boot4 last_kmsg2.log

show last_kmsg2 sig 1128743492, size 6272, hw_status 1128743492, reboot_mode 0!
g for FS 192
[ 1122.337017] (0)[84:mtk-tpd]<<-GTP-DEBUG->> [1558][gtp_bak_ref_proc]/data mounted !!!!
[ 1122.339487] (0)[84:mtk-tpd]<<-GTP-DEBUG->> [1644][gtp_bak_ref_proc]Calc ref chksum:0x008C
[ 1122.339502] (0)[84:mtk-tpd]<<-GTP-DEBUG->> [1644][gtp_bak_ref_proc]Calc ref chksum:0x0000
[ 1122.339513] (0)[84:mtk-tpd]<<-GTP-DEBUG->> [1644][gtp_bak_ref_proc]Calc ref chksum:0x0000
[ 1122.339524] (0)[84:mtk-tpd]<<-GTP-DEBUG->> [1644][gtp_bak_ref_proc]Calc ref chksum:0x0000
[ 1122.339534] (0)[84:mtk-tpd]<<-GTP-DEBUG->> [1644][gtp_bak_ref_proc]Calc ref chksum:0x008C
[ 1122.339545] (0)[84:mtk-tpd]<<-GTP-DEBUG->> [1644][gtp_bak_ref_proc]Calc ref chksum:0x0000
[ 1122.339555] (0)[84:mtk-tpd]<<-GTP-DEBUG->> [1656][gtp_bak_ref_proc]Ref file chksum success.
[ 1122.351131]-(0)[81:mmcqd/1][Power/PMIC] [mt6323_pmic_eint_irq] receive interrupt
[ 1122.351145]-(0)[81:mmcqd/1][Power/PMIC] [wake_up_pmic]
[ 1122.351214] (0)[33:pmic_thread_kth][Power/PMIC] [pmic_thread_kthread] running
[ 1122.351232] (0)[33:pmic_thread_kth][Power/PMIC] [INT] int_status_val_0=0x20
[ 1122.351245] (0)[33:pmic_thread_kth][Power/PMIC] [pwrkey_int_handler]....
[ 1122.351259] (0)[33:pmic_thread_kth][Power/PMIC] [pwrkey_int_handler] Release pwrkey
[ 1122.351269] (0)[33:pmic_thread_kth]kpd: Power Key generate, pressed=0
[ 1122.351302] (0)[33:pmic_thread_kth]kpd: (released) HW keycode =116 using PMIC
[ 1122.351328] (0)[33:pmic_thread_kth][Power/PMIC] [INT] int_status_val_1=0x0
[ 1122.352421] (0)[33:pmic_thread_kth][Power/PMIC] [INT] after ,int_status_val_0=0x0
[ 1122.352435] (0)[33:pmic_thread_kth][Power/PMIC] [INT] after ,int_status_val_1=0x0
[ 1122.354649] (0)[84:mtk-tpd]<<-GTP-INFO->> Send ref success.
[ 1122.354829] (0)[84:mtk-tpd]<<-GTP-INFO->> EXIT_INT
[ 1122.359782] (0)[81:mmcqd/1]mmcblk1: error -5 transferring data, sector 17408, nr 1, cmd response 0x900, card status 0x0
[ 1122.359805] (0)[81:mmcqd/1][MSDC] msdc1 -> XXX CMD<24><0x4400> Error<0> Resp<0x900> <- msdc_dump_trans_error() : L<7046> PID<mmcqd/1><0x51>
[ 1122.359843] (0)[81:mmcqd/1]msdc1 -> TUNE_WRITE: dsmpl<1> rxdly0<0x0> d_cntr<1> sfreq.<50000000> <- msdc_tune_write() : L<6967> PID<mmcqd/1><0x51>
[ 1122.359869] (0)[81:mmcqd/1][MSDC] msdc1 -> check card state<4> <- msdc_abort_data() : L<2673> PID<mmcqd/1><0x51>
[ 1122.364762] (0)[81:mmcqd/1][MSDC] msdc1 -> CRC TUNE WRITE Times(1) <- msdc_reset_crc_tune_counter() : L<1721> PID<mmcqd/1><0x51>
[ 1122.443729]SysRq : Emergency Remount R/O
[ 1122.444050] (0)[1:init][gps]null pointer!!
