root@OpenWrt:/# dmesg
Linux version 2.6.32.10 (openwrt@wrt1.marcant.net) (gcc version 4.3.3 (GCC) ) #20 Tue Apr 6 15:01:26 CEST 2010
prom: fw_arg0=00000007, fw_arg1=a3f77fb0, fw_arg2=a3f78460, fw_arg3=00000008
MyLoader: sysp=aaaa5554, boardp=aaaa5554, parts=aaaa5554
bootconsole [early0] enabled
CPU revision is: 00019374 (MIPS 24Kc)
Atheros AR7161 rev 2, CPU:680.000 MHz, AHB:170.000 MHz, DDR:340.000 MHz
Determined physical RAM map:
 memory: 04000000 @ 00000000 (usable)
Initrd not found or empty - disabling initrd
Zone PFN ranges:
  Normal   0x00000000 -> 0x00004000
Movable zone start PFN for each node
early_node_map[1] active PFN ranges
    0: 0x00000000 -> 0x00004000
On node 0 totalpages: 16384
free_area_init_node: node 0, pgdat 802d0210, node_mem_map 81000000
  Normal zone: 128 pages used for memmap
  Normal zone: 0 pages reserved
  Normal zone: 16256 pages, LIFO batch:3
Built 1 zonelists in Zone order, mobility grouping on.  Total pages: 16256
Kernel command line: rootfstype=squashfs,yaffs,jffs2 noinitrd console=ttyS0,115200 board=DIR-825-B1 mtdparts=spi0.0:256k(uboot)r)
PID hash table entries: 256 (order: -2, 1024 bytes)
Dentry cache hash table entries: 8192 (order: 3, 32768 bytes)
Inode-cache hash table entries: 4096 (order: 2, 16384 bytes)
Primary instruction cache 64kB, VIPT, 4-way, linesize 32 bytes.
Primary data cache 32kB, 4-way, VIPT, cache aliases, linesize 32 bytes
Writing ErrCtl register=00000000
Readback ErrCtl register=00000000
Memory: 61748k/65536k available (2101k kernel code, 3716k reserved, 397k data, 152k init, 0k highmem)
SLUB: Genslabs=7, HWalign=32, Order=0-3, MinObjects=0, CPUs=1, Nodes=1
Hierarchical RCU implementation.
NR_IRQS:56
Calibrating delay loop... 452.19 BogoMIPS (lpj=2260992)
Mount-cache hash table entries: 512
NET: Registered protocol family 16
MIPS: machine is D-Link DIR-825 rev. B1
registering PCI controller with io_map_base unset
bio: create slab <bio-0> at 0
pci 0000:00:00.0: reg 10 32bit mmio pref: [0x000000-0xfffffff]
pci 0000:00:00.0: reg 14 io port: [0x00-0xff]
pci 0000:00:00.0: supports D1 D2
pci 0000:00:00.0: PME# supported from D0 D1 D2 D3hot
pci 0000:00:00.0: PME# disabled
PCI: fixup device 0000:00:11.0
pci 0000:00:11.0: reg 10 32bit mmio: [0x000000-0x00ffff]
pci 0000:00:11.0: PME# supported from D0 D3hot
pci 0000:00:11.0: PME# disabled
PCI: fixup device 0000:00:12.0
pci 0000:00:12.0: reg 10 32bit mmio: [0x000000-0x00ffff]
pci 0000:00:12.0: PME# supported from D0 D3hot
pci 0000:00:12.0: PME# disabled
PCI: mapping irq 48 to pin1@0000:00:11.0
PCI: mapping irq 49 to pin1@0000:00:12.0
Switching to clocksource MIPS
NET: Registered protocol family 2
IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
TCP established hash table entries: 2048 (order: 2, 16384 bytes)
TCP bind hash table entries: 2048 (order: 1, 8192 bytes)
TCP: Hash tables configured (established 2048 bind 2048)
TCP reno registered
NET: Registered protocol family 1
squashfs: version 4.0 (2009/01/31) Phillip Lougher
Registering mini_fo version $Id$
JFFS2 version 2.2. (NAND) (SUMMARY)  �© 2001-2006 Red Hat, Inc.
