rayddteam

DIR-632 dmesg @2012-10-02

Oct 2nd, 2012
116
0
Never
Not a member of Pastebin yet? Sign Up, it unlocks many cool features!
text 7.69 KB | None | 0 0
  1. KDB: debugger backends: ddb
  2. KDB: current backend: ddb
  3. Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
  4. FreeBSD is a registered trademark of The FreeBSD Foundation.
  5. [email protected]:/usr/obj/usr/home/ray/work/DDTeam.net/ZRouter/zrouter/tmp/mips.mips/usr/1/MIPS_FreeBSD/HEAD/head/sys/usr/obj/usr/home/ray/work/DDTeam.net/ZRouter/zrouter/conf/D-Link_DIR-632 mips
  6. real memory = 33554432 (32768K bytes)
  7. nexus0: <MIPS32 root nexus>
  8. clock0: <Generic MIPS32 ticker> on nexus0
  9. Event timer "MIPS32" frequency 200000000 Hz quality 800
  10. cryptosoft0: <software crypto> on nexus0
  11. uart0: <16550 or compatible> on apb0
  12. uart0: console (115200,n,8,1)
  13. gpio0: <Atheros AR71XX GPIO driver> on apb0
  14. gpio0: gpio pinmask=0x3ffff
  15. gpiobus0: <GPIO bus> on gpio0
  16. gpioled0: Use pinmask=0x00000001
  17. gpioled1: Use pinmask=0x00000002
  18. gpioled2: Use pinmask=0x00000040
  19. gpioled4: Use pinmask=0x00000800
  20. gpiobutton0: Use pinmask=0x00001000
  21. gpioc0: <GPIO controller> at pin(s) 0-17 on gpiobus0
  22. gpioled0: <GPIO led> at pin(s) 0 on gpiobus0
  23. gpioled0: /dev/led/wps flags=0102
  24. gpioled1: <GPIO led> at pin(s) 1 on gpiobus0
  25. gpioled1: /dev/led/status_yellow flags=0002
  26. gpioled2: /dev/led/status flags=0102
  27. gpioled3: /dev/led/internet flags=0102
  28. gpioled4: <GPIO led> at pin(s) 11 on gpiobus0
  29. gpioled5: <GPIO led> at pin(s) 17 on gpiobus0
  30. ehci0: <AR71XX Integrated USB 2.0 controller> at mem 0x1b000100-0x1bffffff irq 1 on nexus0
  31. usbus0: set host controller mode
  32. usbus0: set host controller mode
  33. usbus0 on ehci0
  34. pcib0: found EEPROM at 0x1fff1000 on 0.0.0
  35. 00006008: 02800001 (Old: deadbeef)
  36. 0000602c: a199168c (Old: deadbeef)
  37. 00005008: 02800001 (Old: deadbeef)
  38. 0000502c: a199168c (Old: deadbeef)
  39. 0000570c: 22003f01 (Old: deadbeef)
  40. 00004004: 004a050b (Old: 004a0ddf)
  41. 00004074: 00000003 (Old: 00000001)
  42. 00006034: 00000044 (Old: deadbeef)
  43. 00005164: ff241412 (Old: deadbeef)
  44. 00005068: 00192010 (Old: deadbeef)
  45. pcib0: EEPROM firmware: 0x1fff1000 @ 4096 bytes
  46. pci0: <PCI bus> on pcib0
  47. ath0: <Atheros 9287> at device 0.0 on pci0
  48. ath0: [HT] enabling HT modes
  49. ath0: [HT] enabling short-GI in 20MHz mode
  50. ath0: AR9287 mac 384.2 RF5133 phy 15.15
  51. arge0: <Atheros AR71xx built-in ethernet interface> at mem 0x19000000-0x19000fff irq 2 on nexus0
  52. miibus0: <MII bus> on arge0
  53. rtl830x_switch0: <RTL830x ethernet switch> on switch0
  54. rtl830x_switch0: GCNTRL0=0000ebfc
  55. rtl830x_switch0: GCNTRL1=00009c80
  56. rtl830x_switch0: GCNTRL3=0000f7c1
  57. rtl830x_switch0: PORT_PVID(0)=00000f01
  58. rtl830x_switch0: PORT_PVID(1)=00001f02
