[gcode_macro PRINT_START]
gcode:
    {% set EXTRUDER_TEMP = params.EXTRUDER|default(190)|float %}
    {% set BED_TEMP = params.BED|default(60)|float %}
    # Start bed heating
    M140 S{BED_TEMP}
    # Use absolute coordinates
    G90
    # Reset the G-Code Z offset (adjust Z offset if needed)
    SET_GCODE_OFFSET Z=0.0
    # Home the printer
    G28
    # Set and wait for bed to reach temperature
    M190 S{BED_TEMP}
    # KAMP calibration
    BED_MESH_CALIBRATE
    BED_MESH_PROFILE LOAD=default
    # Move the nozzle near the bed
    G1 Z5 F3000
    G1 X0.1 Y20 Z0.3 F5000.0
    # Set and wait for nozzle to reach temperature
    M109 S{EXTRUDER_TEMP}
    G92 E0 ; Reset Extruder
    G1 X0.1 Y200.0 Z0.3 F1500.0 E15 ; Draw the first line
    G1 X0.4 Y200.0 Z0.3 F5000.0 ; Move to side a little
    G1 X0.4 Y20 Z0.3 F1500.0 E30 ; Draw the second line
    G92 E0 ; Reset Extruder
    G1 Z2.0 F3000 ; Move Z Axis up little to prevent scratching of Heat Bed
    G1 X5 Y20 Z0.3 F5000.0 ; Move over to prevent blob squish

[gcode_macro PRINT_END]
gcode:
  {% set x_park = printer.toolhead.axis_maximum.x|float - 5.0 %}
  {% set y_park = printer.toolhead.axis_maximum.y|float - 5.0 %}
    # Turn off bed, extruder, and fan
    M140 S0
    M104 S0
    M106 S0
    # Move nozzle away from print while retracting
    G91
    G1 Z20 E-30 F1500
    # Reset extruder
    G92 E0
    # Absolute coords
    G90
    # Move to park position
    G1 X{x_park} Y{y_park}
    # Disable steppers
    M84