View difference between Paste ID: dY3YYbah and 5QWh6WeY

 local laser = peripheral.find("warpdriveLaser")
 local mininglasers = {}
 local sides = peripheral.getNames()
 local zeroBlockCount = 0
 
 for _, side in pairs(sides) do
   if peripheral.getType(side) == "warpdriveMiningLaser" then
     table.insert(mininglasers, peripheral.wrap(side))
   end
 end
 
 laser.beamFrequency(1420)
 
 if not laser then
   print("No warpdriveLaser detected")
   os.exit()
 end
 
 if #mininglasers == 0 then
   print("No warpdriveMiningLaser detected")
   os.exit()
 end
 
 print("Press the 'M' key to emit a laser scan and start the mining lasers with calculated layer offset.")
 
 -- Loop to wait for key events
 while true do
   -- Wait for a key event
   local event, key = os.pullEvent("key")
 
   -- Check if the "M" key was pressed (key code 50)
   if key == 50 then
     -- Get the laser's own position
     local _, laserY, _ = laser.getLocalPosition()
 
     -- Emit a laser scan in the Y- direction (0, -1, 0)
     laser.emitBeam(0, -1, 0)
 
     -- Get the scan result
     local _, _, targetY = laser.getScanResult()
 
     -- Calculate the layerOffset
     local mineTarget = laserY - targetY - 1
 
     -- Print the target
     print("Target is: " .. mineTarget .. " blocks below")
 
     -- Configure the mining lasers to use the mineTarget as the layerOffset
     for _, mininglaser in pairs(mininglasers) do
       mininglaser.offset(mineTarget)
       mininglaser.enable(true)
     end
 
     repeat
       local areActive = false
       for _, mininglaser in pairs(mininglasers) do
         local _, isActive, _, _, _, total = mininglaser.state()
 
         if total == 0 then
           zeroBlockCount = zeroBlockCount + 1
         else
           zeroBlockCount = 0
         end
 
         if zeroBlockCount >= 3 then
           print("3 consecutive layers with 0 total blocks detected. Stopping mining.")
           for _, mininglaser in pairs(mininglasers) do
                shell.run("stop")
           end
           break
         end
 
         if isActive then
           areActive = true
         end
       end
       os.sleep(1)
     until not areActive or zeroBlockCount >= 3
 
     -- Reset zeroBlockCount for the next mining session
     zeroBlockCount = 0
   end
 end