[  187.850728] ===========================gslx680_ts_init=====================
[  187.859288] _fetch_sysconfig_para.
[  187.862277] gslx680 firmware gslx680.fw.
[  187.871406] _fetch_sysconfig_para: after: ctp_twi_addr is 0x40, dirty_addr_buf: 0x40. dirty_addr_buf[1]: 0xfffe
[  187.882095] _fetch_sysconfig_para: ctp_twi_id is 1.
[  187.886298] _fetch_sysconfig_para: screen_max_x = 800.
[  187.891018] _fetch_sysconfig_para: screen_max_y = 480.
[  187.895112] _fetch_sysconfig_para: revert_x_flag = 1.
[  187.899213] _fetch_sysconfig_para: revert_y_flag = 0.
[  187.904018] _fetch_sysconfig_para: exchange_x_y_flag = 0.
[  187.913172] i2c-core: driver [gslx680] using legacy suspend method
[  187.918228] i2c-core: driver [gslx680] using legacy resume method
[  187.924434] ctp_detect: Detected chip gslx680 at adapter 1, address 0x40
[  187.930203] ====gslx680_ts_probe begin=====.
[  187.932247] ==kzalloc success=
[  187.935039] [GSLX680] Enter gsl_ts_init_ts
[  187.939230] ctp_set_irq_mode: config gpio to int mode.
[  187.953321] ctp_set_irq_mode, 850: gpio_int_info, port = 7, port_num = 11.
[  187.955252]  INTERRUPT CONFIG
[  187.966179] input: gslx680 as /devices/platform/sunxi-i2c.1/i2c-1/1-0040/input/input4
[  188.080735] =============gsl_load_fw start==============
[  190.107050] =============gsl_load_fw end==============
[  190.419141] ==gslx680_ts_probe over =