Create a new version of paste:

diff --git a/sys/arch/evbmips/rasoc/machdep.c b/sys/arch/evbmips/rasoc/machdep.c
index 6cb688d..e85b81f 100644
--- a/sys/arch/evbmips/rasoc/machdep.c
+++ b/sys/arch/evbmips/rasoc/machdep.c
@@ -163,7 +163,7 @@ mach_init(void)
 	 * Determine the memory size.
 	 */
 #if defined(MT7620)
-	memsize = 128 << 20;
+	memsize = 64 << 20;
 #else
 	memsize = *(volatile uint32_t *)
 	    MIPS_PHYS_TO_KSEG1(RA_SYSCTL_BASE + RA_SYSCTL_CFG0);
diff --git a/sys/arch/mips/ralink/ralink_eth.c b/sys/arch/mips/ralink/ralink_eth.c
index 855a712..afe8375 100644
--- a/sys/arch/mips/ralink/ralink_eth.c
+++ b/sys/arch/mips/ralink/ralink_eth.c
@@ -1635,7 +1635,7 @@ ralink_eth_mii_read(device_t self, int phy_addr, int phy_reg)
 		if ((sw_read(sc, RA_ETH_SW_PCTL1) & PCTL1_RD_DONE) == 0)
 			break;
 #else
-		if ((fe_read(sc, RA_FE_MDIO_ACCESS) & MDIO_ACCESS_TRG) == 0)
+		if ((fe_read(sc, 0x7004) & MDIO_ACCESS_TRG) == 0)
 			break;
 #endif
 	}
@@ -1664,7 +1664,7 @@ ralink_eth_mii_read(device_t self, int phy_addr, int phy_reg)
 			return data;
 		}
 #else
-		if ((fe_read(sc, RA_FE_MDIO_ACCESS) & MDIO_ACCESS_TRG) == 0) {
+		if ((fe_read(sc, 0x7004) & MDIO_ACCESS_TRG) == 0) {
 			int data = MDIO_ACCESS_DATA(
 				fe_read(sc, RA_FE_MDIO_ACCESS));
 			ralink_eth_mdio_enable(sc, false);
@@ -1697,7 +1697,7 @@ ralink_eth_mii_write(device_t self, int phy_addr, int phy_reg, int val)
 		if ((sw_read(sc, RA_ETH_SW_PCTL1) & PCTL1_RD_DONE) == 0)
 			break;
 #else
-		if ((fe_read(sc, RA_FE_MDIO_ACCESS) & MDIO_ACCESS_TRG) == 0)
+		if ((fe_read(sc, 0x7004) & MDIO_ACCESS_TRG) == 0)
 			break;
 #endif
 	}
@@ -1725,7 +1725,7 @@ ralink_eth_mii_write(device_t self, int phy_addr, int phy_reg, int val)
 			return;
 		}
 #else
-		if ((fe_read(sc, RA_FE_MDIO_ACCESS) & MDIO_ACCESS_TRG) == 0){
+		if ((fe_read(sc, 0x7004) & MDIO_ACCESS_TRG) == 0){
 			ralink_eth_mdio_enable(sc, false);
 			return;
 		}

----

## Booting image at 80a00000 ...
   Image Name:   evbmips 7.99.27 (ZYXELKX)
   Image Type:   MIPS NetBSD Kernel Image (uncompressed)
   Data Size:    3538832 Bytes =  3.4 MB
   Load Address: 80010000
   Entry Point:  80010000
   Verifying Checksum ... OK
OK
No initrd
## Transferring control to Linux (at address 80010000) ...
## Giving linux memsize in MB, 64

Starting kernel ...

