# This file contains common pin mappings for RAMPS (v1.3 and later)
# boards. RAMPS boards typically use a firmware compiled for the AVR
# atmega2560 (though other AVR chips are also possible).

# See the example.cfg file for a description of available parameters.

[stepper_x]
step_pin: ar54
dir_pin: ar55
enable_pin: !ar38
step_distance: .0125
endstop_pin: ^ar3
#endstop_pin: ^ar2
position_endstop: 0
position_max: 300
homing_speed: 50

[stepper_y]
step_pin: ar60
dir_pin: ar61
enable_pin: !ar56
step_distance: .0125
#endstop_pin: ^ar14
endstop_pin: ^ar15
position_endstop: 0
position_max: 200
homing_speed: 50

[stepper_z]
step_pin: ar46
dir_pin: ar48
enable_pin: !ar62
step_distance: .003125
endstop_pin: ^ar18
#endstop_pin: ^ar19
position_endstop: 0.5
position_max: 200

[extruder]
step_pin: ar26
dir_pin: ar28
enable_pin: !ar24
step_distance: .002
nozzle_diameter: 0.400
filament_diameter: 1.750
heater_pin: ar10
sensor_type: ATC Semitec 104GT-2
sensor_pin: analog13
control: pid
pid_Kp: 22.2
pid_Ki: 1.08
pid_Kd: 114
min_temp: 0
max_temp: 250

#[extruder1]
#step_pin: ar36
#dir_pin: ar34
#enable_pin: !ar30
#heater_pin: ar9
#sensor_pin: analog15
#...

[heater_bed]
heater_pin: ar8
sensor_type: NTC 100K beta 3950
sensor_pin: analog14
control: watermark
min_temp: 0
max_temp: 110

[fan]
pin: ar9

[mcu]
serial: /dev/ttyUSB0
pin_map: arduino

[printer]
kinematics: corexy
max_velocity: 200
max_accel: 1500
max_z_velocity: 5
max_z_accel: 50

# "RepRapDiscount 2004 Smart Controller" type displays
#[display]
#lcd_type: hd44780
#rs_pin: ar16
#e_pin: ar17
#d4_pin: ar23
#d5_pin: ar25
#d6_pin: ar27
#d7_pin: ar29
#encoder_pins: ^ar31, ^ar33
#click_pin: ^!ar35

# "RepRapDiscount 128x64 Full Graphic Smart Controller" type displays
#[display]
#lcd_type: st7920
#cs_pin: ar16
#sclk_pin: ar23
#sid_pin: ar17
#encoder_pins: ^ar31, ^ar33
#click_pin: ^!ar35