[ 1122.444097] (0)[1:init]******** battery driver shutdown!! ********
[ 1122.444125]-(0)[1:init]mt_usb_disable, 1, 1
[ 1122.444951]-(0)[1:init]usb_phy_savecurrent_internal: USBPHY_READ8(0x05) = 0x44
[ 1122.444962]-(0)[1:init]usb_phy_savecurrent_internal: USBPHY_READ8(0x07) = 0x44
[ 1122.445008]-(0)[1:init]usb save current success
[ 1122.445109] (0)[1:init]******** MT auxadc driver shutdown!! ********
[ 1122.445122] (0)[1:init][LED]mt65xx_leds_shutdown
[ 1122.445130] (0)[1:init][LED]mt65xx_leds_shutdown: turn off backlight
[ 1122.445140] (0)[1:init][LED]backlight control through BLS!!1
[ 1122.445177] (0)[1:init][BLS]disp_bls_set_backlight: 0, gBLSPowerOn = 0
[ 1122.445188] (0)[1:init][BLS]after mapping, mapped_level: 0
[ 1122.445198] (0)[1:init][BLS]after SET, PWM_DUTY: 0
[ 1122.445224] (0)[1:init][DISP/MTKFB] [FB Driver] mtkfb_shutdown()
[ 1122.447941] (0)[31:kworker/0:1]Emergency Remount complete
[ 1122.491173] (0)[1:init][DDP] MT_CG_DISP0_SMI_LARB0 is forced on
[ 1122.498409] (0)[1:init][DISP/DSI] DSI_set_cmdq_V3[0]. DSI_CMDQ+0000 : 0x00280500
[ 1122.508453] (0)[1:init][DISP/DSI] DSI_set_cmdq_V3[1]. Delay 10 (ms)
[ 1122.508470] (0)[1:init][DISP/DSI] DSI_set_cmdq_V3[2]. DSI_CMDQ+0000 : 0x00100500
[ 1122.548512] (0)[1:init][DISP/DSI] DSI_set_cmdq_V3[3]. Delay 120 (ms)
[ 1122.728286] (0)[1:init][DDP]disp_path_power_off, caller:mtkfb
[ 1122.728315] (0)[1:init][DDP]disp_reg_backup() start, *pRegBackup=0xdeadbeef, reg_offset=0
[ 1122.728385] (0)[1:init][DDP]disp_reg_backup() end, *pRegBackup=0x2, reg_offset=213
[ 1122.728413] (0)[1:init][DDP] OVLReset called 0
[ 1122.728697] (0)[1:init][DISP/MTKFB] [FB Driver] leave mtkfb_shutdown
[ 1122.728733] (0)[1:init]+AudDrv_shutdown
[ 1122.728749] (0)[1:init]-AudDrv_shutdown
[ 1122.728875] (0)[1:init][battery_meter_shutdown]
[ 1122.728905] (0)[1:init]mtkfb_vsync device shutdown
[ 1122.728926] (0)[1:init]******** MTK WDT driver shutdown!! ********
[ 1122.728946] (0)[1:init]******** MTK WDT driver shutdown done ********
[ 1122.728966] (0)[1:init][vibrator]vib_shutdown: enter!
[ 1122.728988] (0)[1:init]mt_pwm_shutdown
[ 1122.729011] (0)[1:init]JPEG Codec shutdown
[ 1122.729193] (0)[1:init][Power/PMIC] ******** MT6323 pmic driver shutdown!! ********
[ 1122.729243] (0)[1:init]Power down.
[ 1122.729272]-(0)[1:init]machine_shutdown: start, Proess(init:1). father swapper/0:0. grandfather swapper/0:0.
[ 1122.729357]-(0)[1:init][Power/PMIC] [hwPowerOn] acquire powerId:4 index:1 mod_name: msdc powerVolt:3300
[ 1122.743412]-(0)[1:init][pll]0xF020924C = 0x80000001
[ 1122.743431]-(0)[1:init][pll]0xF0209240 = 0x121
[ 1122.743451]-(0)[1:init][mux] 0xF0000060 = 0x1818100
[ 1122.743470]-(0)[1:init][mux] 0xF0000070 = 0x1008101
[ 1122.743488]-(0)[1:init][clk] 0xF0003010 = 0x0
[