MIPS32/64 params: cpu arch: 128
MIPS32/64 params: TLB entries: 32
MIPS32/64 params: Icache: line = 32, total = 65536, ways = 4
		 sets = 512
MIPS32/64 params: Dcache: line = 32, total = 32768, ways = 4
		 sets = 256
  picache_stride    = 4096
  picache_loopcount = 16
mips_fixup_stubs: 5561 fixups done in 6657172 cycles
phys segment: 0x4000000 @ 0
adding 0xf000 @ 0x1000 to freelist 0
adding 0x3c72000 @ 0x38e000 to freelist 0
pmap_steal_memory: seg 0: 0x1 0x1 0x10 0x10
pmap_steal_memory: seg 0: too small for 34 pages
pmap_steal_memory: seg 1: 0x38e 0x38e 0x3fff 0x3fff
pmap_steal_memory: seg 0: 0x1 0x1 0x10 0x10
Enabled early console
pmap_steal_memory: seg 0: 0x3 0x3 0x10 0x10
pmap_steal_memory: seg 0: too small for 297 pages
pmap_steal_memory: seg 1: 0x3b0 0x3b0 0x3fff 0x3fff
Loaded initial symtab at 0x80317454, strtab at 0x80342c34, # entries 10572
Copyright (c) 1996, 1997, 1998, 1999, 2000, 2001, 2002, 2003, 2004, 2005,
    2006, 2007, 2008, 2009, 2010, 2011, 2012, 2013, 2014, 2015, 2016
    The NetBSD Foundation, Inc.  All rights reserved.
Copyright (c) 1982, 1986, 1989, 1991, 1993
    The Regents of the University of California.  All rights reserved.

NetBSD 7.99.27 (ZYXELKX) #0: Sun Apr 17 07:48:24 UTC 2016
	fun@ubuntu:/home/fun/netbsd-src/sys/arch/evbmips/compile/obj/ZYXELKX
MT7620
total memory = 65536 KB
avail memory = 60572 KB
mainbus0 (root): Mediatek MT7620 System Bus
cpu0 at mainbus0: 580.00MHz (hz cycles = 2900000, delay divisor = 290)
cpu0: MIPS 24KE (0x19650) Rev. 80 with software emulated floating point
cpu0: 32 TLB entries, 256MB max page size
cpu0: 64KB/32B 4-way set-associative L1 instruction cache
cpu0: 32KB/32B 4-way set-associative write-back L1 data cache
rwdog0 at mainbus0: Ralink watchdog controller
rwdog0: max period 22 sec.
rwdog0: KTICKLE mode, period 10 sec.
rgpio0 at mainbus0: Ralink GPIO controller
gpio0 at rgpio0: 98 pins
ri2c0 at mainbus0: Ralink I2C controller
iic0 at ri2c0: I2C bus
com0 at mainbus0: Au1X00 UART, working fifo
com0: console
ohci0 at mainbus0: OHCI USB controller
ohci0: OHCI version 1.0, legacy support
usb0 at ohci0: USB revision 1.0
ehci0 at mainbus0: EHCI USB controller
ehci0: companion ohci0
ehci0: companion controller, 1 port each: ohci0
usb1 at ehci0: USB revision 2.0
reth0 at mainbus0: Ralink Ethernet
rpci0 at mainbus0: Ralink PCIe Controller
uhub0 at usb0: Ralink OHCI root hub, class 9/0, rev 1.00/1.00, addr 1
uhub1 at usb1: Ralink EHCI root hub, class 9/0, rev 2.00/1.00, addr 1
uhub2 at uhub1 port 1: vendor 058f product 6254, class 9/0, rev 2.00/1.00, addr 2
uhub2: single transaction translator
umass0 at uhub2 port 1 configuration 1 interface 0
umass0: Generic Flash Card Reader/Writer, rev 2.00/1.00, addr 3
scsibus0 at umass0: 2 targets, 2 luns per target
sd0 at scsibus0 target 0 lun 0: <Generic-, Multiple Reader, 1.07> disk removable
sd0: drive offline
sd1 at scsibus0 target 0 lun 1: <Generic-, MicroSD/M2, 1.08> disk removable
sd1: drive offline
uhub0: device problem, disabling port 1
root device: