more boots!

2015-11-30 17:00:18  ★ Richard Hawkins would walk to the toolstation of the garage as he then bends down and picks up his toolbox
2015-11-30 17:00:37  ★ with his right hand as he then walks back to the Ford with it.      ((Richard Hawkins))
2015-11-30 17:01:10  ★ Richard Hawkins would then place it down next to the Ford as he then crouches down to it and opens it
2015-11-30 17:01:17  ★ with both of his hands.      ((Richard Hawkins))
2015-11-30 17:01:47  ★ after opening it , he would stand back up and walks to the toolstation, before picking up      ((Richard Hawkins))
2015-11-30 17:02:03  ★ 4 plastic pads , with both of his hands.      ((Richard Hawkins))
2015-11-30 17:02:31  ★ Richard Hawkins would then walk to the Ford as he then bends down at each end of the skirt and places one of
2015-11-30 17:02:36  ★ the pads under it.      ((Richard Hawkins))
2015-11-30 17:02:58  ★ Richard Hawkins would then walk to the Lift control as he then presses on one of the buttons with his index
2015-11-30 17:03:12  ★ finger and raises the middle part of the lift.      ((Richard Hawkins))
2015-11-30 17:03:37  ★ Richard Hawkins would release the button when all four wheels of the Ford  are off the ground.
2015-11-30 17:04:30  ★ Richard Hawkins would then walk to the toolbox as he then grabs ahold of the breaker bar and a 17mm socket
2015-11-30 17:04:38  ★ as he then connects the two.      ((Richard Hawkins))
2015-11-30 17:05:05  ★ Richard Hawkins would then use the breaker bar with the 17mm socket to loosen up and remove all 5 wheelnuts
2015-11-30 17:05:33  ★ of the front wheel as he then places the nuts into his pocket.      ((Richard Hawkins))
2015-11-30 17:06:26  ★ Richard Hawkins would then disconnect the 17mm socket from the breaker bar and places the breker bar onto
2015-11-30 17:06:45  ★ the lift with the 17mm socket .      ((Richard Hawkins))
2015-11-30 17:07:29  ★ Richard Hawkins would then grab ahold of the wheel, with both of his hands as he then pulls on it.
2015-11-30 17:08:06  ★ Richard Hawkins would then place the wheel onto the ground, next to him and lowers it down onto its side.
2015-11-30 17:08:32  ★ Richard Hawkins would then walk to the E61 as he then slides one of his hands into his pocket and takes out
2015-11-30 17:08:39  ★ the remote for it.      ((Richard Hawkins))
2015-11-30 17:08:58  ★ Richard Hawkins would then click on one of the buttons as he then opens the trunk.
2015-11-30 17:09:47  ★ Richard Hawkins would reach into the back of the E61 as he then reaches for the winter tyre with both of his
2015-11-30 17:10:17  ★ hands and lifts it out of the E61 as he then lowers it down to the ground and rolls it to      ((Richard Hawkins))
2015-11-30 17:10:26  ★ the Ford.      ((Richard Hawkins))
2015-11-30 17:11:37  ★ Richard Hawkins would then crouch to the wheelhub as he then grabs ahold of the winter tyre and lifts it up
2015-11-30 17:12:15  ★ to the wheelhub and aligns it with the wheelhub.      ((Richard Hawkins))
2015-11-30 17:12:56  ★ Richard Hawkins would then grab couple of nuts from his pocket as he then hand tightens them.
2015-11-30 17:14:23  ★ Richard Hawkins would then reach for the toolbox as he then reaches out for the torque bar .
2015-11-30 17:15:35  ★ Richard Hawkins would then twist the end of the torque bar and sets the torque to the 145N:M.
2015-11-30 17:16:15  ★ Richard Hawkins would then connect the 17mm socket to the torque bar as he then uses it to tighten the
2015-11-30 17:16:23  ★ wheelnuts.      ((Richard Hawkins))
2015-11-30 17:16:51  ★ Richard Hawkins would then check the nuts once again with the torque bar, befor moving on to the next wheel.
2015-11-30 17:17:12  ★ Richard Hawkins would repeat the same actions on all other wheels aswell.
2015-11-30 17:17:42  ★ after doing so he would collect all the tools and places it back into the toolbox and      ((Richard Hawkins))
2015-11-30 17:18:26  ★ crouches down to it as he then closes the toolbox .      ((Richard Hawkins))
2015-11-30 17:18:48  ★ Richard Hawkins would then hrab ahold of it with his right hand as he then takes it back to the toolbox.