HP 735/125 9000

(c) Copyright.  Hewlett-Packard Company.  1992.
All rights reserved.

PDC ROM rev. 2.7
IODC ROM rev. 1.1
208 MB of memory configured and tested.


Selecting a system to boot.
To stop selection process, press and hold the ESCAPE key......

Selection process stopped.

Searching for Potential Boot Devices.
To terminate search, press and hold the ESCAPE key.

b)    Boot from specified device
s)    Search for bootable devices
a)    Enter Boot Administration mode
x)    Exit and continue boot sequence
?)    Help

Select from menu: s

Searching for Devices with Bootable Media.
To terminate search, press and hold the ESCAPE key.

Device Selection      Device Path              Device Type and Utilities
----------------------------------------------------------------------------

P0                    scsi.0.0                  codesrc         CDROM
                                                   IPL


Enter boot selection, (h)elp, or e(x)it: P0

Trying scsi.0.0
Boot path initialized.
Attempting to load IPL.


Hard booted.

ISL Revision A.00.38  OCT 26, 1994

ISL booting  hpux (;0):INSTALL

Boot
: disk(2/0/1.0.0.0.0.0.0;0):INSTALL
3462652 + 315392 + 305120 start 0x1b82e8
vuseg=1390000

    System Console is on the Built-In Serial Interface
Networking memory for fragment reassembly is restricted to 19382272 bytes
    Swap device table:  (start & size given in 512-byte blocks)
        entry 0 - auto-configured on root device; ignored - no room
WARNING: No dump device configured.  Dump is disabled.
Warning: time-of-day register time is out-of-range

Getting time from file system
Starting the STREAMS daemons.
    B2352B HP-UX (B.10.20) #1: Fri Jun  7 09:26:45 PDT 1996

Memory Information:
    physical page size = 4096 bytes, logical page size = 4096 bytes
    Physical: 212992 Kbytes, lockable: 159384 Kbytes, available: 183484 Kbytes

=======  HP-UX Installation Initialization. (Mon Jun 10 02:54:18 EDT 1996)
         @(#) install/init (opt) $Revision: 5.30 $
       * EISA configuration has completed.  Following the completion of a
         successful HP-UX installation, please check the "/etc/eisa/config.err"
         file for any EISA configuration messages.
       * Scanning system for IO devices...