Advertisement
Not a member of Pastebin yet?
Sign Up,
it unlocks many cool features!
- __ __ _ _
- | \/ | __ _ _ ____ _____| | |
- | |\/| |/ _` | '__\ \ / / _ \ | |
- | | | | (_| | | \ V / __/ | |
- |_| |_|\__,_|_| \_/ \___|_|_|
- _ _ ____ _
- | | | | | __ ) ___ ___ | |_
- | | | |___| _ \ / _ \ / _ \| __|
- | |_| |___| |_) | (_) | (_) | |_
- \___/ |____/ \___/ \___/ \__| ** LOADER **
- ** MARVELL BOARD: G2428N BE (configured)
- ** Linux - BE support
- ** vxWorks - BE support
- Ethernet Switch, Version BC_PUGIO_H_1.1.4-X6
- Base on Marvell xCat2 Serial solution
- U-Boot 1.1.4 (Apr 24 2014 - 08:26:24) Marvell version: 5.3.4_0026-TINY
- U-Boot code: 01200000 -> 012C1FF0 BSS: -> 012E460C
- IRQ Stack: 009fff7c
- FIQ Stack: 009fef7c
- Soc: MV88F6281 Rev 3 (DDR2)
- CPU running @ 500Mhz L2 running @ 250Mhz
- SysClock = 250Mhz , TClock = 167Mhz
- DRAM CAS Latency = 5 tRP = 5 tRAS = 15 tRCD=5
- DRAM configured 512MB, probed 256MB
- DRAM CS[0] base 0x00000000 size 256MB
- DRAM Total size 256MB 16bit width
- [32768kB@f8000000] Flash: 32 MB
- Addresses 27M - 0M are saved for the U-Boot usage.
- Mem malloc Initialization (27M - 19M): Done
- CPU : Marvell Feroceon (Rev 1)
- Streaming disabled
- Write allocate disabled
- PEX0 interface detected no Link.
- PEX 0: interface detected no Link.
- Fox Version: BC_PUGIO_H_1.1.4-X6, Build Date: Apr 24 2014 08:26:22
- TWSI: mvTwsiStartBitSet ERROR - start bit didn't went down
- TWSI: mvTwsiStopBitSet ERROR - status 0 after Stop Bit.
- TWSI: mvTwsiRead: 930: mvTwsiStopBitSet fail
- Unable to read CPLD revision
- Unable to read Model ID
- Model ID: 0.0.0.0.0.0
- Board Id: AllyCat2-24
- Chip Revision 0x3
- HW Rev. - BETA build
- Initialize IO Expander ... Done
- Initialize MAC ... Done
- Initialize PHY ... Done
- Initialize PHY LED ... Done
- Fixed Port 1: 1545 Revision ID is A1
- Fixed Port 2: 1545 Revision ID is A1
- Fixed Port 3: 1545 Revision ID is A1
- Fixed Port 4: 1545 Revision ID is A1
- Fixed Port 5: 1545 Revision ID is A1
- Fixed Port 6: 1545 Revision ID is A1
- Fixed Port 7: 1545 Revision ID is A1
- Fixed Port 8: 1545 Revision ID is A1
- Fixed Port 9: 1545 Revision ID is A1
- Fixed Port 10: 1545 Revision ID is A1
- Fixed Port 11: 1545 Revision ID is A1
- Fixed Port 12: 1545 Revision ID is A1
- Fixed Port 13: 1543 Revision ID is A1
- Fixed Port 14: 1543 Revision ID is A1
- Fixed Port 15: 1543 Revision ID is A1
- Fixed Port 16: 1543 Revision ID is A1
- Fixed Port 17: 1543 Revision ID is A1
- Fixed Port 18: 1543 Revision ID is A1
- Fixed Port 19: 1543 Revision ID is A1
- Fixed Port 20: 1543 Revision ID is A1
- Fixed Port 21: No PHY detected
- Fixed Port 22: No PHY detected
- Fixed Port 23: No PHY detected
- Fixed Port 24: No PHY detected
- Fixed Port 25: No PHY detected
- Fixed Port 26: No PHY detected
- Fixed Port 27: No PHY detected
- Fixed Port 28: No PHY detected
- Enable temperature monitor function ... Done
- Fan initialize ...Done.
