Advertisement
Not a member of Pastebin yet?
Sign Up,
it unlocks many cool features!
- [] Linux version 5.4.74 (ubuntu@ip-172-31-27-145) (gcc version 8.4.0 (OpenWrt GCC 8.4.0 r14868+13-dd651e54cc)) #0 Fri Dec 4 15:35:50 2020
- [] printk: bootconsole [early0] enabled
- [] CPU0 revision is: 00019374 (MIPS 24Kc)
- [] MIPS: machine is Jangala Get Box
- [] SoC: Qualcomm Atheros QCA9533 ver 2 rev 0
- [] Initrd not found or empty - disabling initrd
- [] Primary instruction cache 64kB, VIPT, 4-way, linesize 32 bytes.
- [] Primary data cache 32kB, 4-way, VIPT, cache aliases, linesize 32 bytes
- [] Zone ranges:
- [] Normal [mem 0x0000000000000000-0x0000000007ffffff]
- [] Movable zone start for each node
- [] Early memory node ranges
- [] node 0: [mem 0x0000000000000000-0x0000000007ffffff]
- [] Initmem setup node 0 [mem 0x0000000000000000-0x0000000007ffffff]
- [] Built 1 zonelists, mobility grouping on. Total pages: 32480
- [] Kernel command line: console=ttyS0,115200n8 rootfstype=squashfs,jffs2
- [] Dentry cache hash table entries: 16384 (order: 4, 65536 bytes, linear)
- [] Inode-cache hash table entries: 8192 (order: 3, 32768 bytes, linear)
- [] Writing ErrCtl register=00000000
- [] Readback ErrCtl register=00000000
- [] mem auto-init: stack:off, heap alloc:off, heap free:off
- [] Memory: 122196K/131072K available (4819K kernel code, 193K rwdata, 1112K rodata, 1228K init, 196K bss, 8876K reserved, 0K cma-reserved)
- [] SLUB: HWalign=32, Order=0-3, MinObjects=0, CPUs=1, Nodes=1
- [] NR_IRQS: 51
- [] random: get_random_bytes called from start_kernel+0x32c/0x518 with crng_init=0
- [] CPU clock: 650.000 MHz
- [] clocksource: MIPS: mask: 0xffffffff max_cycles: 0xffffffff, max_idle_ns: 5880801374 ns
- [] sched_clock: 32 bits at 325MHz, resolution 3ns, wraps every 6607641598ns
- [] Calibrating delay loop... 431.10 BogoMIPS (lpj=862208)
- [] pid_max: default: 32768 minimum: 301
- [] Mount-cache hash table entries: 1024 (order: 0, 4096 bytes, linear)
- [] Mountpoint-cache hash table entries: 1024 (order: 0, 4096 bytes, linear)
- [] clocksource: jiffies: mask: 0xffffffff max_cycles: 0xffffffff, max_idle_ns: 7645041785100000 ns
- [] futex hash table entries: 256 (order: -1, 3072 bytes, linear)
- [] pinctrl core: initialized pinctrl subsystem
- [] NET: Registered protocol family 16
- [] workqueue: max_active 576 requested for napi_workq is out of range, clamping between 1 and 512
- [] clocksource: Switched to clocksource MIPS
- [] NET: Registered protocol family 2
- [] tcp_listen_portaddr_hash hash table entries: 512 (order: 0, 4096 bytes, linear)
- [] TCP established hash table entries: 1024 (order: 0, 4096 bytes, linear)
- [] TCP bind hash table entries: 1024 (order: 0, 4096 bytes, linear)
- [] TCP: Hash tables configured (established 1024 bind 1024)
- [] UDP hash table entries: 256 (order: 0, 4096 bytes, linear)
- [] UDP-Lite hash table entries: 256 (order: 0, 4096 bytes, linear)
- [] NET: Registered protocol family 1
- [] PCI: CLS 0 bytes, default 32
- [] workingset: timestamp_bits=14 max_order=15 bucket_order=1
- [] squashfs: version 4.0 (2009/01/31) Phillip Lougher
- [] jffs2: version 2.2 (NAND) (SUMMARY) (LZMA) (RTIME) (CMODE_PRIORITY) (c) 2001-2006 Red Hat, Inc.
- [] pinctrl-single 1804002c.pinmux: 576 pins, size 72
- [] Serial: 8250/16550 driver, 1 ports, IRQ sharing disabled
- [] printk: console [ttyS0] disabled
- [] 18020000.uart: ttyS0 at MMIO 0x18020000 (irq = 9, base_baud = 1562500) is a 16550A
- [] printk: console [ttyS0] enabled
- [] printk: console [ttyS0] enabled
- [] printk: bootconsole [early0] disabled
- [] printk: bootconsole [early0] disabled
- [] spi-nor spi0.0: w25q128 (16384 Kbytes)
- [] 6 fixed-partitions partitions found on MTD device spi0.0
- [] Creating 6 MTD partitions on "spi0.0":
- [] 0x000000000000-0x000000040000 : "u-boot"
- [] 0x000000040000-0x000000050000 : "u-boot-env"
- [] 0x000000050000-0x000000800000 : "firmware"
- [] 2 uimage-fw partitions found on MTD device firmware
- [] Creating 2 MTD partitions on "firmware":
- [] 0x000000000000-0x0000001f0000 : "kernel"
- [] 0x0000001f0000-0x0000007b0000 : "rootfs"
- [] mtd: device 4 (rootfs) set to be root filesystem
- [] 1 squashfs-split partitions found on MTD device rootfs
- [] 0x000000710000-0x0000007b0000 : "rootfs_data"
- [] 0x000000800000-0x000000fb0000 : "firmware-b"
- [] 0x000000fb0000-0x000000ff0000 : "persist"
- [] 0x000000ff0000-0x000001000000 : "art"
- [] libphy: Fixed MDIO Bus: probed
- [] ag71xx 19000000.eth: Could not connect to PHY device. Deferring probe.
