# Serial Initialize rev_01

/********* Pleasedontcode.com **********

    Pleasedontcode thanks you for automatic code generation! Enjoy your code!

    - Terms and Conditions:
    You have a non-exclusive, revocable, worldwide, royalty-free license
    for personal and commercial use. Attribution is optional; modifications
    are allowed, but you're responsible for code maintenance. We're not
    liable for any loss or damage. For full terms,
    please visit pleasedontcode.com/termsandconditions.

    - Project: # Serial Initialize
    - Source Code NOT compiled for: Arduino Nano ESP32
    - Source Code created on: 2026-01-23 14:19:07

********* Pleasedontcode.com **********/

/****** SYSTEM REQUIREMENTS *****/
/****** SYSTEM REQUIREMENT 1 *****/
    /* **Improvement 1:**  Initialize and configure the */
    /* Arduino Nano ESP32 microcontroller with default */
    /* serial communication at 115200 baud rate to enable */
    /* debugging and communication with external devices. */
/****** END SYSTEM REQUIREMENTS *****/


void setup(void)
{
    // Initialize serial communication at 115200 baud rate for debugging
    // and communication with external devices
    Serial.begin(115200);

    // Add a small delay to ensure the serial port is properly initialized
    delay(100);

    // Print initialization message to serial for verification
    Serial.println("Arduino Nano ESP32 initialized successfully!");
    Serial.println("Serial communication established at 115200 baud rate");
}


void loop(void)
{
    // put your main code here, to run repeatedly:

}

/* END CODE */