Not a member of Pastebin yet?
Sign Up,
it unlocks many cool features!
- U-Boot 2016.09 (Sep 14 2016 - 16:41:42 -0700)
- CPU0: P5020, Version: 2.0, (0x82200020)
- Core: e5500, Version: 1.2, (0x80240012)
- Clock Configuration:
- CPU0:1995 MHz, CPU1:1995 MHz,
- CCB:798 MHz,
- DDR:665 MHz (1330 MT/s data rate) (Asynchronous), LBC:49.875 MHz
- FMAN1: 498.750 MHz
- QMAN: 399 MHz
- PME: 399 MHz
- L1: D-cache 32 KiB enabled
- I-cache 32 KiB enabled
- Reset Configuration Word (RCW):
- 00000000: 0c540000 00000000 1e1e0000 00000000
- 00000010: 44808c00 ff002000 68000000 45000000
- 00000020: 00000000 00000000 00000000 0003000f
- 00000030: a0000000 00000000 00000000 00000000
- Board: CYRUS
- I2C: ready
- SPI: ready
- DRAM: Initializing....using SPD
- Detected UDIMM M391B5273CH0-YH9
- Detected UDIMM M391B5273CH0-YH9
- 6 GiB left unmapped
- 8 GiB (DDR3, 64-bit, CL=9, ECC on)
- DDR Controller Interleaving Mode: cache line
- DDR Chip-Select Interleaving Mode: CS0+CS1
- Local Bus Controller Registers
- BR0 0xE0001001 OR0 0xFFF00010
- BR1 0xE1001001 OR1 0xFFF00010
- BR2 0x00000000 OR2 0x00000000
- BR3 0x00000000 OR3 0x00000000
- BR4 0x00000000 OR4 0x00000000
- BR5 0x00000000 OR5 0x00000000
- BR6 0x00000000 OR6 0x00000000
- BR7 0x00000000 OR7 0x00000000
- LBCR 0x40000000 LCRR 0x80010004
- L2: 512 KiB enabled
- Corenet Platform Cache: 2 MiB enabled
- SERDES: bank 2 disabled
- MMC: FSL_SDHC: 0
- EEPROM: NXID v0
- PCIe1: Root Complex, x4 gen1, regs @ 0xfe200000
- 01:00.0 - 1002:6779 - Display controller
- 01:00.1 - 1002:aa98 - Multimedia device
- PCIe1: Bus 00 - 01
- PCIe2: Root Complex, x4 gen2, regs @ 0xfe201000
- 03:00.0 - 111d:8092 - Bridge device
- 04:01.0 - 111d:8092 - Bridge device
- 05:00.0 - 12d8:e111 - Bridge device
- 06:04.0 - 1095:3112 - Mass storage controller
- 06:05.0 - 1000:0001 - Build before PCI Rev2.0
- 04:02.0 - 111d:8092 - Bridge device
- 07:00.0 - 10ec:8168 - Network controller
- 04:03.0 - 111d:8092 - Bridge device
- 04:08.0 - 111d:8092 - Bridge device
- 09:00.0 - 1180:e822 - Base system peripheral
- 04:10.0 - 111d:8092 - Bridge device
- 0a:00.0 - 144d:a802 - Mass storage controller
- PCIe2: Bus 02 - 0a
- PCIe3: disabled
- PCIe4: disabled
- In: serial
- Out: serial
- Err: serial
- Net: Initializing Fman
- MMC read: dev # 0, block # 1680, count 128 ...
- Fman1: Uploading microcode version 106.1.0
- Tuning PHY @ 3
- Tuning PHY @ 7
- PCI device RTL8169#0: unknown chip version, assuming RTL-8169
- PCI device: TxConfig = 0xEFBEADDE
- FM1@DTSEC4 [PRIME], FM1@DTSEC5, RTL8169#0
- Hit any key to stop autoboot: 0
- => run fbsd
- 8462132 bytes read in 726 ms (11.1 MiB/s)
- 38093 bytes read in 166 ms (223.6 KiB/s)
- WARNING: adjusting available memory to 30000000
- ## Booting kernel from Legacy Image at 03ffffc0 ...
- Image Name: FreeBSD-AlexBuilt
- Created: 2016-09-21 1:50:23 UTC
- Image Type: PowerPC Linux Kernel Image (uncompressed)
- Data Size: 8462068 Bytes = 8.1 MiB
- Load Address: 03ffffc0
- Entry Point: 04001000
- Verifying Checksum ... OK
- ## Flattened Device Tree blob at 00c00000
- Booting using the fdt blob at 0xc00000
- Loading Kernel Image ... OK
- Loading Device Tree to 03fe3000, end 03fff4cc ... OK
- Bad trap at PC: 7fef3fc4, SR: 4001a34, vector=e00
- NIP: 7FEF3FC4 XER: 20000000 LR: 7FEE0C6C REGS: 7fddd940 TRAP: 0e00 DAR: 00000000
- MSR: 04001a34 EE: 0 PR: 0 FP: 0 ME: 1 IR/DR: 11
- GPR00: 04001000 7FDDDA30 7FDDDEF8 00003000 C0000000 00000000 45504150 04000000
- GPR08: 00000000 00000000 00000000 04000000 48428024 3FFF5000 7FEFA8E8 00000000
- GPR16: 00000000 00000000 00000000 03FFFFC0 04811EF4 00000000 00000000 7FEF3FC4
- GPR24: 00000001 00000000 00000000 7FDDF5FC 03FE3000 7FFC1210 7FF6948C 00000000
- Call backtrace:
- 7FEEA69C 7FEFF3E0 7FEFEA6C 7FEEC078 7FF10BA0 7FEFC448 7FEFCCF4
- 7FEFBDD0 7FF0EEA8 7FF0EFEC 7FF10BA0 7FEFC448 7FEFCCF4 7FEFD280
- 7FF0F08C 7FEFA0F4 7FEFDBB4 7FF42368 7FEFDEC0 7FEE1050
- Exception in kernel pc 7fef3fc4 signal 0
- ### ERROR ### Please RESET the board ###
Add Comment
Please, Sign In to add comment