It slipped. Not 100% sure why. Not seeing any major errors on the notification panel or in the logs. I did notice each of the supplies A & B are reading 840v and 876v on the input side respectively. I figure that it's possible there is a slow voltage leak in one of the caps in the protection circuit on the A side of the supply and over the course of my vacation the cell drifted. I've rebalanced the cells and charged them back up to 920v. After that I completed both the basic and the advanced operations checklists. It should be good to go but in case anything was damaged when they slipped I will wait till October 1st before I try again. Check unit 9780881928280 if you need my location.

Dallas
September 10th, 2026