- [] random: fast init done
- [] libphy: ag71xx_mdio: probed
- [] libphy: ar8xxx-mdio: probed
- [] switch0: Atheros AR8229 rev. 1 switch registered on mdio.0
- [] ag71xx 1a000000.eth: connected to PHY at fixed-0:00 [uid=00000000, driver=Generic PHY]
- [] eth0: Atheros AG71xx at 0xba000000, irq 5, mode: gmii
- [] i2c /dev entries driver
- [] ath79-wdt 18060008.wdt: unable to register misc device, err=-16
- [] ath79-wdt: probe of 18060008.wdt failed with error -16
- [] NET: Registered protocol family 10
- [] Segment Routing with IPv6
- [] NET: Registered protocol family 17
- [] 8021q: 802.1Q VLAN Support v1.8
- [] PCI host bridge /ahb/pcie-controller@180c0000 ranges:
- [] MEM 0x0000000010000000..0x0000000013ffffff
- [] IO 0x0000000000000000..0x0000000000000000
- [] ar724x-pci 180c0000.pcie-controller: PCIe link is down
- [] PCI host bridge to bus 0000:00
- [] pci_bus 0000:00: root bus resource [mem 0x10000000-0x13ffffff]
- [] pci_bus 0000:00: root bus resource [io 0x0000]
- [] pci_bus 0000:00: root bus resource [??? 0x00000000 flags 0x0]
- [] pci_bus 0000:00: No busn resource found for root bus, will use [bus 00-ff]
- [] pci_bus 0000:00: busn_res: [bus 00-ff] end is updated to 00
- [] ag71xx 19000000.eth: connected to PHY at mdio.0:1f:04 [uid=004dd042, driver=Generic PHY]
- [] eth1: Atheros AG71xx at 0xb9000000, irq 4, mode: mii
- [] VFS: Mounted root (squashfs filesystem) readonly on device 31:4.
- [] Freeing unused kernel memory: 1228K
- [] This architecture does not have kernel memory protection.
- [] Run /sbin/init as init process
- [] init: Console is alive
- [] init: - watchdog -
- [] kmodloader: loading kernel modules from /etc/modules-boot.d/*
- [] usbcore: registered new interface driver usbfs
- [] usbcore: registered new interface driver hub
- [] usbcore: registered new device driver usb
- [] ehci_hcd: USB 2.0 'Enhanced' Host Controller (EHCI) Driver
- [] ehci-fsl: Freescale EHCI Host controller driver
- [] ehci-platform: EHCI generic platform driver
- [] ehci-platform 1b000000.usb: EHCI Host Controller
- [] ehci-platform 1b000000.usb: new USB bus registered, assigned bus number 1
- [] ehci-platform 1b000000.usb: irq 3, io mem 0x1b000000
- [] ehci-platform 1b000000.usb: USB 2.0 started, EHCI 1.00
- [] hub 1-0:1.0: USB hub found
- [] hub 1-0:1.0: 1 port detected
- [] kmodloader: done loading kernel modules from /etc/modules-boot.d/*
- [] init: - preinit -
- [] random: jshn: uninitialized urandom read (4 bytes read)
- [] random: jshn: uninitialized urandom read (4 bytes read)
- [] random: jshn: uninitialized urandom read (4 bytes read)
- [] urandom_read: 6 callbacks suppressed
- [] random: jshn: uninitialized urandom read (4 bytes read)
- [] eth0: link up (1000Mbps/Full duplex)
- [] IPv6: ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready
- Press the [f] key and hit [enter] to enter failsafe mode
- Press the [1], [2], [3] or [4] key and hit [enter] to select the debug level
- [] jffs2_scan_eraseblock(): End of filesystem marker found at 0x10000
- [] jffs2_build_filesystem(): unlocking the mtd device...
- [] done.
- [] jffs2_build_filesystem(): erasing all blocks after the end marker...
- [] done.
- [] jffs2: notice: (563) jffs2_build_xattr_subsystem: complete building xattr subsystem, 0 of xdatum (0 unchecked, 0 orphan) and 0 of xref (0 dead, 0 orphan) found.
- [] mount_root: overlay filesystem has not been fully initialized yet
- [] mount_root: switching to jffs2 overlay
- [] overlayfs: upper fs does not support tmpfile.
- - config restore -
- [] urandom-seed: Seed file not found (/etc/urandom.seed)
- [] eth0: link down
- [] procd: - early -
- [] procd: - watchdog -
- [] procd: - watchdog -
- [] procd: - ubus -
- Failed to connect to ubus
- [] procd: - init -
- Please press Enter to activate this console.
- [] kmodloader: loading kernel modules from /etc/modules.d/*
Advertisement
Add Comment
Please, Sign In to add comment
Advertisement