yaffs Mar 28 2010 17:53:41 Installing.
msgmni has been set to 120
io scheduler noop registered
io scheduler deadline registered (default)
Serial: 8250/16550 driver, 1 ports, IRQ sharing disabled
serial8250.0: ttyS0 at MMIO 0x18020000 (irq = 11) is a 16550A
console [ttyS0] enabled, bootconsole disabled
Atheros AR71xx SPI Controller driver version 0.2.4
m25p80 spi0.0: m25p64 (8192 Kbytes)
7 cmdlinepart partitions found on MTD device spi0.0
Creating 7 MTD partitions on "spi0.0":
0x000000000000-0x000000040000 : "uboot"
0x000000040000-0x000000050000 : "config"
0x000000050000-0x000000150000 : "kernel"
0x000000150000-0x000000660000 : "rootfs"
mtd: partition "rootfs" set to be root filesystem
mtd: partition "rootfs_data" created automatically, ofs=290000, len=3D0000
0x000000290000-0x000000660000 : "rootfs_data"
0x000000660000-0x000000670000 : "caldata"
0x000000670000-0x000000800000 : "unknown"
0x000000050000-0x000000660000 : "firmware"
Realtek RTL8366S ethernet switch driver version 0.2.1
rtl8366s rtl8366s: using GPIO pins 5 (SDA) and 7 (SCK)
rtl8366s rtl8366s: RTL8366 ver. 1 chip found
rtl8366-rtl: probed
ag71xx_mdio: probed
eth0: Atheros AG71xx at 0xb9000000, irq 4
eth0: using fixed link parameters
eth1: Atheros AG71xx at 0xba000000, irq 5
eth1: connected to PHY at rtl8366s:04 [uid=001cc960, driver=Realtek RTL8366S]
Atheros AR71xx hardware watchdog driver version 0.1.0
ar71xx-wdt: timeout=15 secs (max=25)
TCP westwood registered
NET: Registered protocol family 17
802.1Q VLAN Support v1.8 Ben Greear <greearb@candelatech.com>
All bugs added by David S. Miller <davem@redhat.com>
VFS: Mounted root (squashfs filesystem) readonly on device 31:3.
Freeing unused kernel memory: 152k freed
Please be patient, while OpenWrt loads ...
gpio-buttons driver version 0.1.2
input: gpio-buttons as /devices/platform/gpio-buttons/input/input0
Button Hotplug driver version 0.3.1
ar71xx: pll_reg 0xb8050010: 0x11110000
eth0: link up (1000Mbps/Full duplex)
Registered led device: dir825b1:blue:usb
Registered led device: dir825b1:orange:power
Registered led device: dir825b1:blue:power
Registered led device: dir825b1:blue:powersave
Registered led device: dir825b1:orange:planet
Registered led device: dir825b1:blue:planet
mini_fo: using base directory: /
mini_fo: using storage directory: /overlay
eth0: link down
ar71xx: pll_reg 0xb8050010: 0x11110000
eth0: link up (1000Mbps/Full duplex)
device eth0.1 entered promiscuous mode
device eth0 entered promiscuous mode
br-lan: port 1(eth0.1) entering forwarding state
PPP generic driver version 2.4.2
ip_tables: (C) 2000-2006 Netfilter Core Team
NET: Registered protocol family 24
nf_conntrack version 0.5.0 (968 buckets, 3872 max)
CONFIG_NF_CT_ACCT is deprecated and will be removed soon. Please use
nf_conntrack.acct=1 kernel parameter, acct=1 nf_conntrack module option or
sysctl net.netfilter.nf_conntrack_acct=1 to enable it.
ar71xx-wdt: enabling watchdog timer
root@OpenWrt:/#