# This file contains common pin mappings for RAMPS (v1.3 and later)
# boards. RAMPS boards typically use a firmware compiled for the AVR
# atmega2560 (though other AVR chips are also possible).

# See the example.cfg file for a description of available parameters.

[stepper_x]
step_pin: ar54
dir_pin: !ar55
enable_pin: !ar38
step_distance: .0025
endstop_pin: ^!ar3
#endstop_pin: ^!ar2
position_endstop: 0
position_max: 200
homing_speed: 10

[stepper_y]
step_pin: ar60
dir_pin: !ar61
enable_pin: !ar56
step_distance: .0025
endstop_pin: ^!ar14
#endstop_pin: ^!ar15
position_endstop: 0
position_max: 200
homing_speed: 10

[stepper_z]
step_pin: ar46
dir_pin: !ar48
enable_pin: !ar62
step_distance: 0.0003125
endstop_pin: ^!ar18
#endstop_pin: ^!ar19
position_endstop: 0.5
position_max: 200

[extruder]
step_pin: ar26
dir_pin: ar28
enable_pin: !ar24
step_distance: .0033
nozzle_diameter: 0.4
filament_diameter: 1.750
heater_pin: ar10
#sensor_type: EPCOS 100K B57560G104F
#sensor_type: ATC Semitec 104GT-2
sensor_type: ATC Semitec 104GT-2
sensor_pin: analog13
control: pid
pid_Kp: 22.2
pid_Ki: 1.08
pid_Kd: 114
min_temp: 0
max_temp: 280

#[extruder1]
#step_pin: ar36
#dir_pin: ar34
#enable_pin: !ar30
#heater_pin: ar9
#sensor_pin: analog15

#...
#sensor_type: ATC Semitec 104GT-2
#control: pid
#pid_Kp: 22.2
#pid_Ki: 1.08
#pid_Kd: 114
#min_temp: 0
#max_temp: 280
#step_distance: .0033
#nozzle_diameter: 0.4
#filament_diameter: 1.750

[heater_bed]
heater_pin: ar8
sensor_type: ATC Semitec 104GT-2
sensor_pin: analog14
control: watermark
min_temp: 0
max_temp: 130

[fan]
pin: ar9

[mcu]
serial: /dev/ttyUSB0
pin_map: arduino

[printer]
kinematics: corexy
#   This option must be "corexy" for corexy printers.
max_velocity: 300
max_accel: 3000
max_z_velocity: 25
max_z_accel: 30