Advertisement
Not a member of Pastebin yet?
Sign Up,
it unlocks many cool features!
- ########## wireless info START ##########
- Report from: 29 Aug 2014 07:33 CDT -0500
- Script from: 17 Aug 2014 02:46 UTC +0000
- ##### release #####
- Distributor ID: LinuxMint
- Description: Linux Mint 13 Maya
- Release: 13
- Codename: maya
- ##### kernel #####
- Linux 3.2.0-23-generic #36-Ubuntu SMP Tue Apr 10 20:41:14 UTC 2012 i686 i686 i386 GNU/Linux
- Parameters: ro, quiet, splash, vt.handoff=7
- ##### desktop #####
- default.desktop
- ##### lspci #####
- 01:08.0 Ethernet controller [0200]: Intel Corporation 82562EZ 10/100 Ethernet Controller [8086:1050] (rev 02)
- Subsystem: Dell Dimension 3000 [1028:019d]
- Kernel driver in use: e100
- ##### lsusb #####
- Bus 001 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub
- Bus 002 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub
- Bus 003 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub
- Bus 004 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub
- Bus 001 Device 002: ID 2001:3301 D-Link Corp. DWA-130 802.11n Wireless N Adapter(rev.C1) [Realtek RTL8192U]
- ##### PCMCIA card info #####
- ##### rfkill #####
- ##### lsmod #####
- r8192u_usb 248351 0
- ##### interfaces #####
- auto lo
- iface lo inet loopback
- ##### ifconfig #####
- eth0 Link encap:Ethernet HWaddr <MAC addr eth0>
- inet addr:192.168.1.23 Bcast:192.168.1.255 Mask:255.255.255.0
- inet6 addr: fe80::213:20ff:fe07:1863/64 Scope:Link
- UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
- RX packets:179 errors:0 dropped:0 overruns:0 frame:0
- TX packets:282 errors:0 dropped:0 overruns:0 carrier:0
- collisions:0 txqueuelen:1000
- RX bytes:103295 (103.2 KB) TX bytes:34375 (34.3 KB)
- ##### iwconfig #####
- lo no wireless extensions.
- eth0 no wireless extensions.
- wlan0 802.11b/g/n Mode:Managed Access Point: Not-Associated
- Bit Rate:1 Mb/s
- Retry min limit:7 RTS thr:off Fragment thr:off
- Power Management:off
- Link Quality=0/100 Signal level=0 dBm Noise level=0 dBm
- Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
- Tx excessive retries:0 Invalid misc:0 Missed beacon:0
- ##### route #####
- Kernel IP routing table
- Destination Gateway Genmask Flags Metric Ref Use Iface
- 0.0.0.0 192.168.1.3 0.0.0.0 UG 0 0 0 eth0
- 169.254.0.0 0.0.0.0 255.255.0.0 U 1000 0 0 eth0
- 192.168.1.0 0.0.0.0 255.255.255.0 U 1 0 0 eth0
- ##### resolv.conf #####
- domain hsd1.tx.comcast.net.
- search hsd1.tx.comcast.net.
- nameserver 68.87.69.146
- nameserver 75.75.76.76
- nameserver 75.75.75.75
- ##### nm-tool #####
- NetworkManager Tool
- State: connected (global)
- - Device: wlan0 ----------------------------------------------------------------
- Type: 802.11 WiFi
- Driver: rtl819xU
- State: unavailable
- Default: no
- HW Address: <MAC address>
- Capabilities:
- Wireless Properties
- WEP Encryption: yes
- WPA Encryption: yes
- WPA2 Encryption: yes
- Wireless Access Points
- - Device: eth0 [Wired connection 1] -------------------------------------------
- Type: Wired
- Driver: e100
- State: connected
- Default: yes
- HW Address: <MAC addr eth0>
- Capabilities:
- Carrier Detect: yes
- Speed: 100 Mb/s
- Wired Properties
- Carrier: on
- IPv4 Settings:
- Address: 192.168.1.23
- Prefix: 24 (255.255.255.0)
- Gateway: 192.168.1.3
- DNS: 68.87.69.146
- DNS: 75.75.76.76
- DNS: 75.75.75.75
- ##### NetworkManager.state #####
- [main]
- NetworkingEnabled=true
- WirelessEnabled=true
- WWANEnabled=true
- WimaxEnabled=true
- ##### NetworkManager.conf #####
- [main]
- plugins=ifupdown,keyfile
- dns=dnsmasq
- [ifupdown]
- managed=false
- ##### iw reg get #####
- nl80211 not found.
- ##### iwlist channels #####
- lo no frequency information.
- eth0 no frequency information.
