[    0.457175] rockchip-usb2phy ff770000.syscon:usb2-phy@e450: failed to create phy
[    0.459516] rockchip-usb2phy ff770000.syscon:usb2-phy@e460: failed to create phy
[    0.468846] rockchip-pcie f8000000.pcie: no vpcie12v regulator found
[    0.469573] rockchip-pcie f8000000.pcie: no vpcie3v3 regulator found
[    0.470347] rockchip-pcie f8000000.pcie: no vpcie1v8 regulator found
[    0.471160] rockchip-pcie f8000000.pcie: no vpcie0v9 regulator found
[    0.994419] rockchip-pcie f8000000.pcie: PCIe link training gen1 timeout!
[    0.995357] rockchip-pcie: probe of f8000000.pcie failed with error -110
[    0.999833] dma-pl330 ff6d0000.dma-controller: Loaded driver for PL330 DMAC-241330
[    1.000601] dma-pl330 ff6d0000.dma-controller:       DBUFF-32x8bytes Num_Chans-6 Num_Peri-12 Num_Events-12
[    1.004072] dma-pl330 ff6e0000.dma-controller: Loaded driver for PL330 DMAC-241330
[    1.004873] dma-pl330 ff6e0000.dma-controller:       DBUFF-128x8bytes Num_Chans-8 Num_Peri-20 Num_Events-16
[    1.006744] Serial: 8250/16550 driver, 5 ports, IRQ sharing disabled
[    1.010861] ff180000.serial: ttyS0 at MMIO 0xff180000 (irq = 37, base_baud = 1500000) is a 16550A
[    1.013287] ff1a0000.serial: ttyS2 at MMIO 0xff1a0000 (irq = 38, base_baud = 1500000) is a 16550A
[    1.014694] console [ttyS2] enabled
[    1.014694] console [ttyS2] enabled
[    1.015417] bootconsole [uart8250] disabled
[    1.015417] bootconsole [uart8250] disabled
[    1.028373] rockchip-drm display-subsystem: bound ff8f0000.vop (ops 0xffffff800871afd8)
[    1.030488] rockchip-drm display-subsystem: bound ff900000.vop (ops 0xffffff800871afd8)
[    1.031635] rockchip-drm display-subsystem: failed to bind ff940000.hdmi (ops 0xffffff800871cbb8): -517
[    1.033330] rockchip-drm display-subsystem: master bind failed: -517
[    1.035278] cacheinfo: Unable to detect cache hierarchy for CPU 0
[    1.044931] loop: module loaded
[    1.045506] lkdtm: No crash points registered, enable through debugfs
[    1.048528] libphy: Fixed MDIO Bus: probed
[    1.050724] rk_gmac-dwmac fe300000.ethernet: PTP uses main clock
[    1.051470] rk_gmac-dwmac fe300000.ethernet: phy regulator is not available yet, deferred probing
[    1.054354] usbcore: registered new interface driver asix
[    1.054972] usbcore: registered new interface driver ax88179_178a
[    1.055600] usbcore: registered new interface driver cdc_ether
[    1.058236] dwc3 fe800000.dwc3: Configuration mismatch. dr_mode forced to host
[    1.058978] dwc3 fe800000.dwc3: failed to initialize core
[    1.060992] dwc3 fe900000.dwc3: failed to initialize core
[    1.064205] ehci_hcd: USB 2.0 'Enhanced' Host Controller (EHCI) Driver
[    1.064869] ehci-pci: EHCI PCI platform driver
[    1.065373] ehci-platform: EHCI generic platform driver
[    1.066952] ohci_hcd: USB 1.1 'Open' Host Controller (OHCI) Driver
[    1.067538] ohci-platform: OHCI generic platform driver
[    1.070817] i2c /dev entries driver
[    1.073197] rk3x-i2c ff110000.i2c: Initialized RK3xxx I2C bus at ffffff8008b63000
[    1.075169] rk3x-i2c ff130000.i2c: Initialized RK3xxx I2C bus at ffffff8008b65000
[    1.078086] rk808 0-001b: chip id: 0x0
[    1.088408] rk808-regulator rk808-regulator: there is no dvs0 gpio
[    1.089219] rk808-regulator rk808-regulator: there is no dvs1 gpio
[    1.098088] vcc2v8_dvp: Bringing 3000000uV into 2800000-2800000uV
[    1.125581] rk808-rtc rk808-rtc: rtc core: registered rk808-rtc as rtc0
[    1.127918] fan53555-regulator 0-0040: FAN53555 Option[8] Rev[1] Detected!
[    1.132965] Internal error: undefined instruction: 0 [#1] PREEMPT SMP