  59. rtl830x_switch0: PORT_PVID(3)=00003f08
  60. rtl830x_switch0: PORT_PVID(4)=00004f10
  61. rtl830x_switch0: PORT_PVID(5)=00005f20
  62. rtl830x_switch0: PORT_PVID(6)=00006f40
  63. rtl830x_switch0: PORT8_PVID=000031ff
  64. rtl830x_switch0: VLAN_A_MEMB=00000f01
  65. set_vlan_ports: idx=0, memb=000001ff
  66. set_vlan_ports: idx=2, memb=00000000
  67. set_vlan_ports: idx=3, memb=00000000
  68. set_vlan_ports: idx=4, memb=00000000
  69. set_vlan_ports: idx=5, memb=00000000
  70. set_vlan_ports: idx=6, memb=00000000
  71. set_vlan_ports: idx=8, memb=00000000
  72. rtl830x_switch0: GCNTRL0=0000e3b4
  73. rtl830x_switch0: GCNTRL1=00009c80
  74. rtl830x_switch0: GCNTRL3=0000f7c1
  75. rtl830x_switch0: PORT_PVID(0)=00000fff
  76. rtl830x_switch0: PORT_PVID(2)=00000e00
  77. rtl830x_switch0: PORT_PVID(3)=00000e00
  78. rtl830x_switch0: PORT_PVID(5)=00000e00
  79. rtl830x_switch0: PORT_PVID(7)=00000e00
  80. rtl830x_switch0: PORT8_PVID=00002000
  81. rtl830x_switch0: VLAN_A_MEMB=00000fff
  82. rtl830x_switch0: VLAN_A_ID=0000f001
  83. floatphy0: 100baseTX, 100baseTX-FDX, auto
  84. arge0: Ethernet address: 62:73:64:34:43:6c
  85. arge1: <Atheros AR71xx built-in ethernet interface> at mem 0x1a000000-0x1a000fff irq 3 on nexus0
  86. miibus1: <MII bus> on arge1
  87. switch1 PHY 16 on miibus1
  88. ar8x16_switch0: <AR8216.2 Ethernet switch> on switch1
  89. floatphy1 PHY 0 on miibus1
  90. arge1: Ethernet address: 62:73:64:a8:40:9e
  91. spi0: <AR71XX SPI> at mem 0x1f000000-0x1fffffff on nexus0
  92. spibus0: <spibus bus> on spi0
  93. mx25l0: <M25Pxx Flash Family> at cs 0 mode 0 on spibus0
  94. ar71xx_wdog0: <Atheros AR71XX watchdog timer> on nexus0
  95. Timecounters tick every 10.000 msec
  96. IPsec: Initialized Security Association Processing.
  97. ugen0.1: <Atheros> at usbus0
  98. map/rootfs.uncompress: GEOM_ULZMA image found
  99. map/rootfs.uncompress: 359 x 65536 blocks
  100. uhub0: 1 port with 1 removable, self powered
  101. warning: no time-of-day clock registered, system time will not be set accurately
  102. gpio0: Will report interrupt on pin 8
  103. gpio0: Will report interrupt on pin 12
  104. ipfw2 initialized, divert loadable, nat loadable, rule-based forwarding enabled, default to accept, logging disabled
  105. floatphy0: found master switch0
  106. lan0: link state changed to DOWN
  107. wlan0: Ethernet address: b8:a3:86:5d:06:59
  108. lan0: promiscuous mode enabled
  109. bridge0: link state changed to DOWN
  110. wlan0: promiscuous mode enabled
  111. bridge0: link state changed to UP
  112. floatphy1: found master switch1
  113. wan0: link state changed to UP
  114. BAD_PAGE_FAULT: pid 225 tid 100062 (sh), uid 0: pc 0x4079f8 got a read fault (type 0x2) at 0x6cf04
  115. zero: 0 at: 0x43c3c8 v0: 0x43c73c v1: 0
  116. a0: 0x6cf04 a1: 0x1 a2: 0 a3: 0
  117. t0: 0 t1: 0x406c200c t2: 0x4 t3: 0x6e
  118. t8: 0x88 t9: 0x4079c8 s0: 0x6cf04 s1: 0x7ffed5b8
