U-Boot 2016.03 (Sep 09 2016 - 15:01:05 -0700)

Model: Digilent-Zybo-Linux-BD-v2015.4
Board: Xilinx Zynq
I2C:   ready
DRAM:  ECC disabled 512 MiB
MMC:   sdhci@e0100000: 0
SF: Detected S25FL128S_64K with page size 256 Bytes, erase size 64 KiB, total 16 MiB
*** Warning - bad CRC, using default environment

In:    serial
Out:   serial
Err:   serial
Net:   ZYNQ GEM: e000b000, phyaddr 1, interface rgmii-id

Warning: ethernet@e000b000 using MAC address from ROM
eth0: ethernet@e000b000
U-BOOT for Digilent-Zybo-Linux-BD-v2015_4

ethernet@e000b000 Waiting for PHY auto negotiation to complete......... TIMEOUT !
ethernet@e000b000: No link.
Hit any key to stop autoboot:  0
Device: sdhci@e0100000
Manufacturer ID: 1b
OEM: 534d
Name: 00000
Tran Speed: 50000000
Rd Block Len: 512
SD version 3.0
High Capacity: Yes
Capacity: 29.8 GiB
Bus Width: 4-bit
Erase Group Size: 512 Bytes
reading image.ub
6437376 bytes read in 553 ms (11.1 MiB/s)
## Loading kernel from FIT Image at 04000000 ...
   Using 'conf@1' configuration
   Verifying Hash Integrity ... OK
   Trying 'kernel@1' kernel subimage
     Description:  PetaLinux Kernel
     Type:         Kernel Image
     Compression:  gzip compressed
     Data Start:   0x040000f0
     Data Size:    6410590 Bytes = 6.1 MiB
     Architecture: ARM
     OS:           Linux
     Load Address: 0x00008000
     Entry Point:  0x00008000
     Hash algo:    crc32
     Hash value:   46f48392
   Verifying Hash Integrity ... crc32+ OK
## Loading fdt from FIT Image at 04000000 ...
   Using 'conf@1' configuration
   Trying 'fdt@1' fdt subimage
     Description:  Flattened Device Tree blob
     Type:         Flat Device Tree
     Compression:  uncompressed
     Data Start:   0x0461d334
     Data Size:    25488 Bytes = 24.9 KiB
     Architecture: ARM
     Hash algo:    crc32
     Hash value:   bcb15942
   Verifying Hash Integrity ... crc32+ OK
   Booting using the fdt blob at 0x461d334
   Uncompressing Kernel Image ... OK
   Loading Device Tree to 07ff6000, end 07fff38f ... OK

Starting kernel ...

