Advertisement
Not a member of Pastebin yet?
Sign Up,
it unlocks many cool features!
- # generated by PrusaSlicer 2.0.0+linux64 on 2019-06-18 at 23:01:19
- bed_temperature = 70
- bridge_fan_speed = 100
- compatible_printers =
- compatible_printers_condition =
- compatible_prints =
- compatible_prints_condition =
- cooling = 1
- disable_fan_first_layers = 3
- end_filament_gcode = "; Filament-specific end gcode \n;END gcode for filament\n"
- extrusion_multiplier = 1
- fan_always_on = 0
- fan_below_layer_time = 60
- filament_colour = #29B2B2
- filament_cooling_final_speed = 3.4
- filament_cooling_initial_speed = 2.2
- filament_cooling_moves = 4
- filament_cost = 20
- filament_density = 0
- filament_diameter = 1.75
- filament_load_time = 0
- filament_loading_speed = 28
- filament_loading_speed_start = 3
- filament_max_volumetric_speed = 15
- filament_minimal_purge_on_wipe_tower = 15
- filament_notes = ""
- filament_ramming_parameters = "120 100 6.6 6.8 7.2 7.6 7.9 8.2 8.7 9.4 9.9 10.0| 0.05 6.6 0.45 6.8 0.95 7.8 1.45 8.3 1.95 9.7 2.45 10 2.95 7.6 3.45 7.6 3.95 7.6 4.45 7.6 4.95 7.6"
- filament_settings_id = ""
- filament_soluble = 0
- filament_toolchange_delay = 0
- filament_type = PLA
- filament_unload_time = 0
- filament_unloading_speed = 90
- filament_unloading_speed_start = 100
- first_layer_bed_temperature = 70
- first_layer_temperature = 210
- inherits =
- max_fan_speed = 100
- min_fan_speed = 35
- min_print_speed = 10
- slowdown_below_layer_time = 5
- start_filament_gcode = "; Filament gcode\n"
- temperature = 210
Advertisement
Add Comment
Please, Sign In to add comment
Advertisement