- Initialize CPU packet ... Done
- egiga0 [PRIME], port1, port2, port3, port4, port5, port6, port7, port8, port9, port10, port11, port12, port13, port14, port15, port16, port17, port18, port19, port20, port21, port22, port23, port24, port25, port26, port27, port28, ppsdma
- Hit any key to stop autoboot: 0
- XCAT2>> boot
- XCAT2>>
- XCAT2>>
- XCAT2>> flinfo
- Bank # 1:
- Flash Base Address : 0xf8000000
- Flash Model : MXIC MX25L25635
- Manufacturer ID : 0xc2
- Device Id : 0x2019
- Sector Size : 64K
- Number of sectors : 512
- Page Size : 256
- Write Protection : All
- Linux/vxWorks partitions on flash
- ---------------------------------
- Flash size : 32MB
- u-boot : offset=0xf8000000, size=0x00100000 (1024K)
- kernel/vxWorks-image : offset=0xf8100000, size=0x001c0000 (1792K)
- Linux rootfs : offset=0xf82c0000, size=0x00740000 (7424K)
- Single Image : offset=0xf8100000, size=0x00900000 (9216K)
- XCAT2>>
- XCAT2>>
- XCAT2>> version
- U-Boot 1.1.4 (Apr 24 2014 - 08:26:24) Marvell version: 5.3.4_0026-TINY
- BC_PUGIO_H_1.1.4-X6 (Apr 24 2014 - 08:26:31)
- PoE Software Version: N/A
- XCAT2>>
- XCAT2>>
- XCAT2>>
- XCAT2>> printenv
- bootdelay=3
- baudrate=9600
- loads_echo=0
- serverip=10.5.70.50
- uboot=u-boot-fox_98dx3025_667_3025_fox_flash.bin
- logname=katara_log.txt
- blup=tftp 3000000 $uboot; prot off f8000000 f80fffff; erase f8000000 f80fffff; sflash write 3000000 0 $filesize
- blup2=tftp 3000000 $(uboot); prot off f8000000 f80fffff; erase f8000000 f80bFFFF; sflash write 3000000 0 0xC0000
- uplog=mw.l 3000000 0 300000; sflash read f9a00000 3000000 300000; tftp 3000000 $(logname) 300000
- pp_init_enable=1
- brcdbl=tftp 3000000 $(uboot); prot off f8000000 f80fffff; erase f8000000 f80bFFFF; sflash write 3000200 0 0xC0000
- broad_pkt_enable=1
- CASset=min
- ethprime=egiga0
- rootpath=/tftpboot/rootfs_arm-gnueabi-be
- consoledev=ttyS0
- linux_loadaddr=0x2000000
- bootcmd=
- fix_nfsroot_to_BE=no
- linux_parts=mtdparts=spi_flash:0x00100000(uboot)ro,0x001c0000(kernel),0x00740000(rootfs)
- nfsboot=setenv bootargs root=/dev/nfs rw nfsroot=$(serverip):$(rootpath) ip=$(ipaddr):$(serverip):$(gatewayip):$(netmask):$(hostname):$(netdev):off console=$(consoledev),$(baudrate) $(othbootargs) $(linux_parts); tftp $(linux_loadaddr) $(image_name);bootm $(linux_loadaddr)
- standalone_mtd=setenv bootargs root=/dev/mtdblock2 rw rootfstype=jffs2 ip=$(ipaddr):$(serverip):$(gatewayip):$(netmask):$(hostname):$(netdev):off console=$(consoledev),$(baudrate) $(othbootargs) $(linux_parts) egiga0=1; bootm 0xf8100000
- netdev=eth0
- vx_burn=mtdburn $(vx_image_name)
- vx_image_name=vxWorks.st
- vx=setenv bootargs mgi(0,0) host:VxWorks h=$(serverip) e=$(ipaddr):FFFF0000 u=anonymous pw=target; setenv bootaddr 0x700; setenv loadaddr 0x3000000; tftpboot $(loadaddr) $(vx_image_name); bootvx
- vx_flash=setenv bootargs mgi(0,0) host:VxWorks h=$(serverip) e=$(ipaddr):FFFF0000 u=anonymous pw=target; setenv bootaddr 0x700; vx_unc_boot
- bootargs_root=root=/dev/nfs rw
- bootargs_end=:::DB88FXX81:eth0:none
- ethaddr=00:50:43:db:8b:8a
- ethmtu=1500
- mvNetConfig=mv_net_config=(00:11:88:0f:62:81,0:1:2:3),mtu=1500
- yuk_ethaddr=00:00:00:EE:51:81
- ethact=egiga0
- start_time=244
- start_time_mday=4
- poe_enable=1
- ip=?
- ipaddr=192.168.1.66
- gatewayip=192.168.1.1
- netmask=255.255.255.0
- stdin=serial
- stdout=serial
- stderr=serial
- enaMonExt=no
- enaCpuStream=no
- enaWrAllo=no
- pexMode=RC
- disL2Cache=no
- setL2CacheWT=yes
- disL2Prefetch=yes
- enaICPref=yes
- enaDCPref=yes
- sata_dma_mode=yes
- netbsd_en=no
- disaMvPnp=no
- image_name=uImage_xcat
- Environment size: 2314/4092 bytes
- XCAT2>>
Advertisement
Add Comment
Please, Sign In to add comment
Advertisement