TS ramps update

# This file contains common pin mappings for RAMPS





[stepper_x]

step_pin: ar54

dir_pin: ar55

enable_pin: !ar38

step_distance: .0125

endstop_pin: ^ar3

#endstop_pin: ^ar2

position_endstop: 0

position_max: 200

homing_speed: 50



[stepper_y]

step_pin: ar60

dir_pin: !ar61

enable_pin: !ar56

step_distance: .0125

endstop_pin: ^ar14

#endstop_pin: ^ar15

position_endstop: 0

position_max: 200

homing_speed: 50



[stepper_z]

step_pin: ar46

dir_pin: ar48

enable_pin: !ar62

step_distance: .0025

endstop_pin: ^ar18

#endstop_pin: ^ar19

position_endstop: 0.5

position_max: 200



[extruder]

step_pin: ar26

dir_pin: ar28

enable_pin: !ar24

step_distance: .002

nozzle_diameter: 0.400

filament_diameter: 1.750

heater_pin: ar10

sensor_type: EPCOS 100K B57560G104F

sensor_pin: analog13

control: pid

pid_Kp: 22.2

pid_Ki: 1.08

pid_Kd: 114

min_temp: 0

max_temp: 250



#[extruder1]

#step_pin: ar36

#dir_pin: ar34

#enable_pin: !ar30

#heater_pin: ar9

#sensor_pin: analog15

#...



[heater_bed]

heater_pin: ar8

sensor_type: EPCOS 100K B57560G104F

sensor_pin: analog14

control: watermark

min_temp: 0

max_temp: 130



[fan]

pin: ar9



[mcu]

serial: /dev/ttyACM0

pin_map: arduino



[printer]

kinematics: cartesian

square_corner_velocity: 8.0

max_velocity: 650

max_accel: 8500

max_z_velocity: 30

max_z_accel: 350



# Common EXP1 / EXP2 (display) pins

[board_pins]

aliases:

    # Common EXP1 header found on many "all-in-one" ramps clones

    EXP1_1=ar37, EXP1_3=ar17, EXP1_5=ar23, EXP1_7=ar27, EXP1_9=<GND>,

    EXP1_2=ar35, EXP1_4=ar16, EXP1_6=ar25, EXP1_8=ar29, EXP1_10=<5V>,

    # EXP2 header

    EXP2_1=ar50, EXP2_3=ar31, EXP2_5=ar33, EXP2_7=ar49, EXP2_9=<GND>,

    EXP2_2=ar52, EXP2_4=ar53, EXP2_6=ar51, EXP2_8=ar41, EXP2_10=<RST>

    # Pins EXP2_1, EXP2_6, EXP2_2 are also MISO, MOSI, SCK of bus "spi"

    # Note, some boards wire: EXP2_8=<RST>, EXP2_10=ar41



# See the sample-lcd.cfg file for definitions of common LCD displays.