SHARE
TWEET

config-35 for Raspbian 9.8 Stretch

a guest Apr 12th, 2019 187 Never
Not a member of Pastebin yet? Sign Up, it unlocks many cool features!
  1. # For more options and information see
  2. # http://www.raspberrypi.org/documentation/configuration/config-txt.md
  3. # Some settings may impact device functionality. See link above for details
  4.  
  5. # uncomment if you get no picture on HDMI for a default "safe" mode
  6. #hdmi_safe=1
  7.  
  8. # uncomment this if your display has a black border of unused pixels visible
  9. # and your display can output without overscan
  10. #disable_overscan=1
  11.  
  12. # uncomment the following to adjust overscan. Use positive numbers if console
  13. # goes off screen, and negative if there is too much border
  14. #overscan_left=16
  15. #overscan_right=16
  16. #overscan_top=16
  17. #overscan_bottom=16
  18.  
  19. # uncomment to force a console size. By default it will be display's size minus
  20. # overscan.
  21. #framebuffer_width=1280
  22. #framebuffer_height=720
  23.  
  24. # uncomment if hdmi display is not detected and composite is being output
  25. hdmi_force_hotplug=1
  26.  
  27. # uncomment to force a specific HDMI mode (this will force VGA)
  28. #hdmi_group=1
  29. #hdmi_mode=1
  30.  
  31. # uncomment to force a HDMI mode rather than DVI. This can make audio work in
  32. # DMT (computer monitor) modes
  33. #hdmi_drive=2
  34.  
  35. # uncomment to increase signal to HDMI, if you have interference, blanking, or
  36. # no display
  37. #config_hdmi_boost=4
  38.  
  39. # uncomment for composite PAL
  40. #sdtv_mode=2
  41.  
  42. #uncomment to overclock the arm. 700 MHz is the default.
  43. #arm_freq=800
  44.  
  45. # Uncomment some or all of these to enable the optional hardware interfaces
  46. dtparam=i2c_arm=on
  47. #dtparam=i2s=on
  48. dtparam=spi=on
  49. enable_uart=1
  50. # Uncomment this to enable the lirc-rpi module
  51. #dtoverlay=lirc-rpi
  52.  
  53. # Additional overlays and parameters are documented /boot/overlays/README
  54.  
  55. # Enable audio (loads snd_bcm2835)
  56. dtparam=audio=on
  57. dtoverlay=tft35a:rotate=270
RAW Paste Data
We use cookies for various purposes including analytics. By continuing to use Pastebin, you agree to our use of cookies as described in the Cookies Policy. OK, I Understand
 
Top