10
40		jerk_travel = 20
41		material_print_temperature = 200
42		material_print_temperature_layer_0 = 200
43		optimize_wall_printing_order = True
44		retract_at_layer_change = True
45		retraction_amount = 7
46		retraction_extra_prime_amount = 0.005
47		retraction_hop = 0.8
48		retraction_hop_enabled = True
49		retraction_hop_only_when_collides = True
50		retraction_min_travel = 0.4
51		retraction_speed = 60
52		skirt_line_count = 2
53		speed_layer_0 = =speed_print * 30 / 60
54		speed_print = 55
55		speed_print_layer_0 = 20
56		speed_topbottom = =speed_print / 2
57		speed_travel_layer_0 = 30
58		speed_wall = =speed_print / 2
59		support_angle = 80
60		support_infill_rate = 5
61		top_bottom_pattern = zigzag
62		top_bottom_thickness = 0.6
63		top_layers = 6
64		wall_thickness = 0.8