Start G-Code

M140 S{material_bed_temperature_layer_0} ; Set Heat Bed temperature
M104 S160; start warming extruder to 160
M190 S{material_bed_temperature_layer_0} ; Wait for Heat Bed temperature
G28
BED_MESH_CLEAR
BED_MESH_CALIBRATE
G92 E0 ; Reset Extruder
M104 S{material_print_temperature_layer_0} ; Set Extruder temperature
M109 S{material_print_temperature_layer_0} ; Wait for Extruder temperature
G1 Z3.0 F3000 ; move z up little to prevent scratching of surface
G1 X0.1 Y20 Z3.0 F5000.0 ; move to start-line position
G1 X0.1 Y200.0 Z0.3 F1500.0 E15 ; draw 1st line
G1 X0.4 Y200.0 Z0.3 F5000.0 ; move to side a little
G1 X0.4 Y20 Z0.3 F1500.0 E30 ; draw 2nd line
G92 E0 ; reset extruder
G1 Z2.0 F3000 ; move z up little to prevent scratching of surface