- wlan0 11 channels in total; available frequencies :
- Channel 01 : 2.412 GHz
- Channel 02 : 2.417 GHz
- Channel 03 : 2.422 GHz
- Channel 04 : 2.427 GHz
- Channel 05 : 2.432 GHz
- Channel 06 : 2.437 GHz
- Channel 07 : 2.442 GHz
- Channel 08 : 2.447 GHz
- Channel 09 : 2.452 GHz
- Channel 10 : 2.457 GHz
- Channel 11 : 2.462 GHz
- ##### iwlist scan #####
- lo Interface doesn't support scanning.
- wlan0 Interface doesn't support scanning : Network is down
- eth0 Interface doesn't support scanning.
- ##### module infos #####
- [r8192u_usb]
- filename: /lib/modules/3.2.0-23-generic/kernel/drivers/staging/rtl8192u/r8192u_usb.ko
- description: Linux driver for Realtek RTL8192 USB WiFi cards
- version: V 1.1
- license: GPL
- firmware: RTL8192U/data.img
- firmware: RTL8192U/main.img
- firmware: RTL8192U/boot.img
- license: GPL
- description: HostAP crypto
- author: Jouni Malinen
- license: GPL
- description: Host AP crypt: TKIP
- author: Jouni Malinen
- license: GPL
- description: Host AP crypt: CCMP
- author: Jouni Malinen
- license: GPL
- description: Host AP crypt: WEP
- author: Jouni Malinen
- license: GPL
- author: Copyright (C) 2004 Intel Corporation <jketreno@linux.intel.com>
- description: 802.11 data/management/control stack
- srcversion: CBD0699D19E4573A143D13E
- depends:
- staging: Y
- intree: Y
- vermagic: 3.2.0-23-generic SMP mod_unload modversions 686
- parm: debug:debug output mask (int)
- parm: ifname: Net interface name, wlan%d=default (charp)
- parm: hwwep: Try to use hardware security support. (int)
- parm: channels: Channel bitmask for specific locales. NYI (int)
- ##### module parameters #####
- [r8192u_usb]
- channels: 16383
- debug: -2147483648
- hwwep: 1
- ifname: wlan%d
- ##### /etc/modules #####
- lp
- ##### blacklists #####
- [/etc/modprobe.d/blacklist-ath_pci.conf]
- blacklist ath_pci
- [/etc/modprobe.d/blacklist.conf]
- blacklist evbug
- blacklist usbmouse
- blacklist usbkbd
- blacklist eepro100
- blacklist de4x5
- blacklist eth1394
- blacklist snd_intel8x0m
- blacklist snd_aw2
- blacklist i2c_i801
- blacklist prism54
- blacklist bcm43xx
- blacklist garmin_gps
- blacklist asus_acpi
- blacklist snd_pcsp
- blacklist pcspkr
- blacklist amd76x_edac
- ##### udev rules #####
- [/etc/udev/rules.d/70-persistent-net.rules]
- # USB device 0x2001:0x3301 (usb)
- SUBSYSTEM=="net", ACTION=="add", DRIVERS=="?*", ATTR{address}=="<MAC address>", ATTR{dev_id}=="0x0", ATTR{type}=="1", KERNEL=="wlan*", NAME="wlan0"
- # PCI device 0x8086:/sys/devices/pci0000:00/0000:00:1e.0/0000:01:08.0 (e100)
- SUBSYSTEM=="net", ACTION=="add", DRIVERS=="?*", ATTR{address}=="<MAC addr eth0>", ATTR{dev_id}=="0x0", ATTR{type}=="1", KERNEL=="eth*", NAME="eth0"
- ##### dmesg #####
- [ 1.567211] e100: Intel(R) PRO/100 Network Driver, 3.5.24-k2-NAPI
- [ 17.860270] intel_rng: don't want to disable this in firmware setup, and if
- [ 18.256674] r8192u_usb: module is from the staging directory, the quality is unknown, you have been warned.
- [ 20.634402] rtl819xU:request firmware fail!
- [ 20.634409] rtl819xU:ERR in init_firmware()
- [ 20.634413] rtl819xU:ERR!!! rtl8192_adapter_start(): Firmware download is failed
- [ 20.634418] rtl819xU:ERR!!! _rtl8192_up(): initialization is failed!
- [ 20.634575] ADDRCONF(NETDEV_UP): wlan0: link is not ready
- [ 20.912997] rtl819xU:request firmware fail!
- [ 20.913004] rtl819xU:ERR in init_firmware()
- [ 20.913008] rtl819xU:ERR!!! rtl8192_adapter_start(): Firmware download is failed
- [ 20.913013] rtl819xU:ERR!!! _rtl8192_up(): initialization is failed!
- ########## wireless info END ############
Advertisement
Add Comment
Please, Sign In to add comment
Advertisement