Create a new version of paste:

OpenWrt kernel loader for AR7XXX/AR9XXX
Copyright (C) 2011 Gabor Juhos <juhosg@openwrt.org>
Decompressing kernel... done!
Starting kernel at 80060000...

[    0.000000] Linux version 4.4.89 (giuseppe@vaio) (gcc version 5.4.0 (LEDE GCC 5.4.0 r4940-00e9a7aacb66) ) #0 Fri Sep 29 10:32:44 2017
[    0.000000] bootconsole [early0] enabled
[    0.000000] CPU0 revision is: 00019750 (MIPS 74Kc)
[    0.000000] SoC: Qualcomm Atheros QCA9556 ver 1 rev 0
[    0.000000] Determined physical RAM map:
[    0.000000]  memory: 04000000 @ 00000000 (usable)
[    0.000000] User-defined physical RAM map:
[    0.000000]  memory: 04000000 @ 00000000 (usable)
[    0.000000] Initrd not found or empty - disabling initrd
[    0.000000] No valid device tree found, continuing without
[    0.000000] Zone ranges:
[    0.000000]   Normal   [mem 0x0000000000000000-0x0000000003ffffff]
[    0.000000] Movable zone start for each node
[    0.000000] Early memory node ranges
[    0.000000]   node   0: [mem 0x0000000000000000-0x0000000003ffffff]
[    0.000000] Initmem setup node 0 [mem 0x0000000000000000-0x0000000003ffffff]
[    0.000000] Primary instruction cache 64kB, VIPT, 4-way, linesize 32 bytes.
[    0.000000] Primary data cache 32kB, 4-way, VIPT, cache aliases, linesize 32 bytes
[    0.000000] Built 1 zonelists in Zone order, mobility grouping on.  Total pages: 16256
[    0.000000] Kernel command line: no-uart no-nand parts=1 boot_part_size=16777216 gpio=537917997 HZ=360000000 mem=64M kmac=E4:8D:8C:BE:15:FB board=wapg-sc Board=wapg-sc hw_opt=00684001 boot=0 mlc=10 console=ttyS0,115200 rootfstype=squashfs noinitrd
[    0.000000] PID hash table entries: 256 (order: -2, 1024 bytes)
[    0.000000] Dentry cache hash table entries: 8192 (order: 3, 32768 bytes)
[    0.000000] Inode-cache hash table entries: 4096 (order: 2, 16384 bytes)
[    0.000000] Writing ErrCtl register=00000000
[    0.000000] Readback ErrCtl register=00000000
[    0.000000] Memory: 57544K/65536K available (3317K kernel code, 167K rwdata, 816K rodata, 2476K init, 198K bss, 7992K reserved, 0K cma-reserved)
[    0.000000] SLUB: HWalign=32, Order=0-3, MinObjects=0, CPUs=1, Nodes=1
[    0.000000] NR_IRQS:51
[    0.000000] Clocks: CPU:720.000MHz, DDR:600.000MHz, AHB:240.000MHz, Ref:40.000MHz
[    0.000000] clocksource: MIPS: mask: 0xffffffff max_cycles: 0xffffffff, max_idle_ns: 5309056796 ns
[    0.000007] sched_clock: 32 bits at 360MHz, resolution 2ns, wraps every 5965232126ns
[    0.008678] Calibrating delay loop... 358.80 BogoMIPS (lpj=1794048)
[    0.071709] pid_max: default: 32768 minimum: 301
[    0.076945] Mount-cache hash table entries: 1024 (order: 0, 4096 bytes)
[    0.084324] Mountpoint-cache hash table entries: 1024 (order: 0, 4096 bytes)
[    0.094391] clocksource: jiffies: mask: 0xffffffff max_cycles: 0xffffffff, max_idle_ns: 19112604462750000 ns
[    0.105370] futex hash table entries: 256 (order: -1, 3072 bytes)
[    0.112783] NET: Registered protocol family 16
[    0.121564] MIPS: machine is MikroTik RouterBOARD wAP G-5HacT2HnD
[    0.357756] clocksource: Switched to clocksource MIPS
[    0.364543] NET: Registered protocol family 2
[    0.370078] TCP established hash table entries: 1024 (order: 0, 4096 bytes)
[    0.377895] TCP bind hash table entries: 1024 (order: 0, 4096 bytes)
[    0.384990] TCP: Hash tables configured (established 1024 bind 1024)
[    0.392160] UDP hash table entries: 256 (order: 0, 4096 bytes)
[    0.398704] UDP-Lite hash table entries: 256 (order: 0, 4096 bytes)
[    0.405921] NET: Registered protocol family 1
[    2.682710] Crashlog allocated RAM at address 0x3f00000
[    2.700631] squashfs: version 4.0 (2009/01/31) Phillip Lougher
[    2.707138] jffs2: version 2.2 (NAND) (SUMMARY) (LZMA) (RTIME) (CMODE_PRIORITY) (c) 2001-2006 Red Hat, Inc.
[    2.767616] io scheduler noop registered
[    2.772040] io scheduler deadline registered (default)
[    2.778004] Serial: 8250/16550 driver, 1 ports, IRQ sharing disabled
[    2.785444] console [ttyS0] disabled
[    2.809503] serial8250.0: ttyS0 at MMIO 0x18020000 (irq = 11, base_baud = 2500000) is a 16550A
[    2.819126] console [ttyS0] enabled
[    2.819126] console [ttyS0] enabled
