IDEC-Tui_bug-list

##### Bugs
plc[connected]> read D100
Error: (5, 'Input/output error')
--The case where the connection was lost, and possibly re-enumerated with a different communications port
  The error is fine, but it should probably drop the connection too.
  this may happen when there are multiple communication ports active.


##### FIXED
# fixed relaese force in MiSmSerial (reminant) MiSmTCP was fine
# fixed utility folder
# fixed tab completion ?? works on my machine

#####
## Not a bug, but could handle script error on conection fault better.
Turn t0k outputs ON # what
setting output Q0030 1
Not connected. Run 'config' and then 'connect' first.
setting output Q0031 1
Not connected. Run 'config' and then 'connect' first.
setting output Q0032 1
Not connected. Run 'config' and then 'connect' first.
setting output Q0033 1
Not connected. Run 'config' and then 'connect' first.
setting output Q0034 1
Not connected. Run 'config' and then 'connect' first.
setting output Q0035 1
Not connected. Run 'config' and then 'connect' first.
setting output Q0036 1
Not connected. Run 'config' and then 'connect' first.
setting output Q0037 1
Not connected. Run 'config' and then 'connect' first.
Error: [Errno 2] could not open port /dev/ttyACM0: [Errno 2] No such file or directory: '/dev/ttyACM0'

## Not a bug, but should assign Y to Q and X to I
       This X,Y are Maintenance Protocol, but I,Q are standard naming conventions.
plc[connected]> read_bit Y0030
1
plc[connected]> output Q0030 0
0
plc[connected]> read_bit Y0030 <--literal Maintenance Protocol command
0
plc[connected]> read_bit Q0030 <-- Q should be bound to Y
Error: bit dtype must be X/Y/M/R (or x/y/m/r)
Q should be bound to Y, in ouput, it is but in read it is not.
## Check input for the same problem.