  119. s2: 0x406d4538 s3: 0x1 s4: 0x1 s5: 0x43c734
  120. s6: 0x43c754 s7: 0x1 k0: 0 k1: 0
  121. gp: 0x443730 sp: 0x7ffed5a0 s8: 0x7ffed62c ra: 0x409ee0
  122. cause: 0x8 pc: 0x4079f8
  123. Page table info for pc address 0x4079f8: pde = 0x81cef000, pte = 0xa0052fda
  124. Dumping 4 words starting at pc address 0x4079f8:
  125. Page table info for bad address 0x6cf04: pde = 0, pte = 0
  126. pid 225 (sh), uid 0: exited on signal 11
  127. wan0: promiscuous mode enabled
  128. wan0: promiscuous mode disabled
  129. wan0: promiscuous mode disabled
  130. wan0: promiscuous mode enabled
  131. ng0: changing name to 'PPPoE'
  132. wifi0: stuck beacon; resetting (bmiss count 4)
  133. wifi0: stuck beacon; resetting (bmiss count 4)
  134. wifi0: stuck beacon; resetting (bmiss count 4)
  135. wifi0: stuck beacon; resetting (bmiss count 4)
  136. wifi0: stuck beacon; resetting (bmiss count 4)
  137. wifi0: stuck beacon; resetting (bmiss count 4)
  138. wifi0: stuck beacon; resetting (bmiss count 4)
  139. wifi0: stuck beacon; resetting (bmiss count 4)
  140. wifi0: stuck beacon; resetting (bmiss count 4)
  141. wifi0: stuck beacon; resetting (bmiss count 4)
  142. wifi0: stuck beacon; resetting (bmiss count 4)
  143. wifi0: stuck beacon; resetting (bmiss count 4)
  144. wifi0: stuck beacon; resetting (bmiss count 4)
  145. wifi0: stuck beacon; resetting (bmiss count 4)
  146. wifi0: stuck beacon; resetting (bmiss count 4)
  147. wifi0: stuck beacon; resetting (bmiss count 4)
  148. wifi0: stuck beacon; resetting (bmiss count 4)
  149. wifi0: stuck beacon; resetting (bmiss count 4)
  150. wifi0: stuck beacon; resetting (bmiss count 4)
  151. wifi0: stuck beacon; resetting (bmiss count 4)
  152. wifi0: stuck beacon; resetting (bmiss count 4)
  153. wifi0: stuck beacon; resetting (bmiss count 4)
  154. wifi0: stuck beacon; resetting (bmiss count 4)
  155. wifi0: stuck beacon; resetting (bmiss count 4)
  156. wifi0: stuck beacon; resetting (bmiss count 4)
  157. wifi0: stuck beacon; resetting (bmiss count 4)
  158. wifi0: stuck beacon; resetting (bmiss count 4)
  159. wifi0: stuck beacon; resetting (bmiss count 4)
  160. wifi0: stuck beacon; resetting (bmiss count 4)
  161. wifi0: stuck beacon; resetting (bmiss count 4)
  162. wifi0: stuck beacon; resetting (bmiss count 4)
  163. wifi0: stuck beacon; resetting (bmiss count 4)
  164. wifi0: stuck beacon; resetting (bmiss count 4)
  165. wifi0: stuck beacon; resetting (bmiss count 4)
  166. wifi0: stuck beacon; resetting (bmiss count 4)
  167. wifi0: stuck beacon; resetting (bmiss count 4)
  168. interrupt storm detected on "int3"; throttling interrupt source
  169. interrupt storm detected on "int3"; throttling interrupt source
  170. lan0: link state changed to DOWN
  171. bridge0: link state changed to DOWN
  172. lan0: link state changed to UP
  173. bridge0: link state changed to UP
Advertisement
Add Comment
Please, Sign In to add comment