Bluetooth Data rev_13

/********* Pleasedontcode.com **********

    Pleasedontcode thanks you for automatic code generation! Enjoy your code!

    - Terms and Conditions:
    You have a non-exclusive, revocable, worldwide, royalty-free license
    for personal and commercial use. Attribution is optional; modifications
    are allowed, but you're responsible for code maintenance. We're not
    liable for any loss or damage. For full terms,
    please visit pleasedontcode.com/termsandconditions.

    - Project: Bluetooth Data
    - Source Code NOT compiled for: Arduino Mega
    - Source Code created on: 2025-07-11 21:53:39

********* Pleasedontcode.com **********/

/****** SYSTEM REQUIREMENTS *****/
/****** SYSTEM REQUIREMENT 1 *****/
    /* send data from bluetooth to android */
/****** END SYSTEM REQUIREMENTS *****/

/* START CODE */

/****** DEFINITION OF LIBRARIES *****/
// Include Bluetooth Serial library if needed
#include <SoftwareSerial.h> // Assuming Bluetooth module uses SoftwareSerial

/****** FUNCTION PROTOTYPES *****/
void setup(void);
void loop(void);
float T_interpolate(byte DS_Temp); // Prototype for the interpolation function

// Define pins for Bluetooth module
const int BluetoothRxPin = 10; // Example pin, change as needed
const int BluetoothTxPin = 11; // Example pin, change as needed

// Instantiate SoftwareSerial for Bluetooth communication
SoftwareSerial BluetoothSerial(BluetoothRxPin, BluetoothTxPin);

void setup()
{
  // **** I/O configuration and setup first
  pinMode(ALDLTestPin, INPUT);                                              // define D4 as an input pin to listen for the 160 baud input data
  pinMode(DecodeDataOutputPin, INPUT_PULLUP);                                // User convenience pin.  Grounding this pin will send Decoded Data to the Serial Port
  pinMode(HexDataOutputPin, INPUT_PULLUP);                                   // User convenience pin.  Grounding this pin will send HEX Data to the Serial Port

  // Initialize serial communication
  Serial.begin(115200);                                                     // Open serial monitoring port
  Serial1.begin(8192);                                                      // Test the capability of esp 8222 to run at 8192 baud directly

  // Initialize Bluetooth serial
  BluetoothSerial.begin(9600); // Set baud rate for Bluetooth communication

  delay(1500);                                                              // delay for diagnostic print
  Serial.println("Ready for data capture");
  // **** Initialize the variables, flags, etc
  i=0;                                                                      // Reset the preamble index flag
}

void loop() {
  // Existing code for data capture and processing...

  // After processing data, send data over Bluetooth
  // Example: Send a simple message or the processed data
  String btData = "Processed Data: RPM=" + String(RPM) + " TPS=" + String(TPS);
  BluetoothSerial.println(btData);

  // Rest of the loop code...
}