Openocd/Raspberrypi2_native

#
	# Config for using Raspberry Pi's expansion header
	#
	# This is best used with a fast enough buffer but also
	# is suitable for direct connection if the target voltage
	# matches RPi's 3.3V and the cable is short enough.
	#
	# Do not forget the GND connection, pin 6 of the expansion header.
	#

	adapter driver bcm2835gpio

	bcm2835gpio_peripheral_base 0x3F000000

	# Transition delay calculation: SPEED_COEFF/khz - SPEED_OFFSET
	# These depend on system clock, calibrated for stock 700MHz
	# bcm2835gpio_speed SPEED_COEFF SPEED_OFFSET
	bcm2835gpio_speed_coeffs 146203 36

	# Each of the JTAG lines need a gpio number set: tck tms tdi tdo
	# Header pin numbers: 23 22 19 21
	bcm2835gpio_jtag_nums 11 25 10 9

	# Each of the SWD lines need a gpio number set: swclk swdio
	# Header pin numbers: 26 24
	bcm2835gpio_swd_nums 7 8

	# If you define trst or srst, use appropriate reset_config
	# Header pin numbers: TRST - 26, SRST - 18



	# bcm2835gpio_trst_num 7
	# reset_config trst_only

 	bcm2835gpio_srst_num 10
 	reset_config srst_only srst_push_pull


	# or if you have both connected,
	# reset_config trst_and_srst srst_push_pull