Booting Linux on physical CPU 0x0
Linux version 4.0.0-xilinx (zynq@Zynq) (gcc version 4.9.2 (Sourcery CodeBench Lite 2015.05-17) ) #8 SMP PREEMPT Fri Sep 9 15:01:27 PDT 2016
CPU: ARMv7 Processor [413fc090] revision 0 (ARMv7), cr=18c5387d
CPU: PIPT / VIPT nonaliasing data cache, VIPT aliasing instruction cache
Machine model: Digilent-Zybo-Linux-BD-v2015.4
bootconsole [earlycon0] enabled
cma: Reserved 40 MiB at 0x1d800000
Memory policy: Data cache writealloc
PERCPU: Embedded 11 pages/cpu @dd3bc000 s12672 r8192 d24192 u45056
Built 1 zonelists in Zone order, mobility grouping on.  Total pages: 130048
Kernel command line: console=ttyPS0,115200 earlyprintk
PID hash table entries: 2048 (order: 1, 8192 bytes)
Dentry cache hash table entries: 65536 (order: 6, 262144 bytes)
Inode-cache hash table entries: 32768 (order: 5, 131072 bytes)
Memory: 468548K/524288K available (4767K kernel code, 223K rwdata, 1720K rodata, 3044K init, 208K bss, 14780K reserved, 40960K cma-reserved, 0K highmem)
Virtual kernel memory layout:
    vector  : 0xffff0000 - 0xffff1000   (   4 kB)
    fixmap  : 0xffc00000 - 0xfff00000   (3072 kB)
    vmalloc : 0xe0800000 - 0xff000000   ( 488 MB)
    lowmem  : 0xc0000000 - 0xe0000000   ( 512 MB)
    pkmap   : 0xbfe00000 - 0xc0000000   (   2 MB)
    modules : 0xbf000000 - 0xbfe00000   (  14 MB)
      .text : 0xc0008000 - 0xc065e0dc   (6489 kB)
      .init : 0xc065f000 - 0xc0958000   (3044 kB)
      .data : 0xc0958000 - 0xc098ff60   ( 224 kB)
       .bss : 0xc098ff60 - 0xc09c42f4   ( 209 kB)
Preemptible hierarchical RCU implementation.
        Additional per-CPU info printed with stalls.
        RCU restricting CPUs from NR_CPUS=4 to nr_cpu_ids=2.
RCU: Adjusting geometry for rcu_fanout_leaf=16, nr_cpu_ids=2
NR_IRQS:16 nr_irqs:16 16
L2C: platform modifies aux control register: 0x72360000 -> 0x72760000
L2C: DT/platform modifies aux control register: 0x72360000 -> 0x72760000
L2C-310 erratum 769419 enabled
L2C-310 enabling early BRESP for Cortex-A9
L2C-310 full line of zeros enabled for Cortex-A9
L2C-310 ID prefetch enabled, offset 1 lines
L2C-310 dynamic clock gating enabled, standby mode enabled
L2C-310 cache controller enabled, 8 ways, 512 kB
L2C-310: CACHE_ID 0x410000c8, AUX_CTRL 0x76760001
slcr mapped to e0804000
zynq_clock_init: clkc starts at e0804100
Zynq clock init
sched_clock: 64 bits at 325MHz, resolution 3ns, wraps every 3383112499200ns
timer #0 at e0808000, irq=17
Console: colour dummy device 80x30
Calibrating delay loop... 1292.69 BogoMIPS (lpj=6463488)
pid_max: default: 32768 minimum: 301
Mount-cache hash table entries: 1024 (order: 0, 4096 bytes)
Mountpoint-cache hash table entries: 1024 (order: 0, 4096 bytes)
CPU: Testing write buffer coherency: ok
CPU0: thread -1, cpu 0, socket 0, mpidr 80000000
Setting up static identity map for 0x4836d8 - 0x483730
CPU1: thread -1, cpu 1, socket 0, mpidr 80000001
Brought up 2 CPUs
SMP: Total of 2 processors activated (2591.94 BogoMIPS).
CPU: All CPU(s) started in SVC mode.
devtmpfs: initialized
VFP support v0.3: implementor 41 architecture 3 part 30 variant 9 rev 4
pinctrl core: initialized pinctrl subsystem
NET: Registered protocol family 16
DMA: preallocated 256 KiB pool for atomic coherent allocations
cpuidle: using governor ladder
cpuidle: using governor menu
hw-breakpoint: found 5 (+1 reserved) breakpoint and 1 watchpoint registers.
hw-breakpoint: maximum watchpoint size is 4 bytes.
zynq-ocm f800c000.ocmc: ZYNQ OCM pool: 256 KiB @ 0xe0880000
GPIO IRQ not connected
XGpio: /amba_pl/gpio@41210000: registered, base is 902
XGpio: /amba_pl/gpio@41230000: registered, base is 901
GPIO IRQ not connected
XGpio: /amba_pl/gpio@41250000: registered, base is 899
GPIO IRQ not connected
XGpio: /amba_pl/gpio@41250000: dual channel registered, base is 897
GPIO IRQ not connected
XGpio: /amba_pl/gpio@41200000: registered, base is 893
GPIO IRQ not connected
XGpio: /amba_pl/gpio@41260000: registered, base is 889
GPIO IRQ not connected
XGpio: /amba_pl/gpio@41220000: registered, base is 885
GPIO IRQ not connected
XGpio: /amba_pl/gpio@41240000: registered, base is 883
GPIO IRQ not connected
XGpio: /amba_pl/gpio@41240000: dual channel registered, base is 879
vgaarb: loaded
SCSI subsystem initialized
usbcore: registered new interface driver usbfs
usbcore: registered new interface driver hub
usbcore: registered new device driver usb
usb_phy@0 supply vcc not found, using dummy regulator
media: Linux media interface: v0.10
Linux video capture interface: v2.00
pps_core: LinuxPPS API ver. 1 registered
pps_core: Software ver. 5.3.6 - Copyright 2005-2007 Rodolfo Giometti <giometti@linux.it>
PTP clock support registered
EDAC MC: Ver: 3.0.0
Advanced Linux Sound Architecture Driver Initialized.
Switched to clocksource arm_global_timer
NET: Registered protocol family 2
TCP established hash table entries: 4096 (order: 2, 16384 bytes)
TCP bind hash table entries: 4096 (order: 3, 32768 bytes)
TCP: Hash tables configured (established 4096 bind 4096)
TCP: reno registered
UDP hash table entries: 256 (order: 1, 8192 bytes)
UDP-Lite hash table entries: 256 (order: 1, 8192 bytes)
NET: Registered protocol family 1
RPC: Registered named UNIX socket transport module.
RPC: Registered udp transport module.
RPC: Registered tcp transport module.
RPC: Registered tcp NFSv4.1 backchannel transport module.
hw perfevents: enabled with armv7_cortex_a9 PMU driver, 7 counters available
futex hash table entries: 512 (order: 3, 32768 bytes)
jffs2: version 2.2. (NAND) (SUMMARY)  © 2001-2006 Red Hat, Inc.
io scheduler noop registered
io scheduler deadline registered
io scheduler cfq registered (default)
zynq-pinctrl 700.pinctrl: zynq pinctrl initialized
dma-pl330 f8003000.dmac: Loaded driver for PL330 DMAC-241330
dma-pl330 f8003000.dmac:        DBUFF-128x8bytes Num_Chans-8 Num_Peri-4 Num_Events-16
xilinx-vdma 43000000.dma: Xilinx AXI VDMA Engine Driver Probed!!
e0000000.serial: ttyPS0 at MMIO 0xe0000000 (irq = 145, base_baud = 6250000) is a xuartps
console [ttyPS0] enabled
bootconsole [earlycon0] disabled

Built with PetaLinux v2015.4 (Yocto 1.8) Digilent-Zybo-Linux-BD-v2015_4 /dev/ttyPS1
Digilent-Zybo-Linux-BD-v2015_4 login: