u-boot-flash-spi-rock64.img.xz (0.6.25)

== Notes ==
White led pulses on completion, red led stays lit the entire time
Took approximately 1m10sec from power on to completion

== Output ==
DDR version 1.06 20170424
In
LPDDR3
786MHz
Bus Width=32 Col=11 Bank=8 Row=15/15 CS=2 Die Bus-Width=32 Size=4096MB
ddrconfig:7
OUT

U-Boot SPL 2017.09-ga0a2b48 (Mar 04 2018 - 20:21:22)
setup_ddr_param  1
booted from SD
Trying to boot from MMC2
NOTICE:  BL31: v1.3(release):f947c7e
NOTICE:  BL31: Built : 20:21:21, Mar  4 2018
NOTICE:  BL31:Rockchip release version: v1.3


U-Boot 2017.09-ga0a2b48 (Mar 04 2018 - 20:21:36 +0000), Build: jenkins-linux-build-rock-64-193

Model: Pine64 Rock64
DRAM:  4 GiB
MMC:   rksdmmc@ff520000: 0, rksdmmc@ff500000: 1
*** Warning - bad CRC, using default environment

In:    serial@ff130000
Out:   serial@ff130000
Err:   serial@ff130000
Model: Pine64 Rock64
misc_init_r
cpuid=55524b50303630303000000000031020
serial=efc659775797323
Net:   eth0: ethernet@ff540000
Hit any key to stop autoboot:  0
Card did not respond to voltage select!
mmc_init: -95, time 10
switch to partitions #0, OK
mmc1 is current device
Scanning mmc 1:6...
Found U-Boot script /boot.scr
reading /boot.scr
449 bytes read in 4 ms (109.4 KiB/s)
## Executing script at 00500000
SF: Detected gd25q128 with page size 256 Bytes, erase size 4 KiB, total 16 MiB

MMC read: dev # 1, block # 64, count 8000 ... 8000 blocks read: OK
SF: 4096000 bytes @ 0x8000 Erased: OK
device 0 offset 0x8000, size 0x3e8000
SF: 4096000 bytes @ 0x8000 Written: OK