[    2.826531] bootconsole [early0] disabled
[    2.826531] bootconsole [early0] disabled
[    2.837710] m25p80 spi0.0: found w25q128, expected m25p80
[    2.843247] m25p80 spi0.0: w25q128 (16384 Kbytes)
[    2.848033] Creating 6 MTD partitions on "spi0.0":
[    2.852897] 0x000000000000-0x00000000e000 : "routerboot"
[    2.860397] 0x00000000e000-0x00000000f000 : "hard_config"
[    2.867273] 0x00000000f000-0x000000010000 : "bios"
[    2.873512] 0x000000010000-0x00000001f000 : "routerboot2"
[    2.880403] 0x00000001f000-0x000000020000 : "soft_config"
[    2.887237] 0x000000020000-0x000001000000 : "firmware"
[    2.947538] libphy: GPIO Bitbanged MDIO: probed
[    3.618462] ag71xx ag71xx.1: connected to PHY at gpio-1:00 [uid=004dd074, driver=Atheros 8031/8033 ethernet]
[    3.629029] eth0: Atheros AG71xx at 0xba000000, irq 5, mode:SGMII
[    3.636632] NET: Registered protocol family 10
[    3.643908] NET: Registered protocol family 17
[    3.648537] bridge: automatic filtering via arp/ip/ip6tables has been deprecated. Update your scripts to load br_netfilter if you need this.
[    3.661454] 8021q: 802.1Q VLAN Support v1.8
[    3.681639] Freeing unused kernel memory: 2476K
[    3.697709] init: Console is alive
[    3.701422] init: - watchdog -
[    3.716801] kmodloader: loading kernel modules from /etc/modules-boot.d/*
[    3.725922] kmodloader: done loading kernel modules from /etc/modules-boot.d/*
[    3.735863] init: - preinit -
[    3.871923] IPv6: ADDRCONF(NETDEV_UP): eth0: link is not ready
Press the [f] key and hit [enter] to enter failsafe mode
Press the [1], [2], [3] or [4] key and hit [enter] to select the debug level
[    7.004852] procd: - early -
[    7.008474] procd: - watchdog -
[    7.549752] procd: - watchdog -
[    7.553168] procd: - ubus -
[    7.562167] random: ubusd: uninitialized urandom read (4 bytes read, 12 bits of entropy available)
[    7.606315] random: ubusd: uninitialized urandom read (4 bytes read, 12 bits of entropy available)
[    7.615898] random: ubusd: uninitialized urandom read (4 bytes read, 12 bits of entropy available)
[    7.625134] random: ubusd: uninitialized urandom read (4 bytes read, 12 bits of entropy available)
[    7.634503] random: ubusd: uninitialized urandom read (4 bytes read, 12 bits of entropy available)
[    7.643668] random: ubusd: uninitialized urandom read (4 bytes read, 12 bits of entropy available)
[    7.652987] random: ubusd: uninitialized urandom read (4 bytes read, 12 bits of entropy available)
[    7.662289] random: ubusd: uninitialized urandom read (4 bytes read, 12 bits of entropy available)
[    7.671795] procd: - init -
Please press Enter to activate this console.
[    7.810800] kmodloader: loading kernel modules from /etc/modules.d/*
[    7.820910] ip6_tables: (C) 2000-2006 Netfilter Core Team
[    7.834903] Loading modules backported from Linux version wt-2017-01-31-0-ge882dff19e7f
[    7.843076] Backport generated by backports.git backports-20160324-13-g24da7d3c
[    7.921570] ip_tables: (C) 2000-2006 Netfilter Core Team
[    7.934012] nf_conntrack version 0.5.0 (937 buckets, 3748 max)
[    7.980300] xt_time: kernel timezone is -0000
[    7.996240] PPP generic driver version 2.4.2
[    8.002724] NET: Registered protocol family 24
[    8.043487] ieee80211 phy0: Atheros AR9550 Rev:0 mem=0xb8100000, irq=47


BusyBox v1.27.2 () built-in shell (ash)

     _________
    /        /\      _    ___ ___  ___
   /  LE    /  \    | |  | __|   \| __|
  /    DE  /    \   | |__| _|| |) | _|
 /________/  LE  \  |____|___|___/|___|                      lede-project.org
 \        \   DE /
  \    LE  \    /  -----------------------------------------------------------
   \  DE    \  /    Reboot (SNAPSHOT, r4940+10-00e9a7aacb66)
    \________\/    -----------------------------------------------------------

[    8.130022] kmodloader: done loading kernel modules from /etc/modules.d/*
=== WARNING! =====================================
There is no root password defined on this device!
Use the "passwd" command to set up a new password
in order to prevent unauthorized SSH logins.
--------------------------------------------------
root@(none):/#