;
; 3D HPGL configuration file with toolchange
;
;
; History
; Who When       What
; === ========   ========================================
; ibu 08/05/2013 Written
;
DESCRIPTION = "VHF 3achs (*.nc)"
;
FILE_EXTENSION = "nc"
;
; Set units used in file - MM
;
UNITS = mm
;
; Cariage return - line feed at end of each line ?
END_OF_LINE = "[13][10]"
;
; Block numbering
;
LINE_NUM_START     = 1
LINE_NUM_INCREMENT = 1
;LINE_NUM_MAXIMUM   = 9999999
;
; Set up default formating for variables
;
; Feed Rate
;
; VHF use mm/s for output feed rate so divide by 60
; this is same as * (1/60)
;
FORMAT = [FC|@||1.0|16.66667]
;
; Spindle Speed
FORMAT = [S|@||1.0]
; Feed Rate
FORMAT = [F|#|F|1.0|16.66667]
FORMAT = [FC|@||1.0|16.66667]
; Tool moves in x,y and z
FORMAT = [X|@||1.0|1000]
FORMAT = [Y|@||1.0|1000]
FORMAT = [Z|@||1.0|-1000]
; Home tool positions
FORMAT = [XH|@||1.0|1000]
FORMAT = [YH|@||1.0|1000]
FORMAT = [ZH|@||1.0|-1000]
;
; Set up program header
;
; initialise program start
START = "GA,,0;"
START = "Material X=[XLENGHT] Y=[YLENGHT] Z=[ZLENGTH]]"
;
START = "/T[T];"
START = "/T[T] = [TOOLDESC]\"
;
START = "GA0,0;"
START = "RVS[S];"
START = "OS2,1;"
START = "GA[XH],[YH],[ZH];"
;START = "VS[FC];"
;
; Program moves
;
PLUNGE_RATE_MOVE      = "PA[X],[Y],[Z];"
RETRACT_MOVE          = "GA[X],[Y],[Z];"
FIRST_RAPID_RATE_MOVE = "GA[X],[Y],[ZH];"
RAPID_RATE_MOVE       = "GA[X],[Y],[Z];"
;
FIRST_FEED_RATE_MOVE = "PA[X],[Y],[Z];"
FEED_RATE_MOVE       = "PA[X],[Y],[Z];"
;
FEED_RATE_CHANGE = "VS[FC];"
;
;
;
;Toolchange Sections
;
TOOLCHANGE = "GA,,[ZH];"
TOOLCHANGE = "OS2,0;"
TOOLCHANGE = "RVS0;"
TOOLCHANGE = "/T[T];"
TOOLCHANGE = "/T[T] = [TOOLDESC]\"
TOOLCHANGE = "RVS[S];"
TOOLCHANGE = "OS2,1;"
TOOLCHANGE = "GA[XH],[YH],[ZH];"
;
;
;
; End of file
END = "OS2,0;"
END = "RVS0;"
;