3Ds1

Question: How to select the interface language of the program being installed?Answer: No way. The program is installed immediately as a multilingual program. Shortcuts to launch the program in each of the supported languages ​​can be found in the "Start" menu.

Question: What about Russian? Why is there no Russian interface?!Answer: This program has never had a Russian interface.

Question: What is the program's medicine?Answer: The medicine included in the assembly is based on a hacked network licensing mechanism (NLM) from the MAGNiTUDE hack group. And the author of the assembly wrapped it all in a convenient shell, allowing you to apply the medicine in one click, and slightly supplemented it with his "bells and whistles".

Question: What is the compatibility of the medicine used in the assembly with other Autodesk programs?Answer: As for the 2026 line, the medicine is compatible with most popular Autodesk programs, the release of which had already taken place at the time of the release of the assembly. As for compatibility with programs of younger lines, such compatibility is also available. Installing this program will kill the activation of products of the 2020-2025 lines. But this activator will cure them again! The only thing is that if the 2020-2021 products were activated by a keygen, the activation format will change to network. Activation of products of the 2019 lines and below will not be affected in any way.

Question: I need the Autodesk Access module to exchange data with Autodesk servers. How do I install it?Answer: Run ..\x64\Access\AdAccess-installer.exe from the distribution. After installation is complete, reboot your computer - everything will work. I would especially like to draw your attention to the fact that you need to install it after using the medicine, since it forcibly "jams" Autodesk Access!

Question: The program does not install. A message appears about preparing for installation, which closes after a couple of seconds and the installation stops. What's wrong?Answer: The problem is with compatibility of different versions of the installer. Follow [the instructions](https://www.autodesk.com/support/technical/article/caas/sfdcarticles/sfdcarticles/Error-2-The-system-cannot-find-the-file-specified-when-starting-Autodesk-Access-Service-Host.html) from the Autodesk website. Do not look at the fact that it is for solving another problem - the method will work in this case too.

Question: The program does not install. An error message of the 400x series appears. What should I do?Answer: First, [read](https://www.autodesk.com/support/technical/article/caas/sfdcarticles/sfdcarticles/Troubleshooting-Tips-for-AdIX-Package-Installation.html) the decoding of error codes and brief recommendations for solving problems installing Autodesk products. If this does not help, then you can only find out the causes of the problem yourself by reading the installation logs. Autodesk has [a utility](https://www.autodesk.com/support/technical/article/caas/sfdcarticles/sfdcarticles/How-to-Use-the-Log-Collection-Tool.html) that competently collects the necessary logs scattered